POROSITY CALCULATION OFMIXTURES OF FIBROUS PARTICLES

The initial forming of fiber blend to high green density, i.e. the packing of fibrous particles, is important to the reinforcement of composite materials. It is very useful to develop a general predictive method for the optimum selection of particle mixtures for the property control of ceramic or composite products. This paper presents such a mathematical model developed on the basis of the similarity analysis between the spherical and non-spherical particle packings and assesses its applicability to the packing of fibrous particles with discrete and/or continuous length distributions. The results indicate that the model can predict this packing system well and hence provide an effective way to solve various packing problems in the composite materials processing.     

多孔硅制备过程中B,P杂质原子的作用

采用DV-Xα方法对多孔硅形成过程中位于表层的B和P杂质原子的作用进行研究,结果表明位于顶层硅原子层中的B和P杂质原子均可削弱其邻近的Si-Si键强度,因而可能导致出现腐蚀的突破点,再通过分析杂质对表面区势场的改变,可以认为位于顶层硅原子层中的B杂质原子产生腐蚀的突破点的可能性更大。 关键词：     

规则结构多孔填料塔两相流动特性实验研究

本文以空气和水为工质,对规则结构多孔填料塔的气-液逆向流动特性进行了可视化实验,研究了填料塔内气一液两相流动规律.实验结果表明:当液体流量一定时,随着气体流量的增加,压力损失增大;当气体流量一定时,随着液体流量的增加,气相压力损失增加.根据实验结果提出了采用水力雷诺数、韦伯数和无量纲流动参数的填料塔内气-液两相流动阻力系数实验关联式.     

Field Emission from Silicon Nanocrystallite Films with Compact Alignment and Uniform Orientation

Patterned silicon nanocrystallite (SINC) films were fabricated on (100) orientation p-type boron-doped sificon wafer by the hydrogen ion implantation technique and the anodic etching method. The efficient field emission with low turn-on field of about 3.5V/μm at current density of 0.1μA/cm^2 was obtained. The emission current density from the SiNC films reached 1mA/cm^2 under a bias field of about 9.1V/μm. The experimental results demonstrate that there are great potential applications of the SiNC films for fiat panel displays. A surface treatment with hydrogen plasma was performed on the SiNC films and a significant improvement of emission properties was achieved.     

Lattice Boltzmann方法模拟多孔介质Klinkenberg效应

格子Boltzmann数值模拟方法是研究复杂的多孔介质结构特别是Klinkenberg效应的有效方法之一，对处理复杂边值问题尤其有效，用格子Boltzmann方法研究了气流穿越多孔介质问题，并将数值计算结果与实验结果进行了比较，结果表明格子Boltzmann方法是数值模拟气流穿越多孔介质问题的有效方法之一。     

Effect of Alumina and Chromium Interlayers on Microstructures and Optical Properties of Thin Ag Films on Glass Substrates

Effects of alumina and chromium interlayers on the microstructure and optical properties of thin Ag films are investigated by using spectrophotometry, x-ray diffraction and AFM. The characteristics of Ag films in Ag/glass, Ag/l2O3/glass and Ag/Cr/glass stacks are analysed. The results indicate that the insertion of an Al2O3 or Cr layer decreases the grains and influences the reflectance of Ag films. The reflectance of the Ag film can be increased by controlling the thickness of alumina interlayer. The stability of Ag films is improved and the adhesion of Ag films on glass substrates is enhanced by alumina as an interlayer.     

�����װ�õĻԹ�ŵ�����

在四阳极直流放电装置上,测量并分析了辉光放电的电流-电压和发光特征随气压的变化关系。结果表明,采用稳流放电模式比稳压放电具有更宽的稳定放电气压和电流范围,能在从1～800Pa的较宽气压范围内实现氦气辉光放电,放电电流可达到500mA左右。随着电极表面亮斑的变化,对于同一气压,在低电流区,放电电压几乎成指数增长;随电流增大,电压的增长速度变缓;对于高的气压,碰撞频率的增大使得电压随电流升高的速率变小。分析表明,放电处于异常辉光区。从放电管的CCD图像可以看出,对于同一放电电流,随气压的升高,等离子体往阴极收缩。     

焚烧炉中多孔介质状垃圾团块传热分析

以焚烧炉中垃圾团块的传热问题为背景,研究含高水分的多孔介质在高温环境下的传热规律。气、固相处于非热平衡态,分别列出其能量方程,且能量方程中考虑辐射项。从描述多孔介质传热的质点方程出发,采用局部容积平均法导出平均化方程,根据经验修正方程中的系数,并列出适当的初始条件和边界条件,用数值计算方法求出垃圾团块中气、固两相的温度场。     

微波消解-原子吸收法测定氧化铝为载体的钯催化剂中钯

报道了微波消解-AAS法测定氧化铝为载体的钯催化剂中钯的新方法,试验了微波消解溶样条件（溶解试剂、压力、时间和功率等）,研究了测定介质的影响,通过在样品测定液中加入铝基体至铝浓度为4 mg/mL,消除了铝对钯测定的干扰.该法测定结果与光度法的结果一致,相对标准偏差小于1.5%（n=5）.     

Experimental Study of Capillary Effect in Porous Silicon Using Micro-Raman Spectroscopy and X-Ray Diffraction

We investigate the capillary effect and the residual stress evolution in the wetting, drying and rewetting stages of porous silicon using x-ray diffraction and micro-Raman spectroscopy. A reversible capillary effect and an irreversible oxidation effect are the driving forces for the residual stress evolution. The lattice expansion of the porous-silicon layer is observed to decrease slightly by x-ray diffraction and the tensile residual stress increases rapidly by micro-Raman spectroscopy, with the change of about 82 MPa for the oxidation effect and the change of 2.78 GPa (enough for cracking) for the capillary effect. Therefore, the capillary effect plays a major role in the residual stress evolution in the stages. A simple microscopic liquid-bridge model is introduced to explain the capillary effect and its reversibility. The capillary emergence has a close relation with a great deal of the micro-pore structure of porous silicon.