超声波燃气表矩形流道的雷诺修正系数仿真研究

在超声波流量计测量技术中, 雷诺修正系数相关的研究对于提高计量精度有重要作用. 为研究矩形流道的雷诺修正系数与雷诺数的关系, 对矩形流道在常温常压流量较小情况下进行仿真, 结果发现: 矩形流道层流状态下的雷诺修正系数与雷诺数呈线性相关. 保持压强、体积流量不变, 在不同温度下进行仿真及拟合, 结果表明: 在不同温度下雷诺修正系数与雷诺数的线性关系依然满足. 在上述实验基础上, 对矩形流道湍流状态下的雷诺修正系数与雷诺数关系进行研究, 通过改变温度、压强和体积流量进行仿真及拟合发现, 矩形流道湍流状态下雷诺修正系数与雷诺数呈非线性相关.     

密度泛函理论方法研究填料表面对聚合物摩擦化学的影响

采用超声分散法制备出氧化铝、高岭土、氧化硅/聚四氟乙烯复合材料, 使用线性往复摩擦磨损试验机对比三种复合材料的摩擦学性能. 结果表明 质量分数10%的氧化铝、高岭土能将聚四氟乙烯的磨损率降低约4个数量级, 而氧化硅仅能降低约3个数量级. 对金属对偶表面形成的转移膜的形貌和化学成分进行分析发现 氧化铝、高岭土/聚四氟乙烯在金属对偶面上形成了高度羧酸盐化的转移膜. 用密度泛函理论对三种填料表面上碳氟分子吸附过程进行模拟, 结果显示氧化铝、高岭土表面的路易斯酸性位点促进了碳氟分子的脱氟过程, 产生了更多的羧酸螯合物的中间产物; 氧化硅缺少路易斯酸性位点, 因此不能促进高度羧酸盐化的转移膜形成.     

基于气体浓度定量的嗅觉刺激器优化设计

现有的基于磁共振测量的嗅觉刺激器，通过调节嗅剂液体浓度的方法可以实现不同浓度的嗅觉刺激，但随着实验进行，受到嗅剂挥发以及实验环境（温度、湿度、气流量）变化的影响，很难确保输送至鼻腔的嗅剂气体浓度的稳定性，进而影响实验结果的准确性．本研究对本实验室前期开发的嗅觉刺激装置进行改进，实现了气体浓度精确定量．改进后的嗅觉刺激器主要分为三个部分：控制系统、反馈系统和气路系统．控制系统主要实现气路系统的送气控制和嗅剂气体浓度调节；反馈系统则负责对气体浓度进行测量；气路系统则在原有基础上添加活性炭装置，降低无关因素干扰．装置改进之后，不同气路切换时间为75.2 ms，比原装置减少了1 s，有效提高刺激精度．实验结果显示，气体浓度调节前，300 s内乙醇、吡啶、乙酸戊酯嗅剂气体浓度分别下降6.7%、71.4%、79.2%，嗅剂气体浓度短时间内发生较大改变．加入气体浓度调节功能后，当气体浓度下降至目标浓度的90%时，可通过调节气泵电压改变嗅剂气流与空气气流比例，从而调节嗅剂气体浓度至目标值，其中吡啶、乙酸戊酯用时13 s．     

Controlling thermomechanical behavior of semicrystalline hydrogenated polynorbornene through the cis- to trans-cyclopentylene ratio

Though polynorbornene synthesized by ring-opening metathesis polymerization has an intrinsically all-cis configuration of the cyclopentylene backbone rings, a fraction of these rings can be epimerized to the trans configuration during hydrogenation over suitable catalysts. By varying the method of hydrogenation, semicrystalline hydrogenated polynorbornenes (hPNs) with trans levels between 0 and 36% were obtained. With increasing trans content, the glass transition temperature, melting point, and enthalpy of melting decrease modestly. By contrast, the temperature at which the hPN crystal transitions into a rotationally disordered polymorph varies strongly with trans content, ranging from 126 °C (all-cis) to 71 °C at 27% trans; at trans contents of 34% and above, no rotationally-ordered phase is observed at any temperature. The room-temperature Young's modulus shows no dependence on trans content, while the yield stress drops by 20% at 1% trans content and slowly decreases further with additional epimerization. The temperature dependence of the Young's modulus differs for trans-containing versus all-cis polymers, while the temperature dependence of the yield stress is set by the polymorph type (rotationally ordered vs. disordered).     

