Stabilization of flow boiling in a micro tube with air injection

Air injection as a stabilization method is evaluated for flow boiling in a micro tube. Pyrex glass tube coated by ITO film is employed as a test tube for flow visualization with water as a working fluid. Air bubble and liquid slug lengths are controlled by changing air and liquid mass velocities. Wall temperatures and inlet/outlet pressures show very large fluctuations during flow boiling without air injection. Severe reverse flow is also observed from flow visualization. On the other hand, wall temperature and inlet/outlet pressures as well as visualized flow patterns become very stable with air injection. In addition, much higher heat transfer coefficients are obtained for air injected cases. It is observed from the flow visualization that the flow becomes much stable and shows regular patterns.     

The boundary condition at the air–liquid interface and its effect on film drainage between colliding bubbles

The drainage of thin liquid films between colliding bubbles is strongly influenced by the boundary conditions at the air–liquid interface. Theoretically, the interface should not resist any tangential stress (fully mobile) in a clean water system, resulting in very fast film drainage and coalescence between bubbles within milliseconds. In reality, under most experimental and industrial conditions, the presence of impurities or surfactants can immobilize the interface and significantly hinder bubble coalescence by several orders of magnitude. In this opinion, we introduce the recent progress on understanding the boundary conditions at the air–water interface, and how they may affect the outcome of bubble collisions. The transition from mobile to immobile boundary conditions in the presence of contaminations is discussed. Despite the considerable recent progress, there are still experimental and theoretical challenges remaining on this topic, for example, finding the mechanism for hindered bubble coalescence by high salt concentrations.     

Visible-light-initiated malic acid-promoted cascade coupling/cyclization of aromatic amines and KSCN to 2-aminobenzothiazoles without photocatalyst

By using ambient air as the oxidant and malic acid as the promoter, a practical method for the preparation of 2-aminobenzothiazoles through visible-light-initiated cascade reaction of aromatic amines and KSCN in eco-friendly bis(methoxypropy)ether under metal-, hazardous additive-, photocatalyst-free conditions was established.     

An overview of emerging pollutants in air: Method of analysis and potential public health concern from human environmental exposure

Air pollutants are perhaps the largest cause of diseases and death in the world today. Increasing urbanization and industrialization have caused an increase in number of diverse forms and types of new pollutants, which are difficult to detect and characterize due to their stench behaviour and complex sources of production. Such pollutants have been called emerging pollutants (EPs) and their list is ever increasing. Therefore, the understanding of the method of analysis and health implication of (EPs) in air is critical to providing a more robust understanding of exposure routes, regulations and mitigation. EPs in air discussed in this study are not in any way exhaustive but limited to emerging VOCs (including acrylonitrile, 1−3-butadiene, chloroform, dichloromethane, ethylene oxides, formaldehyde, toluene, trichloroethylene, 1,4-Dioxane) and metals (arsenic, manganese, and vanadium), ultrafine particles, micro- and nano- plastics, engineered nanoparticles, diesel/black carbon and bioaerosols. Occurrence, detection and health implications of these EPs in air are still unfolding due to limited monitoring studies, lack of standard methodology and regulations. To address this knowledge gap, authors conducted an in-depth review of available information. Their spatial distribution, analytical methods and health implications are discussed including the novel coronavirus (COVID-19) as a potential EP in air. The study concluded with highlights of gaps in knowledge and suggestions to key areas for future research. This information is of general interest to environmental scientists and of specific interest to both health and sanitation workers and policymakers at private, government and international organizations.     

单壁碳纳米管上毒性苯气体净化的分子模拟(英文)

采用巨正则系综蒙特卡罗(GCMC)方法研究了空气中微量苯组分在单臂碳纳米管(SWNTs)上的吸附净化.模拟表明,具有较大孔径的(20,20)纳米管比较适合吸附纯苯蒸汽,而对于移除空气中的毒性苯物质,苯的吸附选择性分别在(12,12)纳米管及4.0 MPa时和(18,18)纳米管及0.1 MPa时出现最小值和最大值.为了解释这一异常行为,我们进一步分析了N2-O2-C6H6混合物的局部密度分布、吸附分子构型和概率密度分布,发现(18,18)纳米管内外完全被苯分子占据,而对于(12,12)纳米管,由于存在更强的吸附质-吸附剂相互作用,空气分子更倾向于吸附在管与管之间的间隙.此外,吸附分子的空间有序参数表明大多数苯分子采取"平躺"在纳米管表面的定位,而线性的N2和O2分子则多数平行于孔轴方向.最后研究了温度和苯分子主体相浓度对分离效果的影响.我们发现较大孔中的选择性随着温度的增加比小孔下降更加明显.与此对比,主体相苯浓度对小孔中的选择性起到更加重要的作用.     

