多种类表面活性剂临界胶束浓度定量构效关系

表面活性剂的临界胶束浓度(CMC)是个非常重要的物质特性参数, CMC在研究表面活性剂的工业应用和生物利用方面发挥着关键作用. 本工作提出了一个新的拓扑指数—扩展距离矩阵, 建立了一个稳定的构效关系模型, 并对175种表面活性剂的临界胶束浓度进行了计算预测. 结果表明, 基于新的拓扑指数建立的构效关系模型计算临界胶束浓度能给出稳定可靠的预测结果, 其预测结果相关性系数R²(training set)=0.9295, 相对标准偏差ARD(training set)=8.20%, R²(testing set)=0.9257, ARD(testing set)=6.76%. 与文献中模型预测结果的对比表明, 本工作在稳定性和可靠性上均有显著改善.     

大型砂尘风洞中砂尘浓度测量与控制方法的研究

砂尘浓度指标严重影响砂尘风洞试验效果;在大型砂尘风洞中准确的测量及有效的控制砂尘浓度是砂尘风洞设备研制中的两个关键问题;针对动态试验工况环境中浓度传感器标定的问题,分析了浓度测量时标定参数与风速和浓度的关系,使用模型树算法建立了三者之间的关系模型,以此模型来预测各种动态情况下的标定参数;针对复杂环境下浓度动态控制问题,采用专家PID算法,提出了多回路控制系统结构和专家规则;工程实践表明该测量和控制方法满足了动态试验环境的需求,取得了良好效果;模型树算法和专家PID系统能有效的解决动态工况下砂尘浓度的测量与控制问题。     

R3中一类Kirchhoff型方程变号解的存在性及集中性

本文研究了一类Kirchhoff型方程。利用极大极小原理及惩罚函数方法,证明了上述方程变号解的存在性及集中性,我们的结果推广了文献[4]的结果。     

生物燃料电池处理生活污水同步产电特性研究

以某生活污水处理厂缺氧池活性污泥为接种体,以葡萄糖为模拟生活废水,构建双室型微生物燃料电池。利用微生物燃料电池(MFC,Microbial fuel cell)实现生活废水降解与同步产电。研究基质降解动力学及温度对MFC电极过程动力学的影响,明确微生物电化学活性、阳极传荷阻抗、阳极电势、电池产能之间的关系,考察库伦效率及COD去除率。研究结果表明,电池功率输出与基质浓度关系遵循莫顿动力学方程:P=Pmaxc/(ks+c),其中,半饱和常数ks为138.5 mg/L,最大功率密度Pmax为320.2 mW/m2。葡萄糖浓度较小时,反应遵循一级动力学规律:-dcA/dt=kcA,k=0.262 h-1。操作温度从20℃提高到35℃,生物膜电化学活性不断提高,传荷阻抗从361.2Ω减小到36.2Ω,阳极电极电势不断降低,同时,峰值功率密度从80.6 mW/m2提高到183.3 mW/m2。45℃时,产电菌活性降低,峰值功率密度减小到36.8 mW/m2。葡萄糖浓度为1 500 mg/L,温度为35℃时,MFC电化学性能最佳,稳定运行6 h后库伦效率为44.6%,COD去除率为49.2%。     

循环流化床富氧气化实验研究

在循环流化床富氧气化实验台上,通过调节水蒸气流量使气化温度基本稳定在910℃,研究了不同氧气浓度及气化当量比对煤气组分、产气率、冷煤气效率及碳转化率的影响。结果表明,氧气浓度从25%增加至40%时,N2体积分数从48.82%降低至33.83%,H2从21.47%不断增加至27.59%,CH4基本不变;受水蒸气流量影响,氧气浓度高于35%时,CO体积分数降低,CO2体积分数增加;氧气浓度40%时的煤气热值为空气气化煤气热值的1.84倍,产气率随氧气浓度增加从2.35 m3/kg降至2.13 m3/kg,冷煤气效率和碳转化率不断增大;当气化当量比从0.20增加至0.29时,N2体积分数先降低后升高,H2体积分数从24.01%增加到25.46%后基本保持不变,CO和CH4持续减小,CO2不断增加,产气率由1.94 m3/kg升高到2.29 m3/kg;受水蒸气和气化当量比综合影响,冷煤气效率先增大后减小,碳转化率持续增加。     

Study of the retention behavior of small polar molecules on different types of stationary phases used in hydrophilic interaction liquid chromatography

The retention behavior of a large group of analytes (35) with varied properties (pK_a and logP) was studied on eight hydrophilic interaction LC columns with different surfaces, stationary phase chemistries, and types of particles. The acetonitrile content (5–95%), buffer concentration (0.5–200 mM), and pH of the mobile phase (3.8 and 6.8) were evaluated for their effects on the retention behavior. The type of stationary phase had a significant impact on the selectivity and retention time of the tested analytes. Completely different selectivity was observed on the aminopropyl stationary phase. In this study, the influence of the buffer concentration was similar for all tested columns, except for the aminopropyl stationary phase. Increasing the buffer concentration led to decreased retention times for the basic compounds and increased retention times for the acidic compounds, while the inverse behavior was observed on the aminopropyl stationary phase. The selectivity of the individual stationary phases was evaluated at pH 3.8 and 6.8. Much lower selectivity differences between the stationary phases were observed at pH 6.8 than pH 3.8. Bare silica stationary phases were used in the comparison of the particles (fused‐core and fully porous particles of 3 and 1.7 μm) and the columns provided by different manufacturers.     