新型多孔材料用作色谱手性固定相

手性固定相是色谱法分离分析手性化合物的关键。近年来,随着材料科学的迅速发展,越来越多的新型手性材料被作为色谱固定相用于手性分离分析。本文综述了近5年来液相色谱、气相色谱和毛细管电色谱领域的新型手性固定相的研究进展,重点总结了基于手性多孔材料的新型手性固定相研究,最后对手性固定相的研究进行了总结与展望。     

The impact of insecticides containing deltamethrin and cyfluthrin on the composition of surface compounds in the larvae,females and males of Tenebrio molitor

This paper presents the effect of insecticides on the composition of the surface compounds of one of the most harmful insects, Tenebrio molitor, by analysis using GC–MS. As a result of the use of insecticides, the composition of the chemical compounds on the surface of insects changes, depending on the insecticides used. The most numerous groups of the marked compounds were fatty acids, alkanes, esters and sterols. The content of the identified compounds in the larvae increased at both 24 and 48 h after the application of insecticides, in comparison with the control samples. The content of identified compounds in the samples taken from the females increased 24, 48 and 72 h after the application of insecticides in comparison with the control samples. By contrast, in samples prepared from males, the content of identified compounds decreased 24 h after the application of insecticides, compared with the control samples. The highest content of chemical compounds was for fatty acids and alkanes after the use of insecticides. The content of fatty acids after the application of the insecticide with deltamethrin was 62.1 ± 3.3–466.9 ± 5.9 μg/g, and after the application of the insecticide with cyfluthrin was 49.9 ± 1.9–458.3 ± 4.2 μg/g. However, the content of alkanes after the use of deltamethrin was 115.6 ± 4.2–4672.0 ± 32.1 μg/g, and after the use of cyfluthrin was 189.4 ± 3.8–3975.0 ± 10.2 μg/g.     

Spectroscopic properties and bond dissociation energies of PbX,PbX±, PbX2 and PbX2± (X ​= ​F,Cl, Br,I)

Ab initio calculations have been performed to investigate some of the spectroscopic properties, like geometry, frequency, electron affinity, ionization potential and finally adiabatic bond dissociation energies (BDEs) of lead monohalides, lead dihalides and their ions viz. PbX, PbX^±, PbX₂, $\mathrm{P}\mathrm{b}{\mathrm{X}}_{\mathrm{2}}^{\pm }$ (X ?= ?F, Cl, Br, I) in their ground state at the QCISD(T)//MP2 level of theory using correlation consistent basis sets. For the validation of MP2 optimized geometry and frequency, we further obtained geometry and frequency of all the neutral and ionic systems using QCISD(T) method with the same basis sets. The BDEs of PbX₂ molecules are calculated using the BDEs of $\mathrm{P}\mathrm{b}{\mathrm{X}}_{\mathrm{2}}^{\pm }$ ions and taking ionization potential and electron affinity of various systems. The calculated values are found in good agreement with the available data. Most of the data for ionic systems are reported first time in literature.     

多孔离子液体的构筑及应用

多孔液体(Porous Liquids, PLs)是一类结合了多孔固体永久性孔隙与液态流动性优势的新材料. 自2007年, PLs的概念被首次提出以来, 其在合成策略与应用领域方面均取得了较大的突破. 然而, 传统的PLs因高黏度、高密度、高熔点与高原材料成本等缺陷极大程度制约了其在流动工业系统中的大规模应用. 因此, 迫切需要寻求理想的位阻溶剂用于制备先进的多孔液体. 离子液体(Ionic Liquids, ILs)因独特的可调节物理特性、非挥发性、高稳定性、易获得、经济性高、低再生能耗等特性, 使其成为构筑PLs中最具有应用前景的理想溶剂之一. 在过去的5年间, 基于多种ILs与先进多孔固体(如有机笼、金属有机框架、中空碳、沸石、多孔聚合物等)制备的多孔离子液体(Porous Ionic Liquids, PILs)被陆续报道. PILs独特的永久性孔隙、无溶剂挥发、再生能力强、黏度可调、低熔点、高稳定性等特性加快了其在气体吸附、分离、催化、萃取、分子分离等领域的快速发展. 本综述围绕PILs的构筑策略、特性、应用领域等阐述了其研究进展. 最后, 对PILs在制备中存在的挑战与未来的研究方向进行了归纳与展望.