A highly specific polyclonal antiserum to the environmental contaminant 1,1,1-trichloro-2,2-bis-(4-chlorophenyl)-ethane (p,p′-DDT)

A very selective polyclonal antiserum against 1,1,1-trichloro-2,2-bis-(4-chlorophenyl)-ethane (p,p′-DDT) was obtained by a careful choice of the haptenic structure (2,2-bis(4-chlorophenyl)-ethanol hemisuccinate). This hapten was conjugated to BSA to prepare the immunogen. The effects of different types of solid phases on the equilibrium reaction between the hapten on solid phase and the polyclonal antiserum were evaluated to obtain a fine tuning of the antiserum performances in terms of specificity for p,p′-DDT and sensitivity to low levels of this pesticide. The calibration curves obtained show that it is possible to set up a sensitive assay for p,p′-DDT, employing a p,p′-dichlorodiphenylacetic acid-based solid phase, with a detection limit of 0.12 ng/mL and a working range of about 0.21–40 ng/mL. Selectivity towards several p,p′-DDT-related substances was good (o,p-DDT 17%, p,p′-DDD 1.2% o,p-DDD 6.3%, p,p′-DDE 6.7%).     

A new approach to phosphoserine and phosphothreonine analysis in peptides and proteins: chemical modification,enrichment via solid-phase reversible binding,and analysis by mass spectrometry

beta-Elimination of the phosphate group on phosphoserine and phosphothreonine residues and addition of an alkyldithiol is a useful tool for analysis of the phosphorylation states of proteins and peptides. We have explored the influence of several conditions on the efficiency of this PO(4)(3-) elimination reaction upon addition of propanedithiol. In addition to the described influence of different bases, the solvent composition was also found to have a major effect on the yield of the reaction. In particular, an increase in the percentage of DMSO enhances the conversion rate, whereas a higher amount of protic polar solvents, such as water or isopropanol, induces the opposite effect. We have also developed a protocol for enrichment of the modified peptides, which is based on solid-phase covalent capture/release with a dithiopyridino-resin. The procedure for beta-elimination and isolation of phosphorylated peptides by solid-phase capture/release was developed with commercially available alpha-casein. Enriched peptide fragments were characterized by MALDI-TOF mass spectrometric analysis before and after alkylation with iodoacetamide, which allowed rapid confirmation of the purposely introduced thiol moiety. Sensitivity studies, carried out in order to determine the detection limit, demonstrated that samples could be detected even in the low picomolar range by mass spectrometry. The developed solid-phase enrichment procedure based on reversible covalent binding of the modified peptides is more effective and significantly simpler than methods based on the interaction between biotin and avidin, which require additional steps such as tagging the modified peptides and work-up of the samples prior to the affinity capture step.     

Effect of molecular weight on the exponential growth and morphology of hyaluronan/chitosan multilayers: a surface plasmon resonance spectroscopy and atomic force microscopy investigation

The layer-by-layer growth of multilayer assemblies of two polysaccharides, the polyanion hyaluronan (HA) and the polycation chitosan (CH), was investigated using atomic force microscopy (AFM) and surface plasmon resonance (SPR) spectroscopy, with primary emphasis on the effect of the polysaccharide molecular weights on the film thickness and surface morphology. The HA/CH multilayers exhibit an exponential increase of the optical film thickness with the number of deposited bilayers. We show that the multilayer thickness at a given stage depends on the size of both CH, the diffusing polyelectrolyte, and HA, the non-diffusing species. Assemblies (12 bilayers) of high molecular weight polysaccharides (HA, 360,000; CH, 160,000) were twice as thick (approximately 900 nm vs approximately 450 nm) as those obtained with low molecular weight polymers (HA, 30,000; CH, 31,000), as assessed by AFM scratch tests. The exponential growth rate is the same for the high and low molecular weight pairs; the larger film thicknesses observed by SPR and by AFM arising from an earlier onset of the steep exponential growth phase in the case of the high molecular weight pair. In all cases, isolated islets form during the deposition of the first CH layer onto the underlying HA. Upon further film growth, individual islets coalesce into larger vermiculate features. The transition from distinct islands to vermiculate structures depends on the molecular weights of the polysaccharides and the lower molecular weight construct presents larger worm-like surface domains than the high molecular weight pair.     

