Highly strained InxGa(1−x)As−InyAl(1−y)As (x>0.8,y<0.3) layers for short wavelength QWIP and QCL structures grown by MBE

Highly strained quantum cascade laser (QCL) and quantum well infrared photodetector (QWIPs) structures based on In_xGa_(1−x)As−In_yAl_(1−y)As (x>0.8,y<0.3) layers have been grown by molecular beam epitaxy. Conditions of exact stoichiometric growth were used at a temperature of 420°C to produce structures that are suitable for both emission and detection in the 2–5 μm mid-infrared regime. High structural integrity, as assessed by double crystal X-ray diffraction, room temperature photoluminescence and electrical characteristics were observed. Strong room temperature intersubband absorption in highly tensile strained and strain-compensated In_0.84Ga_0.16As/AlAs/In_0.52Al_0.48As double barrier quantum wells grown on InP substrates is demonstrated. Γ–Γ intersubband transitions have been observed across a wide range of the mid-infrared spectrum (2–7 μm) in three structures of differing In_0.84Ga_0.16As well width (30, 45, and 80 Å). We demonstrate short-wavelength IR, intersubband operation in both detection and emission for application in QC and QWIP structures. By pushing the InGaAs–InAlAs system to its ultimate limit, we have obtained the highest band offsets that are theoretically possible in this system both for the Γ–Γ bands and the Γ–X bands, thereby opening up the way for both high power and high efficiency coupled with short-wavelength operation at room temperature. The versatility of this material system and technique in covering a wide range of the infrared spectrum is thus demonstrated.     

Determination of in-core power in low energy research reactors by measurement of16N and18F in the primary coolant

The measurement of¹⁶N and¹⁸F activity in the primary coolant of the JASON Argonaut reactor has been used to monitor in-core reactor power. The¹⁶N is produced by the¹⁶O(n, p)¹⁶N reaction and the 6.1 MeV photopeak was measured on-line using a BGO detector adjacent to the primary coolant circuit. These data provided a relative measure of power stability during steady state operation and a measure of linearity at different power levels. The¹⁸F is produced in the primary coolant by the¹⁸O(p, n)¹⁸F reaction and aliquots of primary coolant were sampled from the reactor dump tank for off-line radiochemical analysis. The¹⁸F was separated as trimethylfluorosilane and the activity was determined by measurement of the 0.511 MeV annihilation photopeak using a NaI(TI) detector. The measured¹⁸F activity was used to determine actual in-core reactor power using both ab-initio calculations and by comparison of results with a calibrated power reactor. The¹⁸F data also provided a method of nomalising the¹⁶N data for direct monitoring of in-core reactor power in JASON.     

An evaluation of a new neutron tube (Philips Type 18604) for total body in vivo activation analysis

A 14 MeV neutron generator system with a new sealed tube (Philips 18604) was evaluated for total body in vivo neutron activation analysis (TBIVNAA). The neutron output, angular distribution, rise time, reproducibility of short irradiations and leakage of tritium were investigated. The 18604 tube meets all the requirements of TBIVNAA within its normal operating specification.     

The spectrophotometric determination of arsenic in sea water,potable water and effluents

Procedures are described for the determination of arsenic in sea water, potable waters and effluents. The sample is treated with sodium borohydride added at a controlled rate. The arsine evolved is absorbed in a solution of iodine and the resultant arsenate ion is determined photometrically by a molybdenum blue method. The time required for a complete analysis is about 90 min, but of this only 15 min is operator time. For sea water the range, standard deviation, and detection limit are 1–4 μgl^-1, 1.4 % and O.14 μg l^-1, respectively; for potable waters they are 0–800 μg l^-1, about 1 % (at 20μg l^-1 level) and 0.5μg l^-1, respectively. Silver and copper cause serious interference at levels of 0.5 mgl^-1, and nickel, cadmium and bismuth interfere at concentrations of a few tens of mg l^-1; however, these elements can be removed either by preliminary extraction with a solution of dithizone in chloroform or by ion exchange. Arsenic present in organo-arsenic compounds is not directly determinable, but can be rendered reactive either by photolysis with ultraviolet radiation or by oxidation with permanganate or nitric—sulphuric acid mixture. Arsenic(V) can be determined separately from total inorganic arsenic after extracting arsenic(III) as its pyrrolidine dithiocarbamate into chloroform.     