毛细管气相色谱法测定工作场所空气中3种多环芳烃

采用毛细管气相色谱法测定工作场所空气中3种多环芳烃(萘、萘烷和四氢化萘)的含量。样品采用活性炭管采集,二硫化碳解吸20min,用DB-FFAP毛细管气相色谱柱分离,火焰离子检测器检测。3种多环芳烃在一定的质量浓度范围内与其峰面积呈线性关系,方法的检出限(3S/N)在0.05~0.5 mg·L-1之间。以空白样品为基体进行加标回收试验,所得回收率在89.3%~97.5%之间,测定值的相对标准偏差(n=6)在2.2%~5.4%之间。     

Vanadium-catalyzed green oxidation of benzylic alcohols in water under air atmosphere

The oxidation of alcohols using catalytic amounts of metal complexes is highly attractive from the viewpoint of green chemistry principles. However, examples of metal complex-catalyzed oxidations of alcohols with O₂ using water as the solvent are still rare, and precious metals, high-pressure O₂ or air, and a stoichiometric amount of base are often required. In this study, it was found that an oxovanadium-4,4′-t-Bubpy (4,4′-di-tert-butyl-2,2′-bipyridyl) complex exhibited high catalytic activity in the oxidation of benzhydrols under an atmosphere of O₂ in water as the sole solvent. Interestingly, this catalytic oxidation method could be applied to the gram-scale aerobic oxidation of alcohols in water under the atmosphere.     

Development of a versatile,easy and rapid atmospheric monitor for benzene,toluene, ethylbenzene and xylenes determination in air

A new procedure for the passive sampling in air of benzene, toluene, ethylbenzene and xylene isomers (BTEX) is proposed. A low-density polyethylene layflat tube filled with a mixture of solid phases provided a high versatility tool for the sampling of volatile compounds from air. Several solid phases were assayed in order to increase the BTEX absorption in the sampler and a mixture of florisil and activated carbon provided the best results. Direct head-space-gas chromatography–mass spectrometry (HS-GC–MS) measurement of the whole deployed sampler was employed for a fast determination of BTEX. Absorption isotherms were used to develop simple mathematical models for the estimation of BTEX time-weighted average concentrations in air. The proposed samplers were used to determine BTEX in indoor air environments and results were compared with those found using two reference methodologies: triolein-containing semipermeable membrane devices (SPMDs) and diffusive Radiello samplers. In short, the developed sampling system and analytical strategy provides a versatile, easy and rapid atmospheric monitor (VERAM).     

Bioaerosols chemometric characterization by laser-induced fluorescence: Air sample analysis

A laser-induced fluorescence (LIF) system was optimized using a solution of Micrococcus luteus in ethanol/water 50% (v/v) to obtain spectra in the gas phase of 46 bioaerosols. Experimental designs such as Plackett-Burman and factorial design were applied. The fluorescence spectra were treated chemometrically by principal component analysis, linear discriminant analysis and hierarchical cluster analysis to classify the microorganisms according to family, morphology and gram. The best results were obtained using LDA. The method was applied to air samples and the LIF results allowed to characterize bioaerosols reliability. The robustness of the technique was demonstrated by the identification of many bacteria.     

Eco-friendly and facile synthesis of 2-substituted-1H-imidazo[4,5-b]pyridine in aqueous medium by air oxidation

We report a new environmentally-benign, convenient, and facile methodology for the synthesis of 2-substituted-1H-imidazo[4,5-b]pyridine. The reaction of 2,3-diaminopyridine with substituted aryl aldehydes in water under thermal conditions without the use of any oxidative reagent has been studied. The reaction has yielded 1H-imidazo[4,5-b]pyridine derivatives by an air oxidative cyclocondensation reaction in one step in an excellent yield. Furthermore, a series of compounds were synthesized and characterized by melting point, EI-MS, NMR, and IR tools. For comparison, the reference samples were prepared by the reported method. Utilization of aqueous medium, easy reaction conditions, isolation, and purification make this manipulation very interesting from an economic and environmental perspective.