Simultaneous determination of cloramphenicol, salicylic acid and resorcinol by capillary zone electrophoresis and its application to pharmaceutical dosage forms

This study demonstrates the separation of active ingredients in acne formulations (salicylic acid, cloramphenicol and resorcinol in presence of azulene) by capillary zone electrophoresis. Factors affecting their separations were the buffer pH and concentration, applied voltage, sample preparation, and presence of additives. Optimun results were obtained with a 50 mM sodium tetraborate-50 mM sodium phosphate, pH 9.0. The carrier electrolyte gave baseline separation with good resolution, short migration times (<6 min), great reproducibility and accuracy. Calibration plots were linear over at least three orders of magnitude of analyte concentrations, the lower limits of detection being within the range 0.39-1.25 μg ml⁻¹. The procedure was fast and reliable and commercial pharmaceuticals could be analysed without prior sample clean-up procedure.     

Estimates of the rate of convergence of a dynamic reconstruction algorithm under incomplete information about the phase state

In this paper, we study a dynamic reconstruction algorithm which reconstructs the unknown unbounded input and all unobservable phase coordinates from the results of measurements of part of the coordinates. An upper and a lower bound for the accuracy of the reconstruction is obtained. We determine the class of inputs for which the upper bound is uniform. We give a condition for optimally matching the algorithm parameters, ensuring the highest order of the upper bound and equating the orders of the upper and lower bounds. Thus, we establish the sharpness of the upper bound.     

On the sheaf of extendible ideals of topological algebras

In this paper a new sheaf for topological algebras, called the sheaf of extendible ideals, is introduced. It is shown that the sheaf space of this sheaf is uniformizable but not complete in general. The research of both of the authors was supported by Estonian Science Foundation grant 6205.     

Peptide labeling using 188Re, 188Re-MAG3 and 153Sm-H1ETA: A comparison on their in vitro lipophilicity

Lanreotide peptide was labeled with ¹⁵³Sm-H₁ETA and ¹⁸⁸Re-MAG₃ in order to evaluate whether or not their conjugation to the peptide produce significant differences of the in vitro lipophilicity with respect to the ¹⁸⁸Re-lanreotide prepared by the direct labeling method (highly lipophilic). The differences of lipophilicity between the complexes, were evaluated using a reverse phase HPLC system. The measured lipophilicity of ¹⁵³Sm-H₁ETA-lanreotide, ¹⁸⁸Re-MAG₃-lanreotide and ¹⁸⁸Re-lanreotide was taken to be the capacity factor [k" = (t _R-t ₀)/t ₀ where t _R is the retention time and t ₀ is the dead time] for each of the complexes under identical chromatography conditions. Results showed that the in vitro lipophilicity decreased in the order ¹⁸⁸Re-lanreotide (direct labeling), ¹⁸⁸Re-MAG₃-lanreotide and ¹⁵³Sm-H₁ETA-lanreotide. Since the last one has a capacity factor (k") similar to that of ¹⁸⁸Re-MAG₃, some renal elimination for ¹⁵³Sm-H₁ETA-lanreotide could be expected, which probably would reduce the unnecessary radiation dose to normal tissues.     

Structural Study of Silica Xerogel Composites Containing Pd Aggregates

Composites containing Pd aggregates dispersed in amorphous silica are of interest from both a fundamental and applied point of view because of their attractive catalytic properties. The silica powders added with palladium, prepared by the sol-gel method, were studied using X-ray diffraction, and IR- and UV-Vis-spectrophotometry. Silica xerogel samples were prepared using a ethanol/H₂O/TEOS molar ratio of 4:11.6:1 and loaded with sodium tetrachloropalladate. The silica xerogel microstructure of the powders was studied as a function of annealing temperature. Attention was paid to the evolution of the glass matrix as well as the palladium aggregates in the SiO₂ matrix. We found in our samples partial crystallization of the glass matrix in form of quartz and cristobalite phases with palladium oxide and metallic palladium phase at 1000^∘C. The Rietveld refinement method was used in order to determine the percentage of the phase contents.     

