Voltammetric Determination of Isoniazid Drug in Various Matrix by Using CuOx Decorated MW‐CNT Modified Glassy Carbon Electrode

Copper oxide decorated multi‐walled carbon nanotube (MWCNT) modified glassy carbon electrode (GCE) was prepared for determination of isoniazid (INZ) in various matrices. The electrochemical behavior of INZ was tested with the aid of Cyclic Voltammetry (CV) and quantitative experiments were performed by using Linear Sweep Voltammetry (LSV). Morphological and structural characterization of the modified electrode was performed by utilizing Scanning Electron Microscopy (SEM), X‐Ray Photoelectron Spectroscopy (XPS) while electrochemical characterization was performed by using CV and Electrochemical Impedance spectroscopy (EIS). The proposed sensor exhibited well defined anodic peak at 0.30 V for INZ at pH 6.0 medium. Under the optimum conditions, a linear relation between INZ concentration and peak current was observed in the range of 2.0×10^?7 to 5.0×10^?5 M. Limit of detection was calculated as 1.0×10^?8 M and repeatability and accuracy was found as 5.60 % and 91.0 % for 5.0 10^?7 M INZ by using 3 successive measurement, respectively. Then, the analytic performance of the electrode developed was tested by analyzing commercial tablets, artificial human serum and urine samples. The results indicated that satisfactory recoveries was observed for all issue.     

Efficient synthesis of ferrocenylenones by Friedel-Crafts acylation with EtAlCl2-Me3Al

Efficient synthesis of ferrocenylenones using a Friedel-Crafts acylation reaction is described. Acryloyl, methacryloyl, crotonoyl, cinnamoyl, and β-methylcrotonoyl chlorides react with ferrocene in the presence of a Lewis acid (EtAlCl₂ or EtAlCl₂-Me₃Al) to give the corresponding ferrocenylenones (acryloyl, methacryloyl, crotonoyl, cinnamoyl, and methylcrotonoylferrocenes) in good isolated yields. Besides ferrocenylenones, chloroactylferrocene is also synthesised by this method.     

Bioengineering functional copolymers. III. Synthesis of biocompatible poly[(N‐isopropylacrylamide‐co‐maleic anhydride)‐g‐poly(ethylene oxide)]/poly(ethylene imine) macrocomplexes and their thermostabilization effect on the activity of the enzyme penicillin G acylase

Stimuli‐responsive poly[(N‐isopropylacrylamide‐co‐maleic anhydride)‐g‐poly(ethylene oxide)]/poly(ethylene imine) macrobranched macrocomplexes were synthesized by (1) the radical copolymerization of N‐isopropylacrylamide and maleic anhydride with α,α′‐azobisisobutyronitrile as an initiator in 1,4‐dioxane at 65 °C under a nitrogen atmosphere, (2) the polyesterification (grafting) of prepared poly(N‐isopropylacrylamide‐co‐maleic anhydride) containing less than 20 mol % anhydride units with α‐hydroxy‐ω‐methoxy‐poly(ethylene oxide)s having different number‐average molecular weights (M_n = 4000, 10,000, or 20,000), and (3) the incorporation of macrobranched copolymers with poly(ethylene imine) (M_n = 60,000). The composition and structure of the synthesized copolymer systems were determined by Fourier transform infrared, ¹H and ¹³C NMR spectroscopy, and chemical and elemental analyses. The important properties of the copolymer systems (e.g., the viscosity, thermal and pH sensitivities, and lower critical solution temperature behavior) changed with increases in the molecular weight, composition, and length of the macrobranched hydrophobic domains. These copolymers with reactive anhydride and carboxylic groups were used for the stabilization of penicillin G acylase (PGA). The conjugation of the enzyme with the copolymers significantly increased the thermal stability of PGA (three times at 45 °C and two times at 65 °C). © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 1580–1593, 2003     

Direct determination of sulfite in food samples by a biosensor based on plant tissue homogenate

In the work described here, a biosensor was developed for the determination of sulfite in food. Malva vulgaris tissue homogenate containing sulfite oxidase enzyme was used as the biological material. M. vulgaris tissue homogenate was crosslinked with gelatin using glutaraldehyde and fixed on a pretreated Teflon membrane. Sulfite was enzymatically converted to sulfate in the presence of the dissolved oxygen, which was monitored amperometrically. Sulfite determination was carried out by standard curves, which were obtained by the measurement of consumed oxygen level related to sulfite concentration. Several operational parameters had been investigated: the amounts of plant tissue homogenate and gelatin, percentage of glutaraldehyde, optimum pH and temperature. Also, some characterization studies were done. There was linearity in the range between 0.2 and 1.8 mM at 35 °C and pH 7.5. The results of real sample analysis obtained with the biosensor agreed well with the enzymatic reference method using spectrophotometric detection.     

