Carbon–epoxy composites based on fibers coated with nylon 6,6: hygrothermal ageing versus interlaminar shear strength

Carbon fibers were coated in situ with a thin film of polyhexamethylene adipamide by an interfacial polycondensation technique. The modified fibers were used for the preparation of epoxy-based unidirectional composites. Specimens of these materials were immersed in water until equilibrium conditions were attained. The weight gain at equilibrium was determined as a function of the immersion temperature, the fiber volume fraction and the polyamide content deposited on the fibers. Water penetration in specimens made with uncoated carbon fibers increases when the volume fraction decreases. Introduction of the polyamide interlayer initially increases the water absorption, but reduces it at higher immersion temperatures and/or higher polyamide contents. The treated specimens were subjected to the short beam test to determine the interlaminar shear strength (ILSS). The data show that the ILSS decreases with water penetration but increases when the immersion temperature increases from 40 to 70°C. The overall performance encountered is discussed in terms of the possible roles of the polyamide interphase while taking into account mechanisms concerned with matrix plasticization, interphase degradation and residual stress relaxation.     

High sensitivity CW-cavity ring down spectroscopy of water in the region of the 1.5 μm atmospheric window

The absorption spectrum of natural water vapour around 1.5 μm has been recorded with a typical sensitivity of 5 × 10⁻¹⁰ cm⁻¹ by using a CW-cavity ring down spectroscopy set up based on fibred DFB lasers. A series of 31 DFB lasers has allowed a full coverage of the 6130.8-6748.5 cm⁻¹ (1.63-1.48 μm) region corresponding to the H transparency band of the atmosphere. The line parameters (wavenumber and intensity) of a total of 5190 lines, including 4247 lines of water vapor, were derived by a one by one fit of the lines to a Voigt profile. Different isotopologues of water (H₂¹⁶O, H₂¹⁸O, H₂¹⁷O, and HD¹⁶O) present in natural abundance in the sample contribute to the spectrum. For the main isotopologue, H₂¹⁶O, 2130 lines were measured with line intensities as weak as 10⁻²⁹ cm/molecule while only 926 lines (including a proportion of 30% inaccurate calculated lines) with a minimum intensity of 3 × 10⁻²⁷ cm/molecule are provided by the HITRAN and GEISA databases. Our comparison in the whole 5750-7965 cm⁻¹ region, has also evidenced that an error in the process of conversion of the intensity units from cm⁻²/atm to cm⁻¹/(molecule × cm⁻²) at 296 K, has led to H₂¹⁶O line intensities values listed in the HITRAN-2000 database, systematically 8 % below the original FTS values. The rovibrational assignment was performed on the basis of the ab initio calculations by Schwenke and Partridge with a subsequent refinement and validation using the Ritz combination principle together with all previously measured water transitions relevant to this study. This procedure allowed determining 172, 139, 71, and 115 new energy levels for the H₂¹⁶O, H₂¹⁸O, H₂¹⁷O, and HD¹⁶O isotopologues, respectively. The results are compared with the available databases and discussed in regard of previous investigations by Fourier transform spectroscopy. The spectrum analysis has showed that most of the transitions which cannot be assigned to water are very weak and are due to impurities such as carbon dioxide and ammonia, leaving only about 3% of the observed transitions unassigned. The interest of a detailed knowledge of water absorption for trace detectors developed in the 1.5 μm range is underlined: for instance HDO contributes significantly to the considered spectrum while no HDO line parameters are provided by the HITRAN database.     

Water wave radiation by a sphere submerged in water with an ice-cover

Using the multipoles method, we formulate the problems of radiation (both heave and sway) of water waves by a submerged sphere in deep as well as in uniform finite depth water with an ice-cover, with the ice-cover being modelled as an elastic plate of very small thickness. In each case this leads to an infinite system of linear equations which are solved numerically by standard techniques. The added-mass and damping coefficients for a heaving and swaying sphere are obtained and depicted graphically against the wave number for various values of the radius of the submerged sphere and flexural rigidity of the ice-cover to show the effect of the presence of ice-cover on these quantities. When the flexural rigidity is taken to be zero, the numerical results for the added-mass and damping coefficient for water with a free surface are recovered.     

An enantioselective Michael addition of malonate to nitroalkenes catalyzed by low loading demethylquinine salts in water

An enantioselective Michael addition of malonate to nitroalkenes is efficiently catalyzed by low loading demethylquinine salts in water; the yield range from 49% to 93% and the ee up to 90%.     

