Mass and isotopic concentrations of water-insoluble refractory carbon in total suspended particulates at Mt.Waliguan Observatory(China)

Mass concentration and isotopic values δ¹³C and ¹⁴C are presented for the water-insoluble refractory carbon（WIRC） component of total suspended particulates（TSP）,collected weekly during 2003,as well as from October 2005 to May 2006 at the WMO-GAW Mt.Waliguan（WLG） site.The overall average WIRC mass concentration was（1183±120）ng/m³（n = 79）,while seasonal averages were 2081 ±1707（spring）,454±205（summer）,650±411（autumn）,and 1019±703（winter） ng/m3.Seasonal variations in WIRC mass concentrations were consistent with black carbon measurements from an aethalometer,although WIRC concentrations were typically higher,especially in winter and spring.The δ¹³C PDB value（-25.3 ± 0.8）%.determined for WIRC suggests that its sources are C₃ biomass or fossil fuel combustion.No seasonal change in δ¹³C PDB was evident.The average percent Modern Carbon（pMC） for ¹⁴C in WIRC for winter and spring was（67.2 ± 7.7）%（n = 29）.Lower pMC values were associated with air masses transported from the area east of WLG,while higher pMC values were associated with air masses from the Tibetan Plateau,southwest of WLG.Elevated pMC values with abnormally high mass concentrations of TSP and WIRC were measured during a dust storm event.     

Microporous Hypercross-linked Conjugated Quinonoid Chromophores of Anthracene: Novel Polymers for CO2 Adsorption

Microporous hypercross-linked conjugated quinonoid chromophores represent a novel class of amorphous polymers, synthesized by the reaction of anthracene with dimethoxy methane in the presence of FeCl3 catalyst. Their N2 adsorption isotherms confirm their microporous nature. Diffuse reflectance UV-Visible(DRS UV-Vis) spectroscopy confirms their matrix built with the conjugated quinonoids by their broad light absorption characteristics extending from 1000 nm to 200 nm with the absorbance maximum close to 400 nm. The catalyst cross-linked anthracene with ―CH2― bridges and subsequently dehydrogenating them to form quinonoids. Their Fourier transform infrared(FTIR) spectra showed their characteristic quinonoid vibrations between 1600 and 1700 cm-1. The synthesis of polymers was carried out at 30, 40, 50, 60, 70 and 80 ℃, but the quinonoid content of the polymer obtained at 80 ℃ was higher than that of the others. Their scanning electron microscopy(SEM) images showed microspheres of 1 to 5 μm size built with tiny particles. Their surfaces were not smooth. The polymer synthesized at 80 ℃ showed 5.1 wt% CO2 sorption at 25 ℃ and 0.1 MPa, but when it was recross-linked, the CO2 sorption increased to 8 wt%. Hence, hypercross-linked conjugated quinonoid chromophores of anthracene are good for sorption of CO2.     

一类具非光滑位势p(x)-Laplace方程解的存在性

在非光滑临界点理论的基础上,利用带非光滑(PS)条件的山路引理,结合嵌入定理和Lebourg中值定理,获得了一类具非光滑位势p(x)-Laplace方程解的存在性.     

带分数阶耗散项的Quasi-geostrophic方程周期解的大时间性态

本文主要讨论带有分数阶耗散项的quasi-geostrophic(QG)方程的周期解的大时间性态,并且对初值θ_0没有小性的要求.对于次临界(1/2α1)和临界(α=1/2)两种情况,证明了方程的周期解均具有指数级的衰减性.     

L-fuzzy层双保序算子空间中的(ω_α,υ_α)-仿紧性

首先在层双保序算子空间中引进了两种(ω_α,υ_α)-仿紧性,证明了它们都是好的推广.其次,给出了它们的若干刻画与性质,并指出了它们保持若干拓扑不变性质.最后,讨论了(ω_α,υ_α)-仿紧性、(ω_α,υ_α)-分离性以及(ω_α,υ_α)-紧性之间的关系.     

近紫外激发Gd2ZnTiO6∶Eu3+,Li+红色荧光粉的制备及荧光性能

采用溶胶-凝胶法成功制备出系列Eu³⁺掺杂和Li⁺、Eu³⁺共掺杂Gd₂ZnTiO₆红色荧光粉,并研究Li⁺、Eu³⁺掺杂对样品的晶体结构、微观形貌及发光性能的影响。结果显示,所制备的Gd₂ZnTiO₆∶Eu³⁺,Li⁺(GZT∶Eu³⁺,Li⁺) 荧光粉为双钙钛矿结构,属于单斜晶系(空间群:P2₁/n),大小为10 μm的无规则形状的颗粒。在395 nm近紫外光的激发下,GZT∶Eu³⁺的发射光谱展示出典型的Eu³⁺线状特征光谱,发射峰中心位于615 nm处,归属于Eu³⁺的⁵D₀→⁷F₂跃迁。Eu³⁺的最佳掺杂浓度为0.07(摩尔分数),样品显示明显的浓度猝灭效应,其机制为电偶极子-电偶极子(d-d)相互作用。此外,研究还发现,Li⁺掺杂对样品的晶体结构、微观形貌没有影响,但是一定量的Li⁺掺杂可以显著增强样品的荧光强度。当Li⁺浓度为0.05时,荧光粉发射主峰强度增强程度最大,提高至原来的4.3倍,说明通过Li⁺、Eu³⁺共掺杂可以获得高亮度的GZT红色荧光粉。GZT∶0.14Eu³⁺,0.05Li⁺荧光粉的CIE色坐标为(0.631 1,0.375 3)与标准红光色坐标(0.670,0.330)较为接近,是一种潜在的LED用红色荧光粉。     

