Kerr介质中相干态光场与耦合Λ型三能级原子作用原子信息熵的性质

利用全量子理论研究了相干态光场与耦合全同Λ型三能级原子相互作用过程中原子信息熵的演化特性.讨论了系统初始状态、失谐量和原子间偶极相互作用强度及克尔系数对原子信息熵演化特性的影响.数值计算结果表明:原子信息熵的性质主要决定于原子初态和场的平均光子数的大小.失谐量、原子间的耦合常数和克尔系数对原子信息熵的演化规律也有明显的影响.     

Kerr介质中耦合V型三能级原子与相干态光场作用场的量子性质

研究了Kerr介质中相干态光场与耦合V型三能级原子相互作用过程中场的量子性质.利用量子光学中光场与原子相互作用的耦合Tavis-Cummings模型,对系统的动力学过程进行了求解.讨论了系统初始状态、失谐量、原子间偶极相互作用强度及Kerr系数对光场量子性质随时间演化的影响.数值计算结果表明:初态中场的平均光子数比较小...     

多波段紫外太瓦级CPA系统

基于啁啾脉冲放大(CPA)技术和频率变换技术,构建了一个多波长紫外太瓦量级CPA系统.该系统实现了5种频率的精确同步,可同时输出1 Hz,5 Hz和10 Hz的高能量多波段紫外脉冲.时间抖动小于3 ns的时间同步系统和能量不稳定性小于0.5%rms的kHz预放大系统保证了CPA系统输出的能量不稳定性小于2%rms.最后,通过共线相位匹配方案,得到了64 mJ/400 nm,16 mJ/267 nm和5 mJ/205 nm紫外脉冲输出,对应峰值功率达到太瓦量级. 关键词： 啁啾脉冲放大 光学频率变换 紫外脉冲     

Rb原子磁光阱中囚禁原子数目与实验参数的依赖关系

研究表明，Rb原子磁光阱中所囚禁的原子数目对囚禁光的光强和失谐量，回泵光的强度以及磁场梯度有很大的依赖关系.用二能级系统模型对囚禁原子数目随囚禁光的光强和失谐量的变化关系进行了预估，理论预测的结果与实验结果定性符合.实验结果也展示了囚禁原子数目随回泵光的强度和磁场梯度的变化关系，要定量解释这些实验结果则需要更复杂的理论模型.通过囚禁原子数目对实验参数依赖关系的研究，得到特定的实验参数，来获得最大数目的冷原子. 关键词： 磁光阱 冷原子     

La2/3Ca1/3MnOz薄膜的巨磁电阻效应及其温度关系的研究 *

在室温至液氦温区内,对良好(100)择优取向的La_2/3Ca_1/3MnO_z薄膜的磁电阻作了实验研究.发现零场下未退火样品的电阻约在T_p=72K处出现一峰值,当外加磁场后,其电阻降低,而峰值所对应的温度T_p要往高温方向移动,然而其磁电阻变化值MR=δR/R_H=(R₀-R_H)R_H的极大值却发生在25K附近,而且该值基本上不随外磁场的大小而改变.当样品在700℃t氧气中退火30min后,零场下电阻峰值往高温方向移动到230K附近,表明薄膜的Curie温度升高了.     

Efficient implementation of x-ray ghost imaging based on a modified compressive sensing algorithm

Towards efficient implementation of x-ray ghost imaging (XGI), efficient data acquisition and fast image reconstruction together with high image quality are preferred. In view of radiation dose resulted from the incident x-rays, fewer measurements with sufficient signal-to-noise ratio (SNR) are always anticipated. Available methods based on linear and compressive sensing algorithms cannot meet all the requirements simultaneously. In this paper, a method based on a modified compressive sensing algorithm with conjugate gradient descent method (CGDGI) is developed to solve the problems encountered in available XGI methods. Simulation and experiments demonstrate the practicability of CGDGI-based method for the efficient implementation of XGI. The image reconstruction time of sub-second implicates that the proposed method has the potential for real-time XGI.     

