甲烷浓度对碳化硅基底金刚石薄膜摩擦性能影响

利用热丝化学气相沉积法(HFCVD)在碳化硅基底上制备金刚石薄膜,采用场发射扫描电子显微镜、拉曼光谱仪、原子力显微镜研究了在不同甲烷浓度条件下制备的金刚石薄膜表面形貌及物相组成,在干摩擦条件下通过往复式摩擦磨损实验测试并计算了已制备金刚石薄膜的摩擦系数和磨损率,结合物相分析及摩擦磨损实验结果分析了甲烷浓度的改变对金刚石薄膜摩擦磨损性能的影响。结果表明,由于甲烷气体含量的升高,金刚石薄膜结晶质量下降,薄膜由微米晶向纳米晶转变。摩擦磨损实验结果显示:3%甲烷浓度条件下制备的金刚石薄膜耐磨性较好,磨损率为2.2×10^-7 mm³/mN;5%甲烷浓度条件下制备的金刚石薄膜摩擦系数最低(0.032),磨损率为5.7×10^-7 mm³/mN,制备的金刚石薄膜的耐磨损性能相比于碳化硅基底(磨损率为9.89×10^-5 mm³/mN)提升了两个数量级,显著提高了碳化硅基底的耐磨性。     

催化剂薄层内甲烷水蒸气重整反应强化管内对流换热的数值模拟

本文以竖直圆管内壁催化剂薄层内发生甲烷水蒸气重整反应强化对流换热作为研究对象,对其进行了数值模拟．结果发现,催化剂薄层内的吸热化学反应可以有效地强化对流换热,降低流体和壁面温度,从而对壁面起到保护作用;极限热流密度的大小与流体的入口温度有关,存在最佳入口温度使极限热流密度最大．     

Modulated DSC for gas hydrates analysis

Modulated DSC has been applied to the study of methane, ethane and propane hydrates at different hydrate and ice concentrations. The reversing component of the TMDSC curves, makes it possible to characterize such hydrates. Methane and ethane hydrates show the melting-decomposition peak at a temperatures higher than the ice contained in the sample, while propane hydrate melts and decomposes at lower temperature than the ice present in the sample. The hydrate peaks tend to disappear if the hydrate is stored at atmospheric pressure. Guest size and cavity occupation fix the heat of dissociation and stability of the hydrates, as confirmed by parallel tests on tetrahydrofurane hydrates.     

Calorimetric study of methane interaction with supported Pd catalysts

As supported palladium oxide catalysts present the best performances in methane combustion in lean conditions, microcalorimetric studies of the interaction between methane and palladium oxide or metallic palladium supported on Al₂O₃, ZrO₂ and BN have been performed at 673 K. At this temperature methane reduced the palladium oxide, and the heat of reduction of palladium oxide was shown to depend on the dispersion and on the support. The lowest heats of reduction corresponded to the highest rates of methane combustion. Moreover methane reforming occurred on metallic palladium, producing hydrogen, and again methane decomposition was shown to depend on the support. This revised version was published online in July 2006 with corrections to the Cover Date.     

CO_2 Reforming of CH_4 over Ni/CeO_2-ZrO_2-Al_2O_3 Prepared by Hydrothermal Synthesis Method

The Ni/CeO2-ZrO2-Al2O3 catalyst with different Al2O3 and NiO contents were prepared by hydrothermal synthesis method. The catalytic performance for CO2 reforming of CH4 reaction, the interaction among components and the relation between Ni content and catalyst surface basicity were investigated. Results show that the interaction between NiO and Al2O3 is stronger than that between NiO and CeO2-ZrO2.The addition of Al2O3 can prevent the formation of large metallic Ni ensembles, increase the dispersion of Ni, and improve catalytic activity, but excess Al2O3 causes the catalyst to deactivate easily. The interaction between NiO and CeO2 results in more facile reduction of surface CeO2. The existence of a small amount of metallic Ni can increase the number of basic sites. As metallic Ni may preferentially reside on the strong basic sites, increasing Ni content can weaken the catalyst basicity.     

添加助剂的钙钛矿型氧化物NdMO_3上的甲烷氧化偶联——Ⅱ.15% Li_2O/NdMO_3(M=Cr、Mn、Fe、Co、Ni)上的OCM反应研究

在添加了15%Li_2O的NdMO_3(M=Cr、Mn、Fe、Co、Ni)上进行了甲烷氧化偶联(OCM)反应研究.通过改变反应气中CH_4:O_2浓度比,在氧化态和“脱氧态”催化剂上的CH_4脉冲反应,探讨了表面吸附氧和晶格氧在OCM反应中的作用以及NdMO_3中不同金属离子(M)对OCM反应活性的影响等.     

THE AROMATIZATION MECHANISM OF METHANE OVER Mo/HZSM-5 ZEOLITE CATALYSTS WITHOUT USING OXIDANTS

IntroductionMethancisthcmaJorcomponcntofnaturalgasanditscatalyticconvcrsiontodcsiredchemicalproductsorliquidfiJcIisnotonl}'apromisingapproachtotheutilizationofnaturalgasrcsourccbutalsoagrcatsubjcctforcatalysissciencctt'hichdcaIst"iththcactivationofsmallmolcculesThcx"orldrcscrvcofnaturalgashasbccnexplorcdasaboutl382562xl()8m3IllTheMTGprocessdcvclopedbythcMobilcorpcangctliquidfuelfrommethancthroughsteamreformingofmethanctoproduccsynthcsisgaswhichisassociatedt'ithamaJorityofthecostsofthcprocc…     

La2Zr2O7催化剂结构相变对甲烷氧化偶联反应性能的影响

采用共沉淀法并通过改变焙烧温度制备了一系列具有不同晶相结构的La₂Zr₂O₇催化剂，在微型固定床反应器上评价其甲烷氧化偶联反应性能，并利用XRD、Raman、CO₂-TPD、XPS等表征手段，探究催化剂的物相结构、表面碱性以及表面氧物种的变化规律。结果表明，随着焙烧温度从700℃逐渐升高到1200℃，La₂Zr₂O₇催化剂结晶度不断提高，晶相发生明显变化，从无定形结构逐渐向缺陷萤石结构过渡，最终转变成烧绿石结构。焙烧温度提高促使La₂Zr₂O₇晶相转变过程中，催化剂表面的碱性强度减弱，中等碱性位数量以及具有催化活性的表面氧物种O₂^2-和O₂^-的相对含量不断减少，致使催化剂的CH₄转化率和C₂₊选择性不断降低。其中，无定形LZO-CP-700催化剂表现出最佳的甲烷氧化偶联反应性能。     

镧掺杂粘土源含铜氧化物催化剂的制备、表征及催化性能

采用共沉淀和水热法合成了不同阴离子粘土前驱型复合氧化物催化材料,样品经XRD,FTIR,TPR,TG-DSC,SEM进行表征.同时考察了铜含量在掺杂和不掺杂稀土时对甲烷催化燃烧的影响,结果发现随含铜量增加催化活性增加;未掺杂La的催化剂在高温下出现失活现象,而掺杂型催化剂稳定性良好.同时,制备方法对催化剂的性能有显著影响,在不同制备前驱物pH的条件下,使用共沉淀和水热法合成的阴离子粘土材料,合成时的pH均对催化剂的活性影响较大;同时焙烧温度对催化活性有不同程度的影响.