基于磷光材料的低给体比例有机太阳能电池

本文以低比例的磷光材料作为给体,制备了基于MoOx/C60:x%Ir(ppy)3的有机太阳能电池(OPV)器件.其中,C60为高比例的受体材料,金属配合物Ir(ppy)3为低比例的给体材料,MoOx为阳极缓冲层.通过一系列不同Ir(ppy)3比例的OPV器件对比研究,得出了最优器件结构.研究发现,当Ir(ppy)3比例足够小时,器件表现为肖特基势垒,开路电压(VOC)较大,短路电流(JSC)较小;随着Ir(ppy)3比例的增加,VOC逐渐减少,而JSC逐渐增大;当进一步增加Ir(ppy)3比例时,VOC趋于稳定,JSC开始减小.结果显示,5%Ir(ppy)3比例的器件性能最佳,效率达1.7%.为了使器件效率得到进一步提升,本研究组采用吸收光谱范围比C60更宽的C70作为受体材料,使光电转换效率进一步提升至3.0%.     

Investigation of Changes in Conductivity of Juice during the Evaporation Process

The creation of this article was the necessity of experimental determination of the electric conductivity of juice depending on the concentration of solids, expressed by the empirical formula, in order to more precisely control specific power supplied to the machine and foaming. Authors of the article held staged experimental studies using apple juice, the juice of red mountain ash, buckthorn and black currant. Found that the relationship between the conductivity of the juice solids content corresponds to the empirical formula of Kohlrausch, however, this formula does not represent the contribution juice acidity value of conductivity, and allows to correlate the specific power input to the device with the concentration of solids. The empirical formulas for the distribution of electrical juice conductivity depending on the acidity and for calculation of the specific power depending on the concentration of dry matter, allows to keep the speed of the foam below its destruction speed in the zone of vigorous reflux.     

Predicting ion concentration polarization and analyte stacking/focusing at nanofluidic interfaces

We report on the investigation of electropreconcentration phenomena in micro-/nanofluidic devices integrating 100 μm long nanochannels using 2D COMSOL simulations based on the coupled Poisson–Nernst–Planck and Navier–Stokes system of equations. Our numerical model is used to demonstrate the influence of key governing parameters such as electrolyte concentration, surface charge density, and applied axial electric field on ion concentration polarization (ICP) dynamics in our system. Under sufficiently extreme surface-charge-governed transport conditions, ICP propagation is shown to enable various transient and stationary stacking and counter-flow gradient focusing mechanisms of anionic analytes. We resolve these spatiotemporal dynamics of analytes and electrolyte ICP over disparate time and length scales, and confirm previous findings that the greatest enhancement is observed when a system is tuned for analyte focusing at the charge, excluding microchannel, nanochannel electrical double layer (EDL) interface. Moreover, we demonstrate that such tuning can readily be achieved by including additional nanochannels oriented parallel to the electric field between two microchannels, effectively increasing the overall perm-selectivity and leading to enhanced focusing at the EDL interfaces. This approach shows promise in providing added control over the extent of ICP in electrokinetic systems, particularly under circumstances in which relatively weak ICP effects are observed using only a single channel.     

Ferrozine colorimetry and reverse flow injection analysis (rFIA) based method for the determination of total iron in aqueous solutions at nanomolar concentrations

Iron is one of the most microbiologically and chemically important metals in natural waters. The biogeochemical cycling of iron is significantly influenced by the redox cycling of Fe(II) and Fe(III). Because of the unique chemistry of iron, it is often needed to analyze iron at nano-molar concentrations. This article describes a reverse flow injection analysis (rFIA) based method with ferrozine spectrophotometric detection to quantify total iron concentration in stream water at nanomolar concentrations. The rFIA system has a 0.65 nM detection limit and a linear dynamic range up to 1.40 μM for the total iron analysis. The detection limit was achieved using a 1.0 m long liquid waveguide capillary flow cell, 1.50 m long knotted reaction coil, 87.50 μL injection loop and a miniature fiber optics spectrophotometer. The optimized colorimetric reagent has 1.0 mM ferrozine, 0.1 M ascorbic acid, 1.0 mM citric acid and 0.10 M acetate buffer adjusted to pH 4.0. The best sample flow rate is 2.1 mL min^?1 providing a sample throughput of more than 15 samples h^?1. The linear dynamic range of the method can be adjusted by changing the volume of the injection loop. The rFIA manifold was assembled exclusively from commercially available components.