Temporal behaviour of open-circuit photovoltaic solitons

Based on the time-dependent band-transport model in a photorefractive medium, dark open-circuit photovoltaic (PV) solitons are investigated both theoretically and experimentally. Compared with those of the time-independent models, our theoretical results revealed that quasi-steady-state and steady-state PV solitons can both be obtained. Our results also revealed that when r < 1 (r is the normalized intensity at infinity), the full width at half maximum (FWHM) of solitons decreases monotonically to a constant value; when r > 1, however, the FWHM of solitons first decreases to a minimum before it increases to a constant value. Moreover, the FWHM of steady solitons decreases with increasing intensity ratio for r < 1, and increases with increasing intensity ratio for r > 1. We further observed dark PV solitons in experiments, and recorded their evolution. These results indicated that steady solitons can be observed at low optical power, while quasi-steady-state solitons can only be generated at higher optical power. Good agreement is found between theory and experiment.     

Incoherently coupled soliton pairs in nonlocal nonlinear media

We show that incoherently coupled soliton pairs can exist in nonlocal Kerr-type nonlinear media. Such solitons can propagate in bright--bright, dark--dark, and gray--gray configurations. When the nonlocal nonlinearity is absent, these bright--bright and dark--dark soliton pairs are those observed previously in local Kerr-type nonlinear media. Our analysis indicates that for a self-focusing nonlinearity the intensity full width half maximum (FWHM) of the bright--bright pair components increases with the degree of nonlocality of the nonlinear response, whereas for a self-defocusing nonlinearity the intensity FWHM of the dark--dark and gray--gray pair components decreases with the increase in the degree of nonlocality of the nonlinear response. The stability of these soliton pairs has been investigated numerically and it has been found that they are stable.     

软骨组织工程构建中的生物力学

关节软骨是关节表面具有弹性的承重组织, 其结构复杂, 由固体相和液体相组成. 固体相包括胶原纤维、蛋白多糖等, 属纤维增强型复合结构; 液体相包括水、电解质等.关节软骨提供了一个低磨损和低摩擦的光滑界面, 起缓冲振动和传递载荷等支撑作用. 由于膝关节承受的运动量大、应力高, 关节软骨损伤在临床上较为常见. 但软骨内没有血管, 代谢缓慢, 其损伤后难以实现自我修复. 组织工程从理论上建立了一种治疗软骨缺损的理想方法, 但尚未成为临床上常规的治疗选择. 如何获得结构和功能相匹配, 同时适用于临床治疗的工程软骨, 至今仍是亟需解决的问题.在体外构建功能化工程软骨, 关键在于运用生物反应器对组织施加合适的力学载荷: 首先保证工程软骨复合体内信号分子、营养和废物的有效运输; 其次对支架内种子细胞产生特定的力学刺激; 同时促进细胞外基质结构与功能的适应性发展.本文对力学载荷在软骨组织工程构建中的应用进展加以综述: 按照作用于组织层面的力学载荷传递所需的介质属性, 将其分为液体介导、固体介导和其他媒质介导三种类型, 重点关注不同载荷对工程软骨功能化构建的作用和效果; 分析讨论软骨组织工程构建中存在的关键生物力学问题; 总结和展望软骨组织工程未来的发展趋势.软骨组织工程体外培养需要考虑力学载荷和生化刺激的耦合作用; 在合适的生化条件下进行滚动、滑动和压缩复合加载, 将有利于工程软骨的体外功能化构建.      

标准样品修正-X射线荧光光谱法测定碲铋矿石中碲和铋的含量

作为重要的"三稀"矿产资源,碲在半导体制冷、特种合金、薄膜太阳能电池等领域有着不可替代的作用[1],四川石棉大水沟碲铋硫铁矿是迄今为止有报道的唯一碲原生独立矿床[2]。然而,由于此类矿床的稀缺性,相关分析方法研究尚少[2-3],当前对岩矿、化工样品中高含量碲的测定或采用重量法(YS/T 1227.1-2018《粗碲化学分析方法第1部分:碲量的测定重量法》)或酸溶后稀释测定,铋则采用容量法(GB/T 15926-2010《铋矿石化学分析方法铋量测定》),前处理方法难以统一,影响分析效率。