Vacuum‐driven fluid manipulation by a piezoelectric diaphragm micropump for microfluidic droplet generation with a rapid system response time

Recently, we developed a convenient microfluidic droplet generation device based on vacuum‐driven fluid manipulation with a piezoelectric diaphragm micropump. In the present study built on our previous work, we investigate the influence of settings applied to the piezoelectric pump, such as peak‐to‐peak drive voltage (V_p‐p) and wave frequency, on droplet generation characteristics. Stepwise adjustments to the drive voltage in ±10‐V_p‐p increments over the range of 200?250 V_p‐p during droplet creation revealed that the droplet generation rate could be reproducibly controlled at a specific drive voltage. The droplet generation rate switched within <0.5 s after the input of a new voltage. Although the droplet generation rate depended on the drive voltage, this setting had almost no influence on droplet size. The frequency over the selected range (50?60 Hz) did not markedly influence the droplet generation rate or droplet size. We show that the current fluid manipulation system can be conveniently used for both droplet generation and for rapid droplet reading, which is required in many microfluidic‐based applications.     

双奇核188Au的准粒子带结构研究

利用在束γ谱学实验技术, 通过¹⁷³Yb(¹⁹F,4nγ)反应 布居了¹⁸⁸Au的高自旋态, 并对其准粒子带结构进行了研究. 基于实验测量结果, 对原有的双奇核¹⁸⁸Au能级纲图做了较大的修改. 通过系统性比较, 对15⁺以上的能级结构进行了讨论.     

Magneto-Optical Measurement of Organic Conductor Using Rotational Cavity System

We have developed a new magneto-optical measurement system using a rotational cavity system equipped with a millimeter vector network analyzer and a 14 T solenoid type super conducting magnet. The measurement can be performed in the transmission configuration down to 1.6 K. The results of the precise angular dependence measurement of quasi-one-dimensional organic conductor (DMET)₂I₃ using the new system are shown, and its Fermi surface will be discussed in connection with the previous reports.     

Rotational bands in 181Ta

High-spin states in ¹⁸¹Ta have been studied via the ¹⁷⁶Yb(¹¹B,α2n) reaction at 52 MeV using the PEX array and at 57 MeV using the NORDBALL array, with α-particle detection. The previously known, K^π=(7/2)⁺ ground state band and K^π=(9/2)⁻ band have been extended to spins (29/2)⁺ and (31/2)⁻, respectively. Two new one-quasiparticle bands, the K^π=(5/2)⁺ band built on the known (5/2)⁺ isomer and a K^π=((1/2)⁻) band have been observed. Two other rotational bands with three-quasiparticle structure, K^π=(15/2)⁻ and ((19/2)⁺ with π(7/2)[404]ν²(1/2)[510](9/2)[624] and π(9/2)[514]ν²(1/2)[510](9/2)[624] configurations, respectively, have been newly observed. The half-life of the K^π=((19/2)⁺) bandhead which decays to the head of the (15/2)⁻ band has been measured to be 140(36) ns. However, transitions from the ((19/2)⁺) state to the (15/2)⁻ band have not been observed. Received: 26 August 1998     

Novel flow injection-fluorometric method for the determination of trace silicate and its application to ultrapurified water analysis

A highly sensitive fluorescence quenching method for the determination of silicate based on the formation of an ion associate between molybdosilicate and Rhodamine B (RB) in nitric acid medium was developed. A flow injection system coupled with a fluorescence detector was used for the measurement of fluorescence intensity at 560 and 580 nm as excitation and emission wavelengths, respectively. The calibration graph for Si showed a linear range of 0.1–5 ng cm⁻³ with correlation coefficient of 0.9999, and the detection limit of 0.06 ng cm⁻³. The proposed method was successfully applied to the determination of silicate in ultrapurified water with satisfactory results.     

Oxidation of alcohols with oxoperoxobis(N-phenylbenzohydroxamato)molybdenum(VI)

The title complex oxidizes primary and secondary alcohols to the corresponding carbonyl compounds. Stereoselective epoxidation of allylic alcohols is also described.     

Mass spectrometric analysis of low molecular mass polyesters by laser desorption/ionization on porous silicon

A low molecular mass polyester was analyzed by desorption/ionization on porous silicon (DIOS) mass spectrometry. The results were compared with those of matrix-assisted laser desorption ionization (MALDI) mass spectrometry using matrixes of alpha-cyano-4-hydroxycinnamic acid (CHCA) and 10,15,20-tetrakis(pentafluorophenyl)porphyrin (F20TPP). The CHCA matrix was not suitable for characterization of low molecular mass components of the polyester because the matrix-related ions interfered with the component ions. On the other hand, the F20TPP matrix showed no interference because no matrix-related ions appeared below m/z 822. However, the solvent selection for determining optimal conditions of sample preparation was limited, because F20TPP does not dissolve readily in any of the available organic solvents. In the DIOS spectra, the polymer ions were observed at high sensitivity without a contaminating ion. No matrix is needed for DIOS spectra of low molecular mass polyesters, facilitating sample preparation and selectivity of a precursor ion in post-source decay measurements.     

Reaction of indium ate complexes with allylic compounds. Controlling SN2/SN2′ selectivity by solvents

Vinyl and methylindium ate complexes (indates) were prepared and both the tendency of immigration and regioselectivity toward cinnamyl bromide were investigated. The vinyl group was more preferably transferred than the Me group, giving a regioisomeric mixture of S_N2 and S_N2′ products. The ratio of S_N2/S_N2′ selectivity can be controlled by solvents; in the presence of polar solvents, such as N-butylpyrrolidone (NBP) and THF, the S_N2′ product was mainly obtained, whereas the S_N2 product was selectively prepared in solutions containing hexane. The vinylindium compound, generated by the reaction of allylic-type diindium reagents with imine, was also converted to the corresponding vinyl indate, which was allowed to react with allyl chloride to give a three-component coupling product.