Experimental and theoretical study of the interaction of CO2 with alpha-Al2O3

Density functional molecular cluster calculations are combined with X-ray photoelectron spectroscopy (XPS), quadrupolar mass spectrometry (QMS), and diffuse reflectance infrared Fourier transform (DRIFT) spectroscopy to investigate the interaction of CO2 with alpha-Al2O3 and partially reduced alpha-Al2O3. The electronic structure of the stoichiometric and partially reduced substrate, adsorbate geometries, chemisorption enthalpies, and adsorbate vibrational parameters are computed and discussed. Theoretical results agree quite well with experimental data and previous theoretical investigations. As far as the adsorbate-substrate interaction is concerned, the results of our calculations indicate that CO2 forms bidentate-chelating carbonate species. The bonding scheme of this surface complex implies a significant substrate-->adsorbate transfer of charge (from the occupied dangling bond of a surface Lewis base site into one component of the CO2 2 pi u LUMO) assisted by a definitely weaker adsorbate-->substrate donation (from one component of the CO2 1 pi g HOMO into an empty dangling bond of a surface Lewis acid site). Our estimate of the chemisorption enthalpy (-15 kcal/mol) agrees quantitatively with calorimetric data reported for CO2 adsorbed on high surface area alpha-alumina (-16.0 kcal/mol). [Mao, C.-F.; Vannice, M. A. Appl. Catal. A 1994, 111, 151.] According to XPS and QMS outcomes, theoretical results predict that the interaction of CO2 with partially reduced alpha-Al2O3 gives rise to the reduction of the adsorbate to CO and to the concomitant substrate reoxidation.     

Poly(4‐vinylpyridine) as the host ligand of metal‐containing chromophores for second‐order nonlinear optical active materials

Two formulas of grafted polymers with metal‐containing chromophores, potentially suitable for second‐order nonlinear optics applications, are described. Two chromophores were obtained from a tridentate ligand coordinated to Cu(II) or Pd(II) ions. The organometallic chromophore fragments were grafted to poly(4‐vinylpyridine) by the pyridinic nitrogen of the host polymer. Some qualities displayed by the new metallated polymers are remarkable: (1) a high value of the first hyperpolarizability coefficient of the chromophores, (2) a high content of the grafted chromophore in the polymers (up to 60 wt %), (3) a considerable increase in the glass‐transition temperatures (up to 240 °C), (4) good thermal stability in air (ca. 280 °C), and (5) good optical transparency of the films. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 2987–2993, 2002     

Au nanoparticles prepared by physical method on Si and sapphire substrates for biosensor applications

Gold nanoparticles heavily functionalized with oligonucleotides have been used in a variety of DNA detection methods. The optical properties of three-dimensional aggregates of Au nanoparticles in solution or deposited onto suitable surfaces have been analyzed to detect hybridization processes of specific DNA sequences as possible alternatives to fluorescent labeling methods. This paper reports on the preparation of gold nanoparticles directly deposited onto the surface of silicon (Si) and sapphire (Al2O3) substrates by a physical methodology, consisting in the thermal evaporation of a thin Au film and its successive annealing. The method guarantees the preparation of monodispersed single-crystal Au nanoparticles with a strong surface plasmon resonance (SPR) peak centered at about 540 nm. We show that the changes of SPR excitation before and after DNA functionalization and subsequent hybridization of Au nanoparticles immobilized onto Si and Al2O3 substrates can be exploited to fabricate specific biosensors devices in solid phase.     

Development of a liquid chromatography/electrospray tandem mass spectrometry method for confirmation of chloramphenicol residues in milk after alfa-1-acid glycoprotein affinity chromatography

In this work we present a method for confirmatory analysis of chloramphenicol (CAP) in bovine and buffalo raw milk. CAP is extracted in acetonitrile and purified by affinity chromatography on an alpha-1-acid glycoprotein (AAG) column, then is identified and determined by ion-trap liquid chromatography/electrospray ionisation tandem mass spectrometry (LC/ESI-MS/MS) analysis in the negative ion mode. CAP was identified at the minimum required performance limit (MRPL) of 0.30 ppb, by monitoring the [M-H]- ion and at least two product ions, meeting the qualitative and quantitative criteria set by the European Commission in Decision 2002/657/EC for confirmation of prohibited veterinary drugs. The trueness and within-day and between-day repeatability data are also reported. Moreover, the loading capacity of affinity columns towards CAP was tested. This method, based on the molecular recognition between drug and AAG during the purification step to improve sample cleanup, represents a quantitative and repeatable procedure for confirmatory analysis, and fits the requirements for the routine official control of CAP residues in raw milk.