ZnO纳米线的电化学制备研究

High-quality ZnO nanowires have been synthesized at relatively low temperature via one-step electrochemical anodization technique. In this method, Zn sheet acted as the anode and Pb sheet served as the counter electrode, and the complex solution of HF-C₂H₅OH-H₂O was used as electrolyte. ZnO nanowires were characterized by Field Emission Scanning Electron Microscopy (FE-SEM), Transmission Electron Microscopy (TEM) and Selected Area Electron Diffraction (SAED) and X-ray Diffraction (XRD). The results show that the nanowires were wurtzite crystalline ZnO, and the ZnO nanowires with the diameters of 70 nm and 30～40 nm were obtained by adjusting preparation conditions, respectively.     

PbO2阳极在硫酸溶液中的析氧失活行为

采用热分解鄄电镀法制备了以Sb 掺杂SnO₂(Sb-SnO₂)为底层的Ti 基PbO₂阳极(Ti/PbO₂). 采用加速电解寿命测试、电化学阻抗谱、XRD、SEM-EDX 等技术, 研究了Ti/PbO₂阳极在硫酸溶液中的电解失效行为和机制.结果表明,在新制备的PbO₂镀层中, 由于氧空位的存在, PbO₂镀层的内应力表现为拉应力, 随着电解的进行, 阳极表面生成的活性氧原子在向基底扩散的过程中, 将Pb³⁺态氧化为Pb⁴⁺态, 逐渐占据镀层内作为自由电子施主的氧空位, 这不仅导致镀层的导电性能下降, 同时使镀层的应力逐渐由拉应力转变为压应力, 镀层性质逐渐劣化. 这一过程基本结束时,活性氧原子才大量扩散至Ti基底导致基底的钝化, 在Ti 基底和镀层界面出现显著的界面应力, 在界面应力和镀层内压应力的共同作用下, 阳极出现鼓泡、脱落, 迅速进入失活阶段.     

溴碘化银薄片乳剂颗粒中碘离子分布对潜影分散的影响

碘溴化银乳剂薄片颗粒的潜影分散与碘离子在颗粒中的分布有关。本文用交叉光楔曝光技术测定了由次潜影造成的潜影分散,并根据所测出的潜影分散度和乳剂的表面感光度,对内、表敏的分布作了分析。结果表明,碘离子分布在颗粒边缘的乳剂,其表面潜影分散度要比碘离子均匀分布的颗粒更甚,后者且表现出内、表敏度竞争的现象。     

AFM电化学阳极氧化制备二氧化钛纳米线

当材料的微观尺度进入纳米量级后，由于量子效应，材料常常会显现出特殊的性能。因此近年来制备量子点、量子线，以及具有量子效应的量子器件受到深入的研究。一些新的纳米尺度加工技术如原子力显微镜(AFM)微细加工技术受到研究者的重视。     

LiCl—KCl熔盐中锂在铝电极上的电极过程

采用线性扫描伏安法和电位阶跃法，研究了锂离子在铝电极上的电极过程机理，结果表明锂离子在铝电极上沉积形成α－固熔体时，电极过程受锂原子向铝电极中的扩散速度控制，当形成β－锂铝合地，存在成核极化现象，成核过程为瞬间成核过程，初期电极过程受形成β－锂铝合金的速度控制，一定时间后受锂原子通过β－锂铝合金层的扩散速度控制，β－锂铝合金阳极有限限充电电压和极限电流。     

熔融碳酸盐燃料电池阳极材料表面改性

选择铌作为合金化元素，通过氟化物熔盐电化学表面合金化的方法对熔融碳酸盐燃料电池阳极材料镍进行表面改性，改性后的阳极材料的耐蚀性能与电催化性能均得到明显的改善。     

二甲醚电氧化及其阳极催化剂研究

Anode electro-catalysts for direct dimethyl-ether fuel cell (DDFC), Pt/C, PtRu/C (1∶1) and PtSn/C (3∶2), were prepared by chemical impregnation-reduction method with formaldehyde as the reductant. DME electro-oxidation and adsorption at Pt electrode and Pt electro-catalysts were investigated by Cyclic Voltammetry(CV), Quasi-steady state polarization and Gas Chromatography(GC). CV showed that there were two current peaks of DME electro-oxidation at Pt electrode around 0.8V (vs RHE); DME was adsorbed at Pt electrode more weakly and slowly than oxygen, methanol, even hydrogen; the onset potential of DME oxidation was 50mV less than that of methanol, and DME peak potential 110 mV lower, thus more advantageous for using in fuel cells than methanol. GC showed that small amount of HCHO was generated during DME electro-oxidation. The mechanism of DME electro-oxidation was proposed. Among the three electro-catalysts (Pt/C, PtRu/C and PtSn/C), Pt alloy catalysts, especially PtRu/C, showed a higher performance toward DME electro-oxidation, as in the case of methanol. Temperature experiments showed that both DME electro-oxidation and adsorption on Pt and Pt alloy catalysts were favored with increased temperature.     

Preparation and Properties of Doped Lanthanum Gallate Film on a Ni/SDC Porous Anode Support

IntroductionIn intermediate-temperature solid oxide fuel cells(SOFCs),doped ceria with a fluorite structure anddoped lanthanum gallate(LSGM)with a perovskitestructure are commonly used as electrolyte materials.However,the former easily exhibits an electro…     

利用钐掺杂氧化铈提高燃料电池阳极活性

用浸渍法制备并采用交流阻抗、极化等技术考察了不同组成的Ni-Sm3＋掺杂的CeO2(SDC) 复合镍阳极的电化学性能及相应电池的功率输出性能.结果表明，SDC掺入镍阳极后,阳极极化过电位及电池的欧姆电阻显著减小.其中阳极过电位的减小与SDC掺入镍电极引起的三相界扩展有关，但SDC的掺入同时引起了电极反应活化能的增加,造成低温下Ni-SDC的极化过电位大于纯Ni电极.高温下,Ni-SDC阳极的阻抗谱由两个半圆组成，其中高频半圆随着SDC掺入量的增加而减小,而低频环与SDC的掺入量基本无关.低温下只观察到一个高频环.高频环可能对应三相界反应,而低频环可能对应氢的解离吸附及扩散.75％（w）Ni-25％（w）SDC/La0.9Sr0.1Ga0.8Mg0.2O3(LSGM)/Sm0.5Sr0.5CoO3(SSC)在所研究的电池中具有最大功率输出密度，其值在1073、973、873 K下分别达到1.1、0.43、0.14 W•cm－2.     

硫酸介质中Ti／SnO2／PbO2析氧阳极的研究

由于硫酸溶液具有高的电导、一般条件下性质稳定、价格相对低廉等优点，所以电化学合成大多在硫酸溶液中进行．阳极析氧是电化学合成不可避免的阳极过程．但因硫酸的强腐蚀性，以及从阳极析出的氧的强氧化性，使得能满足工业生产的阳极材料很缺乏．自１９５０年荷兰Ｈｅｎ...