Thermal dissociation of ions limits the degree of the gas‐phase H/D exchange at the atmospheric pressure

We present the application of the extended desolvating capillaries for increasing the degree of the gas‐phase hydrogen/deuterium exchange reaction at atmospheric pressure. The use of the extended capillaries results in the increase of the time that ions spend in the high pressure region, what leads to the significant improvement of the efficiency of the reaction. For the small protein ubiquitin, it was observed that for the same temperature, the number of exchanges increases with the decrease of the charge state so that the lowest charge state can exchange twice the number of hydrogen than the highest one. With the increase of the temperature, the difference decreases, and eventually, the number of exchanges equalizes for all charge states. The value of this temperature and the corresponding number of exchanges depend on the geometric parameters of the capillary. Further increase of the temperature leads to the thermal dissociation of the protein ion. The observed b/y fragments are identical to those produced by collision‐induced dissociation performed in the ion trap. Copyright © 2017 John Wiley & Sons, Ltd.     

Bioadhesive properties of a polyaminoacidic hydrogel: evaluation by ATR FT-IR spectroscopy

The bioadhesive properties of a novel chemical hydrogel based on a polymer of protein-like structure, have been investigated by using ATR FT-IR spectroscopy. In particular, the copolymer PHG obtained by partial derivatization of PHEA with GMA was chemically crosslinked by UV irradiation at 313 nm. Crosslinked PHG was treated with water to obtain a swelled sample, named PHG-UV gel, that was brought into contact with a phosphate buffer/citric acid solution at pH 7.0 in the absence or in the presence of mucin at various concentrations (0.01, 0.1 and 1 wt.-%). Preliminary dynamic swelling studies have evidenced the occurrence of an interaction between the PHG-UV gel and the glycoprotein. This result was confirmed by ATR FT-IR measurements. A diffusion model using a solution of Ficks' second law was employed to determine the diffusion coefficient of water into PHG-UV gel as a consequence of adsorption and/or interdiffusion which occur at the PHG-UV gel/mucin solution interface. Experimental results suggest a potential use of PHG-UV gel to prepare bioadhesive devices.     

Comparative study of spectroscopic properties of Er^3＋／Yb^3＋-codoped tellurite glass and fibres under 980nm excitation＊

A tellurite fibre of TeO_{2}－ZnO－La_{2}O_{3}－Li_{2}O glass codoped with 20000 ppm ytterbium and 5000 ppm erbium was fabricated by the suction casting and rod-in-tube technologies. The absorption spectrum of Er^{3+}/Yb^{3+} -codoped bulk glass has been measured. From the Judd－Ofelt intensity parameters, the spontaneous emission probability and radiative lifetime τ_{rad} of Er^{3+}:{}^{4}I_{13/2}→{}^{4}I_{15/2} transition for the bulk glass have been calculated. The emission fluorescence spectra and lifetimes around 1.5μm, and subsequent upconversion fluorescence in the range of 500－700nm were measured in fibres and compared with those in bulk glass. The changes in amplified spontaneous emission with fibre length and pumping power was also measured. It was found that the emission spectrum from erbium in fibres is almost twice as broad as the corresponding spectrum in bulk glass when pumped at 980nm.     

溶液中pH对蛋白质乳化能力影响的拉曼光谱研究

本工作采用 FT- Raman光谱仪对不同的 p H值的蛋白质水溶液多次扫描 ,采用酰胺 带的谱图作曲线拟合 ,并以子峰面积表征对应二级结构含量 ,得出二级结构的变化与蛋白质水溶液与乙酸丁酯混合后乳化能力变化的关系。结果表明 :蛋白质分子对 p H变化的敏感程度不一样。蛋白质分子结构的改变是引起蛋白质水溶液在有机溶液中乳化的一个重要因素     

High molar mass ethene/1‐olefin copolymers synthesized with acenaphthyl substituted metallocene catalysts

The influence of ligand structure on copolymerization properties of metallocene catalysts was elucidated with three C₁‐symmetric methylalumoxane (MAO) activated zirconocene dichlorides, ethylene(1‐(7, 9)‐diphenylcyclopenta‐[a]‐acenaphthadienyl‐2‐phenyl‐2‐cyclopentadienyl)ZrCl₂ ( 1 ), ethylene(1‐(7, 9)‐diphenylcyclopenta‐[a]‐acenaphthadienyl‐2‐phenyl‐2‐fluorenyl)ZrCl₂ ( 2 ), and ethylene(1‐(9)‐fluorenyl‐(R)1‐phenyl‐2‐(1‐indenyl)ZrCl2 ( 3 ). Polyethenes produced with 1 /MAO had considerable, ca. 10% amount of trans‐vinylene end groups, resulting from the chain end isomerization prior to the chain termination. When ethene was copolymerized with 1‐hexene or 1‐hexadecene using 1 /MAO, molar mass of the copolymers varied from high to moderate (531–116 kg/mol) depending on the comonomer feed. At 50% comonomer feed, ethene/1‐olefin copolymers with high hexene or hexadecene content (around 10%) were achievable. In the series of catalysts, polyethenes with highest molar mass, up to 985 kg/mol, were obtained with sterically most crowded 2 /MAO, but the catalyst was only moderately active to copolymerize higher olefins. Catalyst 3 /MAO produced polyethenes with extremely small amounts of trans‐vinylene end groups and relatively low molar mass 1‐hexene copolymers (from 157 to 38 kg/mol) with similar comonomer content as 1 . These results indicate that the catalyst structure, which favors chain end isomerization, is also capable to produce high molar mass 1‐olefin copolymers with high comonomer content. In addition, an exceptionally strong synergetic effect of the comonomer on the polymerization activity was observed with catalyst 3 /MAO. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 46: 373–382, 2008     

