Enthalpies of sorption of linear hydrocarbons (C2–C8) and chloroderivatives of methane and ethylene on the surface of hydrotalcite

Differential molar adsorption enthalpies (DMAE) were determined by gas chromatographic measurements of specific retention volume of vapors on the surface of two forms of Mg–Al hydrotalcite. A linear dependence of the DMAE on the number of the carbon atoms in hydrocarbons was observed for both form of hydrotalcite. The dependence of the differential molar adsorption enthalpies on the number of chlorine atoms in organic molecules is discussed. A linear dependence of DMAE on the molecular weight of chloroderivatives of methane and ethylene on the basic form in an order monochloromethane < dichloromethane < trichloromethane or vinylidene chloride < 1,1-dichloroethylene < trichloroethylene was found.     

铈杂多配离子-水滑石超分子层柱材料ZnAl-Ce(PMoV)2的插层组装、表征及催化性能

以十四酸根阴离子柱撑Zn-Al水滑石Zn0.77Al0.22(OH)2.0.22C13H27COO.0.81 H2O(记为ZnAl-14A)为预撑前体,在水溶液中用离子交换法将以2∶17缺位杂多酸根离子(P2Mo16VO61)11-记为(P Mo V)为配体的稀土杂多配阴离子Ce(P2Mo16VO61)219-(记为Ce(PMoV)2)插层组装到水滑石层板间,合成了一种具有大的层间距(3.37 nm)的超分子插层材料Zn0.77Al0.23(OH)2.0.0105[Ce(P1.9Mo15.7V1.1O61)2].0.011C13H27COO.0.83H2O(记为ZnAl-Ce(PMoV)2)。用ICP,IR,XRD和DTA对产物的组成和结构进行了表征。结果表明,该产物中Ce(PMoV)2配阴离子沿其长轴垂直于层板的方向分布于水滑石层间;产物具有规整的层状结构和热稳定性;产物对乙酸与正丁醇的酯化反应,二甘醇的脱水-环化反应和H2O2氧化环己烷的反应有良好的催化性能,且易于回收重复使用。     

CuZnAl水滑石衍生催化剂上甲醇水蒸气重整制氢Ⅲ.合成水滑石用金属盐的影响

采用共沉淀法,用不同金属盐为Cu源和Zn源合成了一系列CuZnAl水滑石,以此为前体经600℃焙烧后制得相应催化剂.用硝酸盐和醋酸盐合成的水滑石结晶度高,其衍生催化剂比表面积大、Cu的分散性好且易于还原;而用硫酸盐和盐酸盐合成的水滑石结晶度差,其衍生催化剂比表面积小、Cu的分散性差且不易还原.反应评价结果显示,用硝酸盐和醋酸盐制得的催化剂活性高、反应稳定性好;而用硫酸盐和盐酸盐制得的催化剂由于低的Cu表面积以及S和Cl的毒化作用而几乎无催化活性.在醋酸盐制备的催化剂上,产物干气中CO的浓度明显较低,在250℃和WHSV=3.28 h-1的条件下约为0.03%~0.04%,仅为硝酸盐所制催化剂上CO浓度的1/5;在210℃和WHSV=0.5 h-1的条件下,该催化剂上甲醇几乎完全转化,同时CO浓度降至约0.005%.N2O滴定、CO2程序升温脱附和程序升温还原结果显示,用醋酸盐和硝酸盐制备的催化剂具有极相近的Cu表面积和表面碱性,但前者CuO的还原峰温较后者低近70℃,归因于ZnO与CuO间的强相互作用,这是催化剂具有良好选择性的可能原因.     

有机阴离子柱撑水滑石催化酯交换合成碳酸二苯酯

 A series of organic anion-pillared hydrotalcites were synthesized by the ion exchange method and characterized by X-ray diffraction and Fourier transform infrared spectroscopy. The hydrotalcite precursor and pillared hydrotalcites with different anions was tested as catalysts in transesterification of dimethyl carbonate (DMC) with phenol. The results show that the catalytic selectivity of this transesterification reaction over these organic anion-pillared hydrotalcites is significantly improved. The catalytic selectivities of C4H4O4-, C6H8O4-, C10H16O4-, 1,4-C8H4O4-, and C7H5O2-pillared hydrotalcites for transesterified products (diphenyl carbonate and methyl phenyl carbonate) are all greater than 90%, at least 10% higher than that of the hydrotalcite precursor. Under the conditions of n(phenol)/n(DMC)=4, catalyst amount=1.5%, and t=10 h, the C6H8O4-pillared hydrotalcite presents the best catalytic performance, and the DMC conversion and the selectivity for transesterified products reach 43.8% and 93.2%, respectively.     

