Flow-induced shear stress and deformation of a core–shell-structured microcapsule in a microchannel

A numerical model was developed and validated to investigate the fluid–structure interactions between fully developed pipe flow and core–shell-structured microcapsule in a microchannel. Different flow rates and microcapsule shell thicknesses were considered. A sixth-order rotational symmetric distribution of von Mises stress over the microcapsule shell can be observed on the microcapsule with a thinner shell configuration, especially at higher flow rate conditions. It is also observed that when being carried along in a fully developed pipe flow, the microcapsule with a thinner shell tends to accumulate stress at a higher rate compared to that with a thicker shell. In general, for the same microcapsule configuration, higher flow velocity would induce a higher stress level over the microcapsule shell. The deformation gradient was used to capture the microcapsule's deformation in the present study. The effect of Young's modulus on the microcapsule shell on the microcapsule deformation was investigated as well. Our findings will shed light on the understanding of the stability of core–shell-structured microcapsule when subjected to flow-induced shear stress in a microfluidic system, enabling a more exquisite control over the breakup dynamics of drug-loaded microcapsule for biomedical applications.     

Majorana Representation for a Composite System

International Journal of Theoretical Physics - The Majorana representation, which provides an intuitive way to represent the quantum state by stars on the Bloch sphere, has drawn considerable...     

MCNOs/CdS双效光催化剂的制备及其性能研究

水热合成法制备了不同磁性纳米洋葱碳(MCNOs)负载量(0%、1%、3%、5%)的MCNOs/CdS光催化剂。并通过X射线衍射分析(XRD)、扫描电子显微镜(SEM)、傅里叶红外光谱(FT-IR)、X射线光电子能谱(XPS)、紫外可见光光谱(UV-Vis)、磁滞回线测定仪(VSM)对其进行表征,探究了MCNOs负载比例对催化剂在可见光下降解RhB性能及机理的影响。结果表明,MCNOs能有效提高CdS的光催化效果,复合3%MCNOs后降解率为96%,与纯CdS相比降解率提高了30%,磁性分析表明,其具有良好的顺磁性并能实现催化剂的有效回收。MCNOs/CdS在可见光下催化降解RhB的一级反应动力学直线有较好的拟合度,表明制备的催化剂有较好的催化活性。     

Preparation and gas sensing activity of La and Y co-doped titania nanoparticles

Journal of Sol-Gel Science and Technology - A novel gas sensing material, La–Y co-doped TiO2 nanoparticles, was synthesized by sol–gel method and applied to detect organic pollutants...     

A New Approach to Develop a Standardized Method for Simultaneous Analysis of Astragaloside IV and Formononetin in Radix Astragali by High-Performance Thin-Layer Chromatography

JPC – Journal of Planar Chromatography – Modern TLC - A new high-performance thin-layer chromatographic (HPTLC) method has been developed for the simultaneous estimation of...     

基于响应面法的直拉硅单晶生长工艺参数优化方法

在直拉法制备硅单晶的过程中,要得到优质的晶体必须建立合理的温度分布,而单晶炉内热场的分布与工艺参数的设定密切相关.其中以晶体转速、坩埚转速和拉速等三个工艺参数对热场分布的影响尤为显著.为了确定最佳热场分布下晶转、埚转及拉速的设定值,本文采用响应面算法通过方程拟合、回归分析等步骤求解这三个工艺参量与温度梯度之间的最佳函数模型,并在该模型下同时对这三个工艺参量进行优化分析,且通过仿真实验和拉晶实验表明该方法的有效性.     

Te溶剂Bridgman法CdMnTe晶体核辐射探测器的制备和表征

碲锰镉(CdMnTe)作为性能优异的室温核辐射探测器材料,可用于环境监测和工业无损检测领域。本文中采用Te溶剂Bridgman法生长In掺杂Cd_0.9Mn_0.1Te晶体,制备成10 mm×10 mm×2 mm大小的室温单平面探测器,研究了该探测器对²⁴¹Am@59.5 keV γ射线源的能谱响应。通过表征红外透过率、电阻率以及探测器能谱响应等参数,综合评定了探测器用CdMnTe晶体的质量、电学和探测器性能。结果表明,晶片的红外透过率均在55%以上,最好可达到60%。采用湿法钝化,100 V偏压下的漏电流由钝化前的9.48 nA降为钝化后的7.90 nA,钝化后的电阻率为2.832×10¹⁰ Ω·cm。在-400 V反向偏压下,CdMnTe探测器对²⁴¹Am@59.5 keV γ射线源的能量分辨率在钝化前后分别为13.53%和12.51%,钝化后的电子迁移率寿命积为1.049×10^-3 cm²/V。研究了探测器的能量分辨率随电压的变化特性,当偏压≤400 V时,探测器的能量分辨率主要由载流子的收集效率决定,而当偏压>400 V时,能量分辨率由漏电流决定。本文研究结果表明,Te溶剂Bridgman法生长的CdMnTe晶体质量较好,电阻率和电子迁移率寿命积满足探测器制备需求。     

A generalized super AKNS hierarchy associated with orthosymplectic Lie superalgebra OSP(2,2) and its super bi-Hamiltonian structures

For the orthosymplectic Lie superalgebra $\text{◂⋅▸}OSP(2,2)$, we choose a set of basis matrices. A linear combination of those basis matrices presents a spatial spectral matrix. The compatible condition of the spatial part and the corresponding temporal parts of the spectral problem leads to a generalized super AKNS (GSAKNS) hierarchy. By making use of the supertrace identity, the obtained GSAKNS hierarchy can be written as the super bi-Hamiltonian structures.