Speciation of iron and manganese in dam water particles using electron spectroscopy for chemical analysis (ESCA)

The speciation of iron and manganese compounds retained by membrane filtration of dam water samples was studied by use of electron spectroscopy for chemical analysis (ESCA). Samples were taken at various depths and times of year from North Pine Dam near Brisbane, Australia. Both surface and bulk properties of samples representative of the water column profile were investigated. ESCA results showed that iron(III) compounds were found to predominate in the whole water column in any season of the year while the significance of iron(II) species varied in the hypolimnion (the bottom layer). In summer, although various ratios of manganese(II), manganese(III) and manganese(IV) compounds were found to occur down the water column, manganese(IV) compounds were predominant in the epilimnion (the top layer), while both manganese(II) and (IV) compounds predominated in the metalimnion (the middle layer) and the hypolimnion. The majority of Mn(IV) compounds were found throughout the water column after heavy rain and winter season. The ratios of atomic concentrations of iron and manganese as determined by atomic absorption spectrophotometry and ESCA are also discussed.     

A general method for preparation of metal carbenes via solution- and polymer-based approaches

A new general, synthetically simple, and safe method for the preparation of metal carbene complexes, which is based on diphenyl sulfonium salts as carbenoid precursors, has been developed, and its scope and applications were studied. In general, deprotonation of a sulfonium salt with a base results in a sulfur ylide, which, in turn, reacts with an appropriate metal precursor to give the corresponding metal carbene complex. Thus, starting from benzyldiphenylsulfonium salt, the complexes (PCX)Rh=CHPh (X = P, N) were prepared in quantitative yield. Syntheses of Grubbs' catalyst, (PCy(3))(2)Cl(2)Ru=CHPh, and of Werner's carbene, [Os(=CHPh)HCl(CO)(P(i)Pr(3))(2)], were achieved by this method. Novel trans-bisphosphine Rh and Ir carbenes, ((i)Pr(3)P)(2)(Cl)M=CHPh, which could not be prepared by other known methods, were synthesized by the sulfur ylide approach. The method is not limited to metal benzylidenes, as demonstrated by the preparation of the Ru vinyl-alkylidene, (PCy(3))(2)Cl(2)Ru=CH-CH=CH(2), methoxycarbonyl-alkylidene, (PCy(3))(2)Cl(2)Ru=CH(CO(2)Me), and alkylidene (PCy(3))(2)Cl(2)Ru=CH(CH(3)), (PCy(3))(2)Cl(2)Ru=CH(2) compounds. The problem of recycling of starting materials as well as the issue of facile purification of the product metal carbene complex were addressed by the synthesis of a polymer-supported diarylsulfide, the carrier of the carbenoid unit in the process. Based on the sulfur ylide route, a methodology for the synthesis of metallocarbenes anchored to a polymer via the carbene ligand, using a commercial Merrifield resin, was developed.     

Structures and Bioactivities of Steroidal Saponins Isolated from the Genera Dracaena and Sansevieria

The species Dracaena and Sansevieria, that are well-known for different uses in traditional medicines and as indoor ornamental plants with air purifying property, are rich sources of bioactive secondary metabolites. In fact, a wide variety of phytochemical constituents have been isolated so far from about seventeen species. This paper has reviewed the literature of about 180 steroidal saponins, isolated from Dracaena and Sansevieria species, as a basis for further studies. Saponins are among the most characteristic metabolites isolated from the two genera. They show a great variety in structural motifs and a wide range of biological activities, including anti-inflammatory, anti-microbial, anti-proliferative effects and, in most case, remarkable cytotoxic properties.     