Effect of POSS on crystalline transitions and physical properties of polyamide 12

Polyamide 12/Trisilanolphenyl‐POSS (PA 12/POSS) composites were prepared via melt‐compounding. The effect of polyhedral oligomeric silsesquioxane (POSS) on crystalline structure and crystalline transition of PA 12 was investigated by wide‐angle X‐ray diffraction (WAXD) and real time fourier transform infrared spectroscopy (FTIR). WAXD results indicated that PA 12 crystallized into γ‐form as slowly cooling from melt and the presence of POSS did not influence the crystalline structure of PA 12. Both PA 12 and PA 12/POSS composites underwent Brill transitions when they were heated from room temperature to melt point. Real time FTIR patterns showed that an absorption band at 697 cm^?1 ascribed to Amide V (α) mode was emerged along with the disappearance of Amide VI (γ) band at 628 cm^?1 with the increase of the temperature for PA 12 and PA 12/POSS composites, which suggested that the γ‐form crystalline has transformed into α form. The Brill bands were identified and the transformed mechanism was discussed based on the real FTIR results. The addition of POSS enhanced the tensile strength and thermal stability of PA 12. © 2008 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 47: 121–129, 2009     

Role of Polyalanine Domains in β‐Sheet Formation in Spider Silk Block Copolymers

Genetically engineered spider silk‐like block copolymers were studied to determine the influence of polyalanine domain size on secondary structure. The role of polyalanine block distribution on β‐sheet formation was explored using FT‐IR and WAXS. The number of polyalanine blocks had a direct effect on the formation of crystalline β‐sheets, reflected in the change in crystallinity index as the blocks of polyalanines increased. WAXS analysis confirmed the crystalline nature of the sample with the largest number of polyalanine blocks. This approach provides a platform for further exploration of the role of specific amino acid chemistries in regulating the assembly of β‐sheet secondary structures, leading to options to regulate material properties through manipulation of this key component in spider silks.

     

Novel Method for Preparing NH4NiPO4·6H2O: Hydrogen Bonding Coacervate Selective Self-assembly

The single phase NH₄NiPO₄·6H₂O was synthesized by solid‐state reaction at room temperature using NiSO₄·6H₂O and (NH₄)₃PO₄·3H₂O as raw materials. The NH₄NiPO₄·6H₂O and its calcined products were characterized using X‐ray powder diffraction (XRD), thermogravimetry and differential thermal analyses (TG/DTA), Fourier transform IR (FT‐IR), ultraviolet‐visible (UV‐vis) absorption spectroscopy, and scanning electron microscopy (SEM). The results showed that the product dried at 80°C for 3 h was orthorhombic NH₄NiPO₄·6H₂O [space group Pmm2(25)], and surfactant polyethylene glycol (PEG)‐400 can direct growth of crystal NH₄NiPO₄·6H₂O. The thermal process of NH₄NiPO₄·6H₂O experienced three steps, which involve the dehydration of the five crystal water molecules at first, and then deamination, dehydration of the one crystal water, intramolecular dehydration of the protonated phosphate groups together, at last crystallization of Ni₂P₂O₇. The product of thermal decomposition at 150°C for 2 h, orthorhombic NH₄NiPO₄·H₂O, is layered compound with an interlayer distance of 0.8370 nm.     

STUDY OF THE COPRECIPITATED IRON/MANGANESE FISCHER-TROPSCH CATALYSTS

IntroductionInFTsynthesis,metalMnhasbeenregardedasanicepromotertoincreaselightolefinselectivity.Coprecipitationhasbeenusedextensivelyinthepreparationofcommercialcatalysts.AnumberofpublicationsdealingwiththerelationbetWcenphysical-chemistry'proPertiesofcatalystsandFTs}nthesishaveappeared,butdifferentcatal})stcompositionsandpreparationconditi0nsmakedifferentconclusions.Therearetu)omainrespects.0neisthatcarelystswithhighacivityandolefinselectivityhavedifferentMMieratiovaryingoverawiderange(Mn…