Synthesis and characterization of oligosalicylaldehyde-based epoxy resins

The synthesis of a new epoxy resin of oligosalicylaldehyde by the reaction with epichlorohydrin is reported. New resin’s epoxy value and chlorine content were determined and found to be 25% and 1%, respectively. The characterization of the new resin was instrumented by FTIR, ¹H NMR, scanning electron microscopy, and thermal gravimetric analyses. TGA results showed that the cured epoxy resin has a good resistance to thermal decomposition. The mass losses of cured epoxy resin were found to be 5%, 10%, 50% at 175°C, 240°C, and 400°C, respectively. On the curing procedure the resin was cured with polyethylenepolyamine at 25 °C for 8 h and 100°C for 1.5 h. The FTIR spectrum of new epoxy resin gave the peak of oxirane ring at ṽ = 918 cm⁻¹. In memory of Professor Dr. Adalet R. Vilayetoğlu     

An ultrasensitive method for the determination of thiouracil and phenylthiouracil using capillary zone electrophoresis and laser-induced fluorescence detection

This paper reports the development of a method based on capillary electrophoresis with laser-induced fluorescence detection for the simultaneous determination of thiouracil (TU) and phenylthiouracil (PhTU) with high sensitivity (nanomolar range, i.e., attomoles detected). After derivatization with 5-iodoacetamidofluorescein, the analytes were separated by capillary zone electrophoresis using 20 mM phosphate buffer (pH 10.0) and quantified by fluorescence detection. The linearity range, precision, recovery, and detection limits were determined, and the method was shown to be applicable for the determination of TU and PhTU in spiked feed samples and urine.     

Identifying acetylated lignin units in non-wood fibers using pyrolysis-gas chromatography/mass spectrometry

A series of non-wood plant fibers, namely kenaf, jute, sisal and abaca, have been analyzed upon pyrolysis-gas chromatography/mass spectrometry (Py-GC/MS) of the whole material. The pyrolysis products mainly arise from the carbohydrate and lignin moieties of the fibers. The lignin-derived phenols belonged to the p-hydroxyphenylpropanoid (H), guaiacylpropanoid (G) and syringylpropanoid (S) structures, and showed a high S/G ratio of between 2.0 and 5.4, the highest corresponding to kenaf. Among the lignin-derived phenols released, small amounts of sinapyl and coniferyl acetates (in both cis- and trans-forms) were identified for the first time upon Py-GC/MS of lignocellulosic materials. Acetylation of the sinapyl and coniferyl alcohols was at the gamma-position of the side chain. The release of these alcohols derived from intact acetylated lignin units upon pyrolysis seems to indicate that the native lignin in the fibers selected for this study is at least partially acetylated. Sinapyl (and coniferyl) acetates have recently been suggested to be authentic lignin precursors involved in the polymerization of lignin along with the normal sinapyl and coniferyl alcohols. Py-GC/MS will offer a convenient and rapid tool for analyzing naturally acetylated lignins, as well as to screen plant materials for the presence of acetylated units in lignin.     

Evaluation of new pregnane derivatives as 5alpha-reductase inhibitor

The objective of this study was to synthesize several new pregnane derivatives and evaluate them as antiandrogens. From the commercially available 16-dehydropregnenolone acetate (7), two new steroidal compounds were synthesized: 17alpha-hydroxy-17beta-methyl-16beta-phenyl-D-homoandrosta-1,4,6-triene-3,20-dione (18) and 17alpha-acetoxy-17beta-methyl-16beta-phenyl-D-homoandrosta-1,4,6-triene-3,20-dione (19). The 5alpha-reductase inhibitory effect of the new compounds 18 and 19 together with the previously synthesized intermediates 7, 8, 13, 16, and 17 was determined in three different models: gonadectomized hamster flank organs diameter size, incorporation of [1,2-(14)C]sodium acetate into lipids in flank organs and conversion of [3H]testosterone (T) to [3H]dihydrotestosterone (DHT) by Penicillium crustosum. The evaluation of these steroids was carried out with three different controls: one group was treated with vehicle, the second with T and the third group with T plus finasteride. The pharmacological results from this work demonstrated that T significantly increases the diameter of the pigmented spot on the flank organs (p<0.05) as well as the incorporation of labeled sodium acetate into lipids in gonadectomized hamster flank organs (from 0.125 to 0.255 nmol per gland). In this study we also observed that broth of Penicillium crustosum converted [3H]T to [3H]DHT in a manner comparable to that of the flank organs. All experiments indicated that finasteride as well as steroids 7, 8, 13, 16-19 reduced significantly the conversion of T to DHT in P. crustosum. These compounds also decrease the size of the pigmented spot in the flank organs as well as reducing the incorporation of radiolabeled sodium acetate into lipids; T and the control sample (treated with vehicle only) were used for comparison. Apparently the presence of the 4,6-diene-3,20-dione moiety and also the C-17 ester group produce a higher inhibitory effect on the parameters used. PPThe data from this study indicated also that the three models used for the pharmacological evaluation exhibited comparable results.     

