光参量啁啾脉冲饱和放大的增益稳定性

 光参量啁啾脉冲放大（OPCPA）在饱和放大区存在一个增益稳定点，据此设计了一个输出稳定的三级OPCPA系统；第一、二、三级分别选用准相位匹配的周期极化钛氧磷酸钾（PPKTP）晶体、LBO晶体和KDP晶体作为增益介质。饱和放大时，增益随泵浦光强度变化时的增益输出稳定性明显改善，在泵浦光强度抖动低于6%的情况下，各级光参量放大器OPA输出的增益抖动小于1%。前级采用准相位匹配的PPKTP晶体作为增益介质，在远低于破坏阈值的30MW/cm²的泵浦功率密度下，可得到2×10⁵的饱和放大增益和20%的能量转换效率。     

Banach空间二阶非线性脉冲微分-积分方程的极值解

通过建立一个新的比较定理研究了B anach空间二阶非线性混合型脉冲微分-积分方程初值问题的极值解,所得结果推广和改进了现有文献的主要结果.     

用于二聚物三能级蒸气激光系统的环形谐振腔设计

针对二聚物三能级蒸气激光系统增益相对于泵浦光方向显著的不对称特性,本文设计了一种稳定的能够充分利用介质增益特性的环形谐振腔,给出了象散和慧差补偿及泵浦激光与谐振腔匹配的条件。文中还给出了Na_2B~1Ⅱ_u-X~1∑_g~+跃迁激光谐振腔设计数据。     

陡前沿脉冲产生的受激布里渊散射稳定性研究

受激布里渊散射转换效率及相位共轭保真度的稳定性与泵浦脉冲的前沿上升时间有关，对前沿上升时间与介质声学声子寿命接近的泵浦脉冲，在泵浦能量超过受激布里渊散射阈值较多时，会造成严重的相位共轭保真度不稳定。本文针对上升前沿时间为２ｎｓ的泵浦脉冲及声学声子寿命的１ｎｓ和ＣＣｌ４介质，在泵浦脉冲前沿根部引入缓慢上升的小信号后，采用振放双池受激布里渊散射相位共轭镜，在泵浦激光能量达到５００倍受激布里渊散射阈值时     

GNSS/INS紧组合的新息优化抗差估计欺骗检测算法

针对传统的新息抗差估计欺骗检测算法对缓慢增长的斜坡式欺骗检测时间较长甚至检测不敏感等问题,提出了一种GNSS/INS紧组合的新息优化抗差估计欺骗检测算法。所提出的算法对缓慢增长的斜坡式的新息检测量进行了优化,结合抗差估计自适应调整增益矩阵并合理选择“检测窗口”,进一步提高了对缓慢增长的斜坡式欺骗干扰的检测效率和检测性能。仿真结果表明,在检测单通道0.1?m/s缓慢增长的斜坡式欺骗时,所提算法检测时间较新息抗差估计欺骗检测算法平均缩短了30%以上,漏检率为0;在检测多通道时,检测时间平均缩短了30%,漏检率为0,虚警率平均降低了18.5%。所提算法在检测缓慢增长的斜坡式欺骗干扰时,具有检测快、漏检率和虚警率低的优势,对无人机应用领域具有重要意义。     

Laser-induced pattern formation from homogeneous polyisoprene solutions

This paper reports that the pattern formation in homogeneous solutions of polyisoprene in toluene saturated with C60 induced