PARTIAL VERSUS GENERAL STORAGE POLICY: COMMODITIES AND RESOURCES

This paper examines joint storage considerations when both commodities and resources can be stored, e.g., grain and water for irrigation. Results suggest that when separate agencies control public resource and commodity storage, suboptimal storage rules occur unless (i) each agency is sensitive to the policies of the other, (ii) commodity inventories are adjusted in response to prices, and (iii) resource inventories are adjusted in response to both commodity demand and resource supply conditions. For example, the common case where water storage depends on weather and reservoir conditions alone is not sufficiently general. The results imply that water management agencies that tend to be dominated by engineers and hydrological considerations need to incorporate economic considerations into decision processes.     

Three-dimensional structure of the calcite-water interface by surface X-ray scattering

The three-dimensional structure of the calcite (104)-water interface has been determined with surface X-ray scattering. Nine crystal truncation rods (including specular and non-specular rods) were measured providing both vertical and lateral sensitivity to the interfacial structure. The results reveal that calcite is nearly ideally terminated with a single surface hydration layer that includes two inequivalent water molecules having distinct heights of 2.3 ± 0.1 and 3.5 ± 0.2 Å, each with a well-defined lateral registry with respect to the calcite surface. No additional layering of water is observed beyond this surface hydration layer. Small displacements in the outer two calcium carbonate layers were also observed. These results are compared with previous experimental and computational results.     

Potential-dependent structure of the interfacial water on the gold electrode

Doubly tunable sum frequency generation (SFG) spectra demonstrate that the water molecules at gold/electrolyte interface change their orientation with applied potential. At negative potentials, water molecules in the double layer align with their oxygen atom pointing to the solution. As potential became positive to be close to the potential of zero charge (PZC), the SFG signal decreased, suggesting the OH groups of the water molecule are either in random orientation or parallel to the electrode. As potential became more positive than the PZC, the SFG signal increased again with the oxygen-up orientation as same as in the negative potential region, indicating that water molecules interact with the adsorbed sulfate anions. The peak position of the SFG spectra indicates a relatively disordered state of water molecules at the gold electrode surface, in contrast to the previously observed ice-like structure of water at electrolyte/oxide interfaces.     

Automated derivatization for on-line solid-phase extraction-gas chromatography; phenolic compounds

An automated system for derivaatization was coupled on-line with solid-phase extraction-gas-chromatography (SPE-GC). The system was optimized for the determination of phenol and chlorinated phenols in aqueous samples. The test analytes were acetylated with acetic anhydride; proper buffering of the sample was a critical factor. Next, the phenol acetates were enriched on a SPE cartridge and transferred to a GC; two appraoaches were studied. In the first approach, the derivatives were enriched on disposable C18 cartridges (ASPEC type) and desorbed with methylacetate. Aan aliquot of the final eluate was injected on-line the GC by means of a loop-type interface. In the second approach, trace enrichment was performed on 10 × 2 mm i.d. LC-type precolumn packed with polystyrenedivinylbenzene copolymer (PLRP-S) this precolumn was dried with a mitrogen purge and the phenol acetates were desorbed with ethyl acetate which was injectedon-line into the retention gap of the GC under partially concurrent solvent evaporation (PCSE) conditions. The Derivatization-SPE-GC system which was based on the loop-type interface has the advantage of simplicity and easy operation, the main drawback is the impossibility to determine phenol acetates which elute prior to trichlorophenol acetates. With the derivatization-SPE-GC approach using PCSE-based desorption, even the most volatile analyte of the test series, phenol acetate, can be determined successfully. The entire procedure, including the derivatization step, was fully automated and integrated in one set-up. The precision data for the integrated on-line derivatization-SP-FID system were fully satisfactory, with RSD values of 1–12 % at the 1 μg/1 level. When a sample volume of 2.2 ml was analyzed, The detection limits for the chlorinated phenol acetates were in the 0.1–0.3 μg/1 range.     

Determination of anions in rainwater by capillary electrophoresis with conductivity detection

A routine method for the determination of chloride, nitrate and sulfate anions in rainwater by capillary electrophoresis was developed. The system uses an end-column non-suppressed conductivity detector. Linear calibration plots were generated from 0.050 to 20 mg/l, which is the range generally found in wet depositions. Accuracy and precision were evaluated by analyzing certified standards of simulated rainwater and environmental samples, or by comparing CE results with those obtained by IC, the reference technique for anion analysis in wet deposition. The reproducibility of the method was satisfactory except at the lower and upper limits of the analytical range. Sensitivity lay in the range of few μg/l.