Ethylenediamine effect on Co2+ uptake by zeolite Y

Co²⁺ ion exchange, at room temperature, from aqueous cobalt — sodium chloride solutions with NaY zeolite has been studied. The effect of contact time on the shape of the sorption curves of Co²⁺ using zeolite Y dehydrated at 600°C is similar to the one found in our previous work with a zeolite dehydrated at 150 °C. A fast sorption uptake is observed in which 1.8 meq of Na⁺ ions/g of zeolite are replaced by cobalt ions followed by a desorption process where the uptake decreases to 1.2 meq/g zeolite. The Co²⁺ sorption using zeolite Y dehydrated at 600 °C is increased when ethylenediamine solution is passed through the zeolite. The Co²⁺ sorption uptake, initially 2.0 meq/g, incrases to 2.8 meq/g of zeolite. This behavior is explained by the location and coordination of cobalt in zeolite Y sites. It is suggested that the highest uptake process is due to the blocking of zeolite sites by a Co complex compound.     

From nitrides to carbides: topotactic synthesis of the eta-carbides Fe3Mo3C and Co3Mo3C

The molybdenum bimetallic interstitial carbides Fe(3)Mo(3)C and Co(3)Mo(3)C have been synthesized by temperature-programmed reaction (TPR) between the molybdenum bimetallic interstitial nitrides Fe(3)Mo(3)N and Co(3)Mo(3)N and a flowing mixture of CH(4) and H(2) diluted in Ar. These compounds have been characterized by X-ray diffraction, laser Raman spectroscopy, elemental analysis, energy dispersive analysis of X rays, thermal analysis (in air) and scanning electron microscopy (field emission). Their structures have been refined from X-ray powder diffraction data. These carbides crystallize in the cubic system, space group Fd3m[a= 11.11376(6) and 11.0697(3)[Angstrom] for Fe and Co compounds, respectively].     

A fluorimetric study of pindolol and its complexes with cyclodextrins

Spectrofluorimetric characteristics of pindolol have been investigated with the aim of using this technique for analytical determinations. Other monosubstituted indole derivatives, 4-methoxy and 5-methoxyindole, have been also studied for comparative purposes. Corrected excitation and emission wavelengths in different solvents are reported and the effect of solvent on the Stokes shifts of these compounds has been analysed using the Lippert equation. In addition, the Stokes shift of pindolol has been determined in dioxan-water solvent mixtures and the presence of specific solvent effects is discussed. The fluorescence of pindolol is pH dependent, the quantum yields determined in water are lower than those in other solvents. With respect to the sensitivity, it has been found that the detection limits in aqueous solutions are improved in the presence of beta and methyl-beta-cyclodextrin. Finally, a fluorimetric analysis of the interaction between pindolol and different cyclodextrins has been carried out in order to determine the apparent stability constants of the complexes and the thermodynamic parameters associated to complexation.     

Photophysical properties of neutral and cationic tetrapyridinoporphyrazines

We describe the synthesis and photophysical properties of a series of neutral and cationic 3,4-tetrapyridinoporphyrazines, potential lead photosensitizers for photodynamic inactivation of bacteria. Tetracationic TPyPzs exist essentially as monomers in aqueous systems, but the presence of trialkylated compounds due to incomplete quaternization of the outer nitrogen atoms induces severe aggregation. The absorption, fluorescence, triplet, and singlet oxygen quantum yields for both the neutral and cationic compounds are comparable to those of the related phthalocyanines.     

Texture changes inside smectic-C droplets in azobenzene Langmuir monolayers

Preparation of Langmuir monolayers of a mixture of trans- and cis-isomers of an azobenzene derivative, 4-[4-[(4-octylphenyl)azo]phenoxy]butanoic acid, results in the segregation of birefringent trans-isomer domains embedded in an isotropic medium of cis-isomers. Brewster angle microscopy observations allow us to identify different textures inside the domains depending on surface pressure, temperature, and domain size. The evolution of the monolayer in the dark, from initial droplets formed after spreading to a stable stripe texture, is described. The dynamics of domain coalescence and some morphological transitions induced by temperature and surface pressure changes are also discussed. A simple theoretical model is included to supplement some of these experimental observations.     

Extraction of the (C4H9)4N+Co(II)SCN− ion-pair in chloroform and in isoamyl alcohol: Spectrophotometric determination of cobalt

When excesses of ammonium thiocyanate and tetrabutylammonium chloride are added to a cobalt(II) solution, a water-insoluble ion-pair is formed; this compound is soluble in chloroform, isoamyl alcohol, and other solvents. The variables which affect the extractions by these two solvents are studied in order to obtain the optimal conditions and two alternative extraction procedures are proposed. Thus, the separation of cobalt as a previous step for its spectrophotometric determination is studied.