H2SO4-H2O中硝酸铜对脱硫石膏晶须生长的影响

以处理后的脱硫石膏为原料,在H₂SO₄-H₂O体系中以Cu(NO₃)₂为晶形控制剂采用水热法制备脱硫石膏晶须,探讨了Cu(NO₃)₂对脱硫石膏晶须生长的影响机理。结果表明:Cu(NO₃)₂对脱硫石膏有明显促溶作用,其中Cu²⁺可减小溶液中各离子的活度系数,使溶液中的Ca²⁺浓度增大。NO^-₃通过静电作用在Ca²⁺周围聚集并对SO^2-₄产生屏蔽作用,导致脱硫石膏继续溶解并使Ca²⁺和SO^2-₄的浓度处于相对稳定状态,有利于半水脱硫石膏晶体的形核与生长。此外,Cu²⁺还可在晶须的生长过程中选择性吸附在晶须表面,生成CuSO₄,促进了脱硫石膏的结晶生长,最终在Cu(NO₃)₂用量为2.0%(质量分数)时制备的脱硫石膏晶须长径比约为73。     

DMF体系中Cu2O球晶的制备及形貌分析

以N,N-二甲基甲酰胺(DMF)为溶剂,通过改变铜源和表面活性剂,调控反应参数,溶剂热条件下制备了三维十字形、空心及实心的Cu₂O球晶。利用XRD、SEM等表征手段,分析探讨了工艺条件变化对Cu₂O球晶形貌的影响。研究表明,随着DMF浓度的增大,体系的还原能力增强,Cu⁺增多,溶液的过饱和度增大,Cu₂O晶体集合体形态由晶体结构控制的各向异性与对称性的球晶逐渐向各向同性球晶演变。十二烷基硫酸钠(SDS)、十六烷基三甲基溴化铵(CTAB)、聚乙烯吡咯烷酮(PVP)等表面活性剂有助于降低溶液的过饱和度,增加结晶质的表面扩散能力,有利于规则形态Cu₂O晶粒的形成。反应体系中,Cu(Ac)₂·H₂O水解生成的羧基与DMF中的甲酰基在高温下发生脱羧反应产生CO₂气体以及SDS发泡作用产生的气体是形成空心Cu₂O球晶的重要原因。     

Ni、Mo共掺杂对SnO2材料性能影响的仿真研究

针对AgSnO₂触头材料存在的不足,采用基于密度泛函理论的第一性原理对SnO₂、Ni单掺杂、Mo单掺杂以及Ni-Mo共掺杂SnO₂材料进行了电性能与力学性质的研究,计算了各体系的形成能、能带结构、态密度、弹性常数等各项参数。结果表明,掺杂后的材料可以稳定存在,且仍为直接带隙半导体材料。与未掺杂相比,掺杂后体系的能带结构带隙值减少,其中Ni-Mo共掺杂时的带隙值最小,载流子跃迁所需能量减少,极大地改善了SnO₂的电性能;由弹性常数计算了剪切模量、体积模量、硬度等参数,其中Ni-Mo共掺杂时的硬度大幅降低,韧性增强,有利于AgSnO₂触头材料后续加工成型,且其普适弹性各向异性指数最小,不易形成裂纹。综合各项因素,Ni-Mo共掺杂能够很好地改善SnO₂的性能,为触头材料的发展提供了理论指导。     

基于5-磺基水杨酸的单、双核铜(Ⅱ)三元混配配合物的合成及晶体结构

以5-磺基水杨酸和咪唑衍生物为配体合成了单核、双核结构的三元混配Cu(Ⅱ)配合物:[Cu(H₂biim)(Hssal)(H₂O)₂]·H₂O(1)和{[Cu(MeHbiim)(Hssal)(H₂O)]·0.5H₂O}₂(2)(H₃ssal=5-磺基水杨酸,H₂biim=2,2’-联咪唑,MeHbiim=N-甲基-2,2’-联咪唑),并利用元素分析、红外光谱、紫外-可见光谱、X-射线单晶衍射及热重分析等技术手段对其结构进行了表征。单晶结构解析表明配合物1属于单斜晶系,P2₁／C 空间群,Cu(Ⅱ)离子与1个5-磺基水杨酸根、2个水分子以及1个联咪唑分子形成五配位四角锥构型的单核配合物结构。配合物2属于正交晶系,P2(1)2(1)2(1)空间群,双核Cu(II)离子分别处于五配位四角锥和四配位平面四边形的几何构型的配位环境中,与配合物1不同,5-磺基水杨酸采取μ₂双-单齿配位模式。荧光光谱分析表明配合物2具有较强的荧光性。