Characterization of Commercial Amylases for the Removal of Filter Cake on Petroleum Wells

Drilling fluid has many functions, such as carry cuttings from the hole permitting their separation at the surface, cool and clean the bit, reduce friction between the drill pipe and wellbore, maintain the stability of the wellbore, and prevent the inflow of fluids from the wellbore and form a thin, low-permeable filter cake. Filter cake removal is an important step concerning both production and injection in wells, mainly concerning horizontal completion. The drilling fluids are typically comprised of starch, the most important component of the filter cake. A common approach to remove this filter cake is the use of acid solutions. However, these are non-specific reactants. A possible alternative is the use of enzymatic preparations, like amylases, that are able to hydrolyze starch. Wells usually operate in drastic conditions for enzymatic preparations, such as high temperature, high salt concentration, and high pressure. Thus, the main objective of this work was to characterize four enzymatic preparations for filter cake removal under open hole conditions. The results showed that high salt concentrations (204,000 ppm NaCl) in completion fluid decreased amylolytic activity. All enzymatic preparations were able to catalyze starch hydrolysis at all temperatures tested (30, 65, 80, and 95 °C). An increase of amylolytic activity was observed with the increase of pressure (100, 500 and 1,000 psi) for one commercial amylase.     

Multineutron photonuclear reactions on the <Superscript>197</Superscript>Au isotope

An experiment on irradiation of the ¹⁹⁷Au isotope by a beam of bremsstrahlung γ-rays of maximum energy E _γ ^m = 70 MeV has been carried out at the RTM-70 race-track microtron of the INP MSU. Residual activity spectra of the irradiated sample were measured. Multiparticle photonuclear reactions on the ¹⁹⁷Au nucleus are observed. Photonuclear reactions with emission of as many as six neutrons are observed for the first time.     

Rapid, sensitive DNT vapor detection with UV-assisted photo-chemically synthesized gold nanoparticle SERS substrates

We report rapid, sensitive, and direct detection of 2,4-dinitrotoluene (DNT) vapor using tailored gold nanoparticles (Au-NPs) as the SERS substrate. The Au-NPs were synthesized using the UV-assisted photo-chemical reduction method and subsequently formed a monolayer on the glass slide through polymer-mediated self-assembly. The SERS substrate such prepared has high SERS enhancement, high affinity towards DNT vapor, and rapid response to the DNT adsorption/desorption. We systematically studied the effect of the Au-NP size and surface density on the SERS performance such as enhancement factor and response time. With the optimized SERS substrate, an enhancement factor over 5.6 × 10(6) was achieved. Furthermore, real-time detection of DNT vapor with only 0.35 second data acquisition time was demonstrated using a 12 mW laser. Compared to previously reported results, we achieved two orders of magnitude reduction in detection time and more than one order of magnitude reduction in excitation laser power. The detection limit is estimated to be 0.4 attogram, which corresponds to a sub-ppb DNT concentration in air. This work will lead to the development of ultra-fast and ultra-sensitive SERS devices for explosive identification and monitoring.     

Alternative chromatographic processes for no-carrier added 177Lu radioisotope separation

HPLC technique combined with the simple conventional column solid phase extraction (SPE) chromatography using di-(2-ethylhexyl)orthophosphoric acid (HDEHP) impregnated OASIS-HLB sorbent based SPE resins (OASIS-HDEHP) was developed for the separation of no-carrier added (n.c.a) ¹⁷⁷Lu from the bulk quantity of ytterbium target. This combination strategy was based on combining the advantages of the better resolution of HPLC separation of n.c.a ¹⁷⁷Lu from the few milligram level Yb target with the high capacity of the OASISHDEHP column for the separation of ¹⁷⁷Lu from the bulk Yb target. The production batches of several hundred mCi activity of n.c.a ¹⁷⁷Lu radioisotope separated from 50 mg Yb target activated in a nuclear reactor of medium neutron flux (Φ=5·10¹³ n·cm^?2·s^?1) were successfully performed using this combined separation technique. With the target irradiation in a reactor of higher thermal neutron flux or with the parallel run of several separation units, several Ci-s of n.c.a ¹⁷⁷Lu can be profitably produced on a commercial production basis.     

Hybrid Plasma – Prospects for Application in Medicine and Biology

Russian Physics Journal - Different schemes and designs of generators of low-temperature hybrid plasma produced by simultaneous ionization of plasma-generating medium by an electron beam with...