Experimental designs and response surface modeling applied for the optimization of metal-cyanide complexes analysis by capillary electrophoresis

The development of capillary zone electrophoresis (CZE) methods for the determination of metal cyanide complexes in real samples showed some problems, such as the low detection signal of Au (CN)2- and the low resolution between Ni(II) and Fe(II) cyanides in gold processing solutions, and the lack of separation of Pt(CN)4(2-) and Pd(CN)4(2-) in the leachates from automobile catalytic converters. To optimize some analytical parameters, the present study thus focused on the application of experimental designs and multiregression models. The following factors were examined by a two-level factorial design: applied voltage, injection time, detection wavelength, buffer ion, ionic strength and buffer modifiers. For optimization of the CZE method, subsequent response-surface experiments with the important factors were made with the two kinds of leaching solutions. Optimal analytical conditions were obtained in each case, giving good detection signals and resolution for the components of the studied leachates.     

Application of strategically designed sample composition to the rapid analytical screening of milk samples for polychlorinated biphenyls

Strategically designed sample composition (SSC) is a new technique that decreases the number of analytical determinations needed in routine screening to as few as the number of original sample specimens while providing information that is specific to them. Although this new technique has been applied to environmental studies, this paper describes its first application to food safety studies. Contamination of milk samples with polychlorinated biphenyls (PCBs) was chosen as a case study to show the usefulness and potential of the SSC technique with a fast analytical procedure that involves saponification of the samples and solid-phase microextraction of the PCBs. A total of 20 sample specimens can be analyzed in 11 determinations with excellent predictions of the positive samples and the concentration levels of the contaminants. The robustness of the strategy was investigated and demonstrated.     

Structure and aggregation number of a lyotropic liquid crystal: a fluorescence quenching and molecular dynamics study

The structure and aggregation number of a discotic lyotropic liquid crystal, prepared from tetradecyltrimethylammonium chloride (TDTMACl)/decanol (DeOH)/NaCl/H2O, have been examined using fluorescence quenching of pyrene by hexadecylpyridinium chloride and molecular dynamics (MD). The fluorescence method gives an aggregation number of 258 +/- 25 units (DeOH + TDTMACl). From the MD simulation, a lower limit for the aggregate dimension of 130 units of DeOH + TDTMACl is predicted. A stable oblate aggregate of 240 units was studied in detail. A strong polarization between the ammonium headgroups and chloride ions is observed from the calculated trajectory. DeOH headgroups are located, on average, 0.3 nm more to the interior of the aggregate than the TDTMACl headgroup and contribute to widening the interface by forming H-bonds with water. The radial distribution function of the ammonium headgroup shows that there are 16 water molecules in the first solvation sphere. The diagonal elements of the order parameter tensor of the tail atoms of both surfactants indicate that the interior of the micelle preserves about the same degree of order as at the interface, up to the last three atoms of the aliphatic chain, where the order starts to decrease.     

Highly efficient redox isomerization of allylic alcohols at ambient temperature catalyzed by novel ruthenium-cyclopentadienyl complexes--new insight into the mechanism

A range of ruthenium cyclopentadienyl (Cp) complexes have been prepared and used for isomerization of allylic alcohols to the corresponding saturated carbonyl compounds. Complexes bearing CO ligands show higher activity than those with PPh3 ligands. The isomerization rate is highly affected by the substituents on the Cp ring. Tetra(phenyl)methyl-substituted catalysts rapidly isomerize allylic alcohols under very mild reaction conditions (ambient temperature) with short reaction times. Substituted allylic alcohols have been isomerized by employing Ru-Cp complexes. A study of the isomerization catalyzed by [Ru(Ph5Cp)(CO)2H] (14) indicates that the isomerization catalyzed by ruthenium hydrides partly follows a different mechanism than that of ruthenium halides activated by KOtBu. Furthermore, the lack of ketone exchange when the isomerization was performed in the presence of an unsaturated ketone (1 equiv), different from that obtained by dehydrogenation of the starting allylic alcohol, supports a mechanism in which the isomerization takes place within the coordination sphere of the ruthenium catalyst.