Fibre raman amplifier properties for applications to long-distance optical communications

This paper reviews recent theoretical and experimental studies on optical amplification by stimulated Raman scattering (Raman amplification) in single-mode optical fibres, and discusses its possible applications to long-distance optical communications. The fibre Raman amplifier can be used as an in-line optical amplifier in both repeaterless and non-regenerative all-optical repeater configurations. In the former application, signal transmission of over 400 km has been predicted theoretically, although high-power pump sources are considered to be required. In the latter configuration, in which optical fibre losses are compensated for by Raman gains, it has been shown that extremely long-distance transmission over more than 1000 km is feasible in terms of signal-to-noise ratio, where the distance achievable is mainly limited by the accumulation of Raman noise. Recent experimental demonstrations including bit-error rate measurements on the Raman amplified signal, and laser-diode pumped amplification, etc., are also reviewed. The results confirm the effectiveness of fibre Raman amplifiers in future long-haul systems.     

Estimation of growth rate in unidirectionally solidified multicrystalline silicon by the growth-induced striation method

Multicrystalline silicon was grown by unidirectional solidification method using the accelerated crucible rotation technique. The application of the accelerated crucible rotation technique in unidirectional solidification method induced growth striations across the axial direction of the grown crystal. This striation pattern was observed from carbon concentration distribution, obtained by using Fourier transform infrared spectroscopy. The generated striation pattern was found to be weak and discontinuous. Some striations were absent, probably due to back melting, caused during each crucible rotation. From the growth striations and applied time period in crucible rotation, the growth rate was estimated by using Fourier transformation analysis.     

Measuring Light Field of Light Source with High Directional Resolution Using Mirrored Ball and Pinhole Camera

This paper presents a method of measuring a light field of a light source with high directional resolution using a mirrored ball and a pinhole camera. The light field describes a spatial and directional distribution of radiances from the light source. The directional distribution is expanded by a reflection on the mirrored ball, and the radiances are measured by a charge-coupled device (CCD) camera with a pinhole lens. The light source is laterally moved by a robot arm to measure the directionally expanded light field, and each pixel on a CCD can obtain the radiances from the light source through the pinhole lens with high directional resolution. The light field is estimated from the pixel value and the position of each pixel using a ray tracing technique. The light field of a krypton lamp was experimentally measured by the proposed method, and the accuracy of the measurement was evaluated against the irradiances measured by a spectro-radiometer at sample points.     

Fabrication and transport properties of multiwall carbon nanotube crossroads

A multiwall carbon nanotube crossroads has been fabricated by a manipulation technique using a glass microcapillary, and the low temperature transport properties investigated. The two-terminal conductance of an individual tube shows Tomonaga–Luttinger liquid behavior G∝T^α at high temperature and dI/dV ∝V ^α at low temperature. However, no evidence of such a power-law behavior is obtained in the four-terminal conductance at the junction, where the conductance shows an almost metallic behavior ‘corrected’ by weak localization. Weak localization would essentially appear in electron states at the junctions of MWNTs.     

Local structure analysis of smoky and colorless topaz using single crystal Al NMR

The angular dependence of the ²⁷Al NMR spectrum was measured for single crystals of smoky and colorless topaz, Al₂SiO₄(F,OH)₂. Smoky topaz was obtained by irradiating high energy neutrons to colorless topaz. The quadrupole coupling constant e²Qq/h and the asymmetry parameter η were obtained from the analysis of the angular dependences of quadrupole splitting of the ²⁷Al NMR spectrum. The local structures around the aluminum atoms in smoky and colorless topaz were discussed from the magnitude and the direction of the electric field gradient. The directions of principal axes of the EFG tensor of ²⁷Al were close to the directions of Al-O and Al-F bonds. The difference in the bond lengths between Al(1)-F(1) and Al(1)-F(2) was found to affect the x and y components of the EFG tensor.     

Photo-Absorption and photochemical decomposition of copper and alkaline-earth ß-diketonates as source gases of high-Tc superconducting films

For low-temperature deposition of oxide films relating to Bi-Sr-Ca-Cu-O superconductors, photo-absorption and -decomposition properties were examined with respect to copper and alkaline-earth ß-diketonates. It was confirmed that all ß-diketonates examined were promising as source materials for photochemical vapour deposition (photo-CVD) using a low-pressure mercury lamp, in view of their large light absorption coefficients at wavelength 254 nm. The light irradiation was effective for the formation of highly crystalline oxide films at temperatures below 600 °C. By combining two sources, Ca₂CuO₃ and SrCuO₂ films were prepared. Photo-CVD of c-axis oriented Bi₂Sr₂CuO_x film was achieved by the irradiation of ternary sources of Bi(C₆H₅)₃ and strontium and copper ß-diketonates at 500 °C.     

Altered protein synthesis in rat kidney cells exposed to semiconductor materials

It is thought that the extensive industrial use of arsenic, gallium and indium, which have applications as the materials for III–V semiconductors, will increase human exposure to these compounds in the near future. We have undertaken the development of new biological indicators for assessing exposure to these elements. Element-specific alterations in protein synthesis patterns were expected to occur following exposure to arsenic compounds. We examined alterations in protein synthesis in primary cultures of rat kidney proximal tubule epithelial cells by sodium arsenite, gallium chloride and indium chloride, utilizing two-dimensional gel electrophoresis. After incubation with the chemicals for 20 h, newly synthesized proteins were labeled with [³⁵S]methionine. A protein with a molecular weight (M_r) of 30 000 was markedly induced on exposure to 10 μM arsenite or 300 μM gallium chloride, and synthesis of proteins with M_r values of 85 000, 71 000, 65 000, 51 000, 38 000 and 28 000 were also increased by exposure to arsenite and gallium chloride. No significant changes were observed upon exposure to indium. Some of these increased proteins could be heat-shock proteins.     

High spin chemistry underlying organic molecular magnetism: Topological symmetry rule as the first principle of spin alignment in organic open-shell systems of π-conjugation and their ions

This review paper deals with an overview of molecule-based magnetism as a rapidly developing interdisciplinary field, topological symmetry rule as the first principle of spin alignment in organic open-shell systems in the ground state, the proposal of organic through-bond 1D and 2D ferro- and superparamagnets and the detection of the first organic high-spin molecule, m-phenylenebis(phenylmethylene) in the quintet ground state (S = 2), followed by extended organic high-spin systems with π-conjugation such as aromatic hydrocarbons having S = 3, 4, 5. The paper also describes a theoretical approach to the understanding of electronic spin structures of organic high-spin molecules by invoking both Heisenberg and Hubbard model Hamiltonians, weakly interacting intramolecular high-spin systems from both experimental and theoretical sides, the spin density distribution of the first organic high-spin molecule in terms of electron- nuclear multiple resonance spectroscopy and the detection and characterization of ionic high-spin hydrocarbons, emphasizing the establishment of high spin chemistry underlying organic molecular magnetism.