用于二聚物三能级蒸气激光系统的环形谐振腔设计

针对二聚物三能级蒸气激光系统增益相对于泵浦光方向显著的不对称特性,本文设计了一种稳定的能够充分利用介质增益特性的环形谐振腔,给出了象散和慧差补偿及泵浦激光与谐振腔匹配的条件。文中还给出了Na_2B~1Ⅱ_u-X~1∑_g~+跃迁激光谐振腔设计数据。     

SBS新介质C4Cl6参数确定及性能研究

 从介质对光的吸收机理出发，研究了吸收系数较小的受激布里渊散射（SBS）新介质六氯-1,3-丁二烯（C4Cl6）。通过基本的物理参数，确定了入射光波长为1 064 nm时C₄Cl₆的SBS参数，其吸收系数约为0.003 cm^-1，声子寿命约为0.25 ns，增益系数约为4.9 cm·GW^-1。分析了入射光波长与介质SBS参数的关系，布里渊频移与入射光波长成反比，声子寿命与入射光波长的平方成正比，增益系数一般与入射光波长无关。在单池SBS系统中，利用Nd:YAG调Q激光器研究了C₄Cl₆的SBS性能。实验结果表明：由于其吸收系数小，与具有相同增益系数的H₂O比较，C₄Cl₆具有较高的能量反射率（饱和能量反射率大于55%）和较宽的SBS脉宽；由于其声子寿命短，与具有相同吸收系数的CS₂比较，C₄Cl₆的SBS波形上升时间较短。吸收系数小和声子寿命短的特点，使C₄Cl₆适合作为放大池介质，这对优化SBS介质选取，提高SBS系统性能具有一定意义。     

Banach空间二阶非线性脉冲微分-积分方程的极值解

通过建立一个新的比较定理研究了B anach空间二阶非线性混合型脉冲微分-积分方程初值问题的极值解,所得结果推广和改进了现有文献的主要结果.     

光参量啁啾脉冲饱和放大的增益稳定性

 光参量啁啾脉冲放大（OPCPA）在饱和放大区存在一个增益稳定点，据此设计了一个输出稳定的三级OPCPA系统；第一、二、三级分别选用准相位匹配的周期极化钛氧磷酸钾（PPKTP）晶体、LBO晶体和KDP晶体作为增益介质。饱和放大时，增益随泵浦光强度变化时的增益输出稳定性明显改善，在泵浦光强度抖动低于6%的情况下，各级光参量放大器OPA输出的增益抖动小于1%。前级采用准相位匹配的PPKTP晶体作为增益介质，在远低于破坏阈值的30MW/cm²的泵浦功率密度下，可得到2×10⁵的饱和放大增益和20%的能量转换效率。     

陡前沿脉冲产生的受激布里渊散射稳定性研究

受激布里渊散射转换效率及相位共轭保真度的稳定性与泵浦脉冲的前沿上升时间有关，对前沿上升时间与介质声学声子寿命接近的泵浦脉冲，在泵浦能量超过受激布里渊散射阈值较多时，会造成严重的相位共轭保真度不稳定。本文针对上升前沿时间为２ｎｓ的泵浦脉冲及声学声子寿命的１ｎｓ和ＣＣｌ４介质，在泵浦脉冲前沿根部引入缓慢上升的小信号后，采用振放双池受激布里渊散射相位共轭镜，在泵浦激光能量达到５００倍受激布里渊散射阈值时     

Investigation on improving characteristics of two-cell SBS system with CCl4/C2H5OH liquid mixture

In order to improve the performance of the two-cell stimulated Brillouin scattering （SBS） system, this paper proposes the methods of using mixtures, which require amplifier media to have small absorption rate, and generator media to have high optical breakdown threshold and Brillouin frequency shift equal to that of the amplification media. The characteristics of the two-cell SBS system are studied experimentally by using CCl4 as amplifier medium and CCl4, C2H5OH and CCl4/C2H5OH liquid mixture as generator medium pumped by Nd：YAG Q-switched laser. The obtained results show that liquid mixture in generator cell improves the power load ability, phase conjugation fidelity, energy reflectivity （ER） and ER stability.     

基于SBS光限幅和金属酞菁光限幅相结合的复合型光限幅器的研究

为了使受激布里渊散射(SBS)光限幅器的输出能量更"平",提出了一种基于SBS光限幅和金属酞菁光限幅相结合的复合型光限幅器的方案,即SBS光限幅后边放置金属酞菁光限幅,在两种光限幅器的共同限幅作用下,使复合型光限幅器的输出光能量更"平". 数值模拟了该复合型光限幅器的输出光能量随入射光强度的变化曲线,并在Countinuum's Nd: YAG种子注入式激光器中进行了实验验证. 理论和实验结果均表明,复合型光限幅器的输出光能量比单独SBS光限幅器更"平". 关键词： 复合型光限幅器 SBS光限幅 金属酞菁限幅     

Laser-induced pattern formation from homogeneous polyisoprene solutions

This paper reports that the pattern formation in homogeneous solutions of polyisoprene in toluene saturated with C60 induced by a continuous-wave visible laser is observed experimentally. The transmitted beam patterns change with the increase of the laser irradiation time. In the initial phase, the patterns with concentric ring-shaped structure are formed. In the end, the patterns become speckle-shaped. The incubation time of the transmitted beam widening is inversely proportional to the laser power density and solution concentration. The pattern formation results from the optical-field-induced refractive index changes in the solutions, but the mechanism of optical-field-induced refractive index changes in the polymer solutions needs to be further studied.     

受激布里渊散射新介质——全氟胺的研究

本文从介质化学结构与受激布里渊散射(SBS)特性的关系入手,寻找出了SBS特性良好的全氟胺系列新介质——FC-131,FC-3283,FC-40,FC-43,FC-70等,并测定或计算出了新介质的SBS参数. 结果表明,新介质的吸收系数均小于10^-3 cm^-1,光学击穿阈值均高于100 GW/cm². 全氟胺系列新介质不仅具有良好的SBS特性,而且还具有无毒、低挥发性和高稳定性等一系列独特的物理化学性质. 新介质的发现不仅增加SBS介质的种类,而且能够有效提高SBS系统的性能,对于SBS相位共轭镜在高功率激光系统中的应用打下了良好的基础. 关键词： 受激布里渊散射(SBS) 全氟胺 吸收系数 光学击穿阈值     

A new circulating two-cell structure for stimulated Brillouin scattering phase conjugation mirrors with 1-J load and 10-Hz repetition rate

A new approach to realize high-energy and high-power stimulated Brillouin scattering phase conjugation mirrors （SBS-PCMs） is described.The reflectivity of SBS-PCM is investigated under a 10-Hz repetition rate and a high energy load.The relationship between reflectivity and input energy is examined experimentally with different PCM structures,focus lengths,and medium cell structures.A medium cell with a circulating structure is designed,and its advantage is demonstrated through an experimental comparison with traditional PCM structures.The 30-cm focus lens and 150-cm collimation lens are optimized when the input energy reaches 1010 mJ at 10-Hz repetition rate.Therefore,a reflectivity of 84.7% and a higher energy load using the circulating two-cell structure are achieved.