Asymptotic Behavior of Least Energy Solutions for a Fractional Laplacian Eigenvalue Problem on ℝN

Acta Mathematica Sinica, English Series - We are interested in the existence and asymptotic behavior for the least energy solutions of the following fractional eigenvalue problem $$\left({\rm{P}}...     

浮升力和流动加速对超临界CO2管内流动传热影响

基于单相流体的概念,超临界流体的异常传热行为已经被研究很多年了,但是关于其流动传热机理仍没有统一的认识.本文通过理论分析和实验研究了超临界二氧化碳在竖直管内向上流动过程中,浮升力和流动加速效应对其流动结构和传热过程的影响.结果表明,没有确凿的实验证据表明超临界流体的异常传热行为是浮升力和流动加速直接导致的,存在的估计浮升力和流动加速效应准则均是在常物性流体的基础上,做了大量假设得出的,不同的研究者采用浮升力和流动加速准则分析超临界流体的传热恶化得出的结论不一致.最后,基于拟沸腾理论分析超临界流体的传热恶化过程,提出超临界沸腾数区分了超临界流体正常传热与恶化传热的转换边界,为超临界流体流动传热研究提供新思路,超临界沸腾数对建立用于不同技术的超临界流体动力循环的最佳运行条件具有重要意义.     

场发射平板显示高低压电平转换电路

提出适用于场发射高压驱动的高低压电平转换电路设计及性能分析。通过模拟,此电路可以在100V的驱动工作电压以及10mA的驱动电流条件下安全工作,最高工作频率可达20MH_z。在50pF输出负载下上升时间和下降时间分别为14,25ns。同时分析了高压CMOS器件与0.8μm标准CMOS工艺兼容过程中的厚栅氧化对于低压器件及高压N管的阈值特性影响。     

若干图类的邻强边染色

研究了若干图类的邻强边染色 .利用在图中添加辅助点和边的方法 ,构造性的证明了对于完全图 Kn和路 Lm 的笛卡尔积图 Kn× Lm,有χ′as(Kn× Lm) =△ (Kn× Lm) +1 ,其中△ (Kn× Lm)和χ′as(Kn× Lm)分别表示图 Kn× Lm的最大度和邻强边色数 .同理验证了 n阶完全图 Kn的广义图 K(n,m)满足邻强边染色猜想 .     

A novel synthesis of 5-perfluorophenyl 4,5-dihydro-1H-pyrazoles in THF or water

5-Perfluorophenyl 4,5-dihydro-1H-pyrazoles were synthesized from 1,3-dipolar cycloaddition reaction of perfluorobenyl 2,4,6-triisopropylbenzenesulfonylhydrazone and α,β-unsaturated carbonyl compounds or acrylonitrile in THF or water. It was worthy to note that better results were obtained when water was employed as the solvent, which was considered as an effective, economic and environmentally friendly method to synthesize these pyrazole derivatives.     

γ-辐照对纯Y_2SiO_5和Eu~(3+)∶Y_2SiO_5晶体光谱性能的影响

研究了γ-辐照前后纯Y2SiO5和Eu3+掺杂的Y2SiO5晶体吸收光谱的变化,辐照后,未退火和氢气退火的纯Y2SiO5晶体在260~270 nm和320 nm波段产生了附加吸收峰,分别是由F心和O-心的吸收引起的;经过空气退火的纯YSO晶体中,由于消除了氧空位,因此辐照后没有出现色心吸收峰。在Eu3+∶Y2SiO5晶体中,不但有相同的F心和O-心吸收峰,而且还有Eu2+离子在300 nm和390 nm的吸收峰。随着辐照剂量的增加,色心附加吸收峰增强。空气退火能减少Eu3+∶Y2SiO5晶体中的色心,而氢气退火能增加色心。     

Yellow‐light‐emitting cyano‐substituted poly[(1,3‐phenylene vinylene)‐alt‐(1,4‐phenylene vinylene)] derivative: Its synthesis and optical properties

A soluble cyano‐substituted poly[(1,3‐phenylene vinylene)‐alt‐(1,4‐phenylene vinylene)] derivative ( 9 ) was synthesized and characterized. Comparison between 9 and its model compound ( 10 ) showed that the chromophore in 9 remained to be well defined as a result of a π‐conjugation interruption at adjacent m‐phenylene units. The attachment of a cyano substituent only at the β position of the vinylene allowed the maximum electronic impact of the cyano group on the optical properties of the poly(p‐phenylene vinylene) material. At a low temperature (?108 or ?198 °C), the vibronic structures of 9 and 10 were partially resolved. The absorption and emission spectra of a film of 9 were less temperature‐dependent than those of a film of 10 , indicating that the former had a lower tendency to aggregate. A light‐emitting diode (LED) based on 9 emitted yellow light (λ_max ≈ 578 nm) with an external quantum efficiency of 0.03%. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 3149–3158, 2003     

Synthesis and gas barrier characterization of poly(ethylene isophthalate)

Poly(ethylene isophthalate) (PEI) was synthesized for this research with essentially a condensation polymerization of isophthalic acid and ethylene glycol catalyzed by zinc acetate and antimony trioxide. Several samples were obtained, and their characteristics were observed and compared with poly(ethylene terephthalate) (PET). The synthesized PEI samples were chemically identified by ¹H NMR. Thermal analysis with differential scanning calorimetry (DSC) yielded results that indicate the samples were primarily amorphous, with a glass‐transition temperature of 55–60 °C. Molecular weights of these PEI samples were also obtained through intrinsic viscosity measurements (Mark–Houwink equation). Molecular weights varied with conditions of the polymerization, and the highest molecular weight achieved was 21,000 g/mol. Finally, the diffusion coefficient, solubility, and permeability of CO₂ gas in PEI were measured and found to be substantially lower than in PET, as anticipated from their isomeric chemical structures. This is because in PET the phenyl rings are substituted in the para (1,4) positions, which allows for their facile flipping, effectively permitting gases to pass through. However, the meta‐substituted phenyl rings in PEI do not permit such ring flipping, and thus PEI may be more suitable for barrier applications. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 4247–4254, 2004     

The uv-Decomposition on a Class of D.C. Functions and Optimality Conditions

In this paper,the UV-theory and P-differential calculus are employed to study second-order ex-pansion of a class of D.C.functions and minimization problems.Under certain conditions,some properties ofthe U-Lagrangian,the second-order expansion of this class of functions along some trajectories are formulated.Some first and second order optimality conditions for the class of D.C.optimization problems are given.