Enantioselective reduction of ketones with borane catalyzed by cyclic β- amino alcohols prepared from proline

New catalysts have been prepared from (S)- and (R)- proline and the asymmetric borane reduction of prochiral ketones using these catalysts has been studied. The secondary alcohols were obtained in 76–95% yield with 57– 96% enantiomeric excesses.     

Detection of toluene diisocyanate with a coated quartz piezoelectric crystal: Part 3. Practical coatings for a humidity-corrected detector

Dithizone and tri-n-octylphosphine oxide (TOPO) were tested as coatings for quartz piezoelectric crystals to be used in a detector for touene diisocyanate (TDI). Cobalt(II) chloride and polyethylene glycol (PEG) with molecular weights of 400 and 1540 were tested for suitability as coatings for detecting humidity variations so that correction for humidity could be obtained from a two-crystal system. Sensitivities for TDI of 12 and 75 Hz ppm^?1 were found with dithizone and TOPO, respectively, between 0 and 1 ppm TDI. Cobalt chloride-coated crystals showed a sensitivity for water of 0.053 Hz ppm^?1 at 8000 ppm water and about 40 Hz ppm^?1 for TDI at the 2 ppm level. PEG-400 and PEG-1540 provided sensitivities to water of 0.038 and 0.051 Hz ppm^?1 respectively, and the response was linear over the range 9000—13 000 ppm water. All coatings showed irreversible behaviour towards TDI.     

Selective pre-concentration of selenite from aqueous samples using mercapto-silica

Silica gel modified with 3-mercaptopropyl-trimethoxysilane was used for the selective separation and pre-concentration of selenite (Se(IV)) from aqueous solutions containing Se(IV) and selenate (Se(VI)). Over a wide range of acidity, from 2 mol l⁻¹ HCl to pH 9.00, Se(IV) was taken up by the mercaptopropyl-silica with nearly 100% efficiency; Se(VI) however was unretained. Se(IV) content was determined by hydride generation atomic absorption spectrometry (HGAAS), following batch release of the selenium from the pre-concentration medium by acidic periodate. The overall pre-concentration efficiency, including both take-up and elution, in the range of 89-106%. The method was applied to spiked seawater samples containing as low as 800 ng l⁻¹ Se in selenite form. This solid-phase extraction system offers several major advantages over conventional solvent extraction procedures. It firstly exhibits high selectivity for Se(IV) over Se(VI). Using the solid-phase media, pre-concentration of Se(IV) in dilute water samples can be carried out in the field, stabilizing the selenite-selenium in a convenient form for transport and storage. In addition, selenium stored on silica is derived solely from Se(IV) overcoming problems of selenium redox speciation changes and loss during storage.     

Glycan–protein cross-linking mass spectrometry reveals sialic acid-mediated protein networks on cell surfaces

A cross-linking method is developed to elucidate glycan-mediated interactions between membrane proteins through sialic acids. The method provides information on previously unknown extensive glycomic interactions on cell membranes. The vast majority of membrane proteins are glycosylated with complicated glycan structures attached to the polypeptide backbone. Glycan–protein interactions are fundamental elements in many cellular events. Although significant advances have been made to identify protein–protein interactions in living cells, only modest advances have been made on glycan–protein interactions. Mechanistic elucidation of glycan–protein interactions has thus far remained elusive. Therefore, we developed a cross-linking mass spectrometry (XL-MS) workflow to directly identify glycan–protein interactions on the cell membrane using liquid chromatography-mass spectrometry (LC-MS). This method involved incorporating azido groups on cell surface glycans through biosynthetic pathways, followed by treatment of cell cultures with a synthesized reagent, N-hydroxysuccinimide (NHS)–cyclooctyne, which allowed the cross-linking of the sialic acid azides on glycans with primary amines on polypeptide backbones. The coupled peptide–glycan–peptide pairs after cross-linking were identified using the latest techniques in glycoproteomic and glycomic analyses and bioinformatics software. With this approach, information on the site of glycosylation, the glycoform, the source protein, and the target protein of the cross-linked pair were obtained. Glycoprotein–protein interactions involving unique glycoforms on the PNT2 cell surface were identified using the optimized and validated method. We built the GPX network of the PNT2 cell line and further investigated the biological roles of different glycan structures within protein complexes. Furthermore, we were able to build glycoprotein–protein complex models for previously unexplored interactions. The method will advance our future understanding of the roles of glycans in protein complexes on the cell surface.

The cell surface glycocalyx is highly interactive defined by extensive covalent and non-covalent interactions. A method for cross-linking and characterizing glycan–peptide interactions in situ is developed.     

Chemistry and the Origin of Life

The natural genesis of life on Earth is a hypothesis of evolutionary science; it is the task of synthetic organic chemistry to test this hypothesis experimentally. The aim of an experimental aetiological chemistry is not primarily to delineate the pathways along which our (‘natural’) life on Earth could have originated, but to provide decisive experimental evidence, through the realization of model systems (‘artificial chemical life’), that life can arise as a result of the organization of organic matter.