New method for estimating survival curves based upon subpopulations

The overall Kaplan-Meier estimate of the survival curve underlying a study population does not individually account for the ages at which patients were first seen and thence followed up in the study. Since the number of patients in these age-specific subgroups varies quite arbitrarily for a given study, the overall Kaplan-Meier curve which assumes that all patients were seen from the beginning of the study usually either overestimates or underestimates the survival probability, depending on the varying sample sizes. In this paper, we therefore propose an estimate of the overall survival curve underlying a study population based on the individual age-specific Kaplan-Meier estimates and the probability distribution of the age at which patients were first seen in the study. In the particular case when there is no censoring, it is shown that the usual overall Kaplan-Meier survival curve which assumes that all patients irrespective of their age at entry into the study were followed from the beginning of the study is identical with the proposed estimate. This result does not seem to necessarily hold good in the presence of arbitrary censoring. Further, the estimate is unbiased and consistent, a property which the Kaplan-Meier estimate also enjoys. The efficiency of the proposed estimate relative to the Kaplan-Meier estimate is being investigated and will be reported along with results of its application in a separate communication.     

<Emphasis Type="Italic">parkin</Emphasis> counteracts symptoms in a <Emphasis Type="Italic">Drosophila</Emphasis> model of Parkinson's disease

Background

Parkinson's disease, a prevalent neurodegenerative disease, is characterized by the reduction of dopaminergic neurons resulting in the loss of motor control, resting tremor, the formation of neuronal inclusions and ultimately premature death. Two inherited forms of PD have been linked to mutations in the α-synuclein and parkin genes. The parkin protein functions as an ubiquitin ligase targeting specific proteins for degradation. Expression of human α-synuclein in Drosophila neurons recapitulates the loss of motor control, the development of neuronal inclusions, degeneration of dopaminergic neurons and the ommatidial array to provide an excellent genetic model of PD.

Results

To investigate the role of parkin, we have generated transgenic Drosophila that conditionally express parkin under the control of the yeast UAS enhancer. While expression of parkin has little consequence, co-expression of parkin with α-synuclein in the dopaminergic neurons suppresses the α-synuclein-induced premature loss of climbing ability. In addition directed expression of parkin in the eye counteracts the α-synuclein-induced degeneration of the ommatidial array. These results show that parkin suppresses the PD-like symptoms observed in the α-synuclein-dependent Drosophila model of PD.

Conclusion

The highly conserved parkin E3 ubiquitin ligase can suppress the damaging effects of human α-synuclein. These results are consistent with a role for parkin in targeting α-synuclein to the proteasome. If this relationship is conserved in humans, this suggests that up-regulation of parkin should suppress α-synucleinopathic PD. The development of therapies that regulate parkin activity may be crucial in the treatment of PD.

     

Polystyrene/decahydronaphthalene/propane phase equilibria and polymer conformation properties from intrinsic viscosities

The influence of dissolved propane (up to 31.2 wt %) on the phase equilibria of 5 wt % polystyrene (PS) dissolved in 66/34 wt % trans/cis‐decahydronaphthalene (DHN) was measured over the temperature range of 323–423 K. A suitable temperature, pressure, and propane composition operating space was defined to measure intrinsic viscosities of a single fluid phase. Intrinsic viscosities of PS in cosolvent mixtures of propane and trans/cis‐DHN were measured between 323 and 423 K and between 70 and 208 bar. The addition of propane to the isomeric mixture of DHN resulted in a decreased solvent quality for PS, causing a contraction of the PS coil. The most dramatic decrease in solvent quality with the addition of propane occurred at 323 K and 70 bar with approximately a 36% reduction in the viscometric radius with the addition of 45 mol % propane to DHN. At 423 K, the solvent quality was less sensitive to the addition of propane and only a 13% reduction in the viscometric radius was observed at 70 bar and 45 mol % propane in DHN. © 2011 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys, 2011     

Os(VIII)-catalysed oxidation of sulfides by sodium salt of N-chlorobenzenesulfonamide

Catalytic activity of Os(VIII) in the oxidation of some twenty organic sulfides with sodium salt of N-chlorobenzenesulfonamide (CAB) has been investigated in alkaline (pH8.7) t-butanol–water (1:1 v/v) medium. Significant retarding influence of [OH⁻] on the reactivity is exhibited. The catalysed reaction is strongly accelerated in the presence of Hg(II). Imperfections are observed in the linear Hammett relationship in the case of –NO₂ substituents.