Correction to: Practical framework for data-driven RANS modeling with data augmentation

Acta Mechanica Sinica -     

新型4-羟色胺类化合物的合成及生物活性

以4-羟基吲哚为原料,经吲哚环4位乙酰基化、3位亲电取代、酰胺化和还原加氢等反应合成目标化合物7.通过核磁共振氢谱及碳谱对化合物进行结构表征,并对目标化合物进行体外抗氧化生物活性测试.初步生物活性测试结果表明,化合物7a,7b,7c和7d对DPPH·均有很强的清除作用(清除率为85.25%~90.73%),7e,7f,7g,7h作用较差;目标化合物与Vc相比,对·OH的清除作用稍差,最高清除率25.66%(Vc的最高清除率为34.67),但各化合物整体水平相当;在清除O-2·能力上化合物7a,7d,7g,7h最大清除率(分别为19.34,35.35,27.93和31.74)均强于同等浓度的Vc(17.58).     

Recyclable and reusable Pd(OAc)2/PPh3/PEG‐2000 system for homocoupling reaction of arylboronic acids under air without base

A stable and efficient Pd(OAc)₂/PPh₃/PEG‐2000 catalytic system for homocoupling of arylboronic acids has been developed. In the presence of Pd(OAc)₂ and PPh₃, the homocoupling reaction of arylboronic acids was carried out smoothly in PEG‐2000 at 70 °C under air without base to afford a variety of symmetric biaryls in good to excellent yields. The isolation of the products was readily performed by extraction with diethyl ether, and the Pd(OAc)₂/PPh₃/PEG‐2000 system could be easily recycled and reused six times without significant loss of catalytic activity. Copyright © 2014 John Wiley & Sons, Ltd.     

煤直接液化油中混合酚的分离研究

利用分子筛择形特点，对煤直接液化油中的混合酚实施高效分离。本研究选取间甲酚和对甲酚作为分离煤直接液化油馏分段混合酚的模型化合物，采用化学液相沉积法对HZSM-5吸附剂的孔口结构进行改变，分析分子筛硅铝比及颗粒粒径对模型化合物间甲酚和对甲酚吸附分离性能的影响，以获得高性能固相吸附剂，并将其应用于180-190℃馏分段混合酚分离。结果表明，当分子筛硅铝比为25、粒径为3-5 μm时，分子筛的孔口结构调节效果最优；当正硅酸乙酯的最小用量为0.2 mL/g时，固相吸附剂的吸附量为0.03 g/g，对甲酚选择性高于95%。由于外表面沉积物对吸附剂的孔口结构变化，导致对甲酚选择性的提高。进一步采用HZSM-5（1）吸附剂对真实煤直接液化油混合酚的分离中发现，苯酚和对甲酚的选择性均达到100%。     

Investigations in the recrystallization of evolved gases from pyrolysis process of melamine

Journal of Thermal Analysis and Calorimetry - A complete analysis of the thermal process about melamine was presented, in which different methods were applied to determine the characteristic of the...     

喷雾干燥-固相煅烧法制备球形钛酸狸负极材料的研究

通过喷雾干燥-固相煅烧法制备了球形钛酸钾.不同于传统喷雾干燥工艺采用固态钛源进行制备,本文采用的前驱体是钾盐,分散剂和钛酸四丁酯制备出的硝酸氧钛的混合溶液.由于制备方法中前驱体为原子级均匀分布,化学计量比可精确控制,制备出的材料颗粒细小,粒径、成分分布均匀,电化学性能优异.同时研究了不同钾钛摩尔比以及煅烧温度对球形钛酸钾的形貌和成分的影响,并研究了其作为钾离子电池电极材料的电化学性能.结果表明,钾钛摩尔比为0.816,煅烧温度为 800 ℃时钛酸钾的电化学性能最好,首圈容量 185.1 mAh/g,30 圈后容量为173.9 mAh/g,循环100圈后还有169.7 mAh/g的容量.     

Evaluation of Charged Defect Energy in Two-Dimensional Semiconductors for Nanoelectronics: The WLZ Extrapolation Method

Defects play a central role in controlling the electronic properties of two-dimensional (2D) materials and realizing the industrialization of 2D electronics. However, the evaluation of charged defects in 2D materials within first-principles calculation is very challenging and has triggered a recent development of the WLZ (Wang, Li, Zhang) extrapolation method. This method lays the foundation of the theoretical evaluation of energies of charged defects in 2D materials within the first-principles framework. Herein, the vital role of defects for advancing 2D electronics is discussed, followed by an introduction of the fundamentals of the WLZ extrapolation method. The ionization energies (IEs) obtained by this method for defects in various 2D semiconductors are then reviewed and summarized. Finally, the unique defect physics in 2D dimensions including the dielectric environment effects, defect ionization process, and carrier transport mechanism captured with the WLZ extrapolation method are presented. As an efficient and reasonable evaluation of charged defects in 2D materials for nanoelectronics and other emerging applications, this work can be of benefit to the community.