典型钙/镁基吸附剂对二氧化硒吸附特性研究

针对钙/镁基矿物吸附剂的主要组分CaO、CaCO₃、MgO在500-800 ℃下对Se的吸附特性进行研究，并选取天然矿物方解石、白云石研究其对Se的吸附效果，且对矿物煅烧所得CaO进行吸附实验。结果表明，三种组分中CaO的吸附效果最佳，800 ℃时单位质量CaO对Se的吸附量可达368 mg/g。CaCO₃对Se的吸附在700 ℃时效果最佳且其吸附产物的热稳定性较好。镁基吸附剂仅在中温段对Se具有一定吸附效果。方解石对Se的吸附效果随温度变化趋势与CaCO₃相似，因其较好的孔隙结构，吸附效果略优于CaCO₃。煅烧方解石得到的F-sor对Se的吸附效果优于CaO和CaCO₃煅烧得到的C-sor，这与其良好的比表面积、孔隙结构与抗烧结能力有关，且F-sor吸附产物的热稳定性相对较好。F-sor对Se的吸附量最高可达403 mg/g。     

超分子结构水杨酸根插层水滑石的组装及结构与性能研究

以锌铝水滑石ZnAl-CO3 LDHs为前体（主体），以乙二醇为分散介质，用离子 交换法组装了水杨酸根（客体）插层水滑石ZnAl-[o-HO(C6H4)COO]LDHs，并用XRD ，FT-IR，TG-DTA等手段对样品进行了表征。结果表明，能过控制离子交换条件， 水杨酸根阴离子可取代锌铝水滑石前体层间的CO3^2-离子，组装得到晶体结构良好 的水杨酸根插层水滑石。通过研究发现，主体水滑石层板与客体以静电力和氢键相 互作用，得到的超分子结构材料紫外阻隔作用增强并具有较好的稳定性，从而成为 一种集屏蔽和吸收双重功能的新型无机-有机得合紫外阻隔材料。     

尿素法合成高结晶度类水滑石

尿素的高温分解特性被用于控制层状化合物合成过程中的pH值。室温下尿素可与硝酸盐形成均一溶液，当其高温分解时可以保证溶液内部各点的pH值始终一致，因而可获得高结晶度的水滑石样品。利用该法可合成出Mg-Al、Zn-Al及Ni-Al类水滑石，但难以合成出Co-Al，Mn-Al及Co-Cr类水滑石，相信这与不同金属离子发生沉淀时所需的pH值有关。     

The Adsorption of NOx on Magnesium Aluminium Hydrotalcite

Magnesium aluminium hydrotalcite (Mg-Al-HT) with molar ratio of Mg-to-Al of 3 to 1 was prepared and characterized by X-ray diffraction (XRD) and infrared spectra (IR). The performances of Mg-Al-HT for the adsorption and desorption of NOx were studied. The results indicated that the adsorption capacity of the hydrotalcite for NOx was 1398.2mg/g, and it was higher than the acticarbon‘s. The adsorption capacities depended on adsorption time and temperature.Mg-Al-HT could be regenerated by thermal decomposition, and the adsorption efficiency had not changed markedly after three cycles.     

钴铬水滑石的合成及表征

采用共沉淀法合成了一系列不同Co/Cr物质的量比的碳酸根型水滑石。用X－衍射、红外光谱、差热、热重、分光光度等方法对其组成和结构进行了研究。结果表明Co/Cr投料比为2到3时能形成结晶度好、纯度高的水滑石。初步推测了部分产物的组成及所含水滑石的化学式。     

钴镁铁水滑石的合成、表征及衍生复合氧化物酸碱催化活性研究

以Co(NO3)2.6(H2O)、Mg(NO3)2.6(H2O)和Fe(NO3)3.9(H2O)为原料,以NaOH和Na2CO3为沉淀剂采用低过饱和共沉淀法合成了CoMgFe系列的碳酸根水滑石,通过XRD,IR,TG-DTA,等手段对样品进行测试和表征,X-衍射结果显示,其M2 /M3 投料物质的量比为2-4得到的水滑石为理想构型。经焙烧后,发现其复合氧化物对乙醇催化脱水、脱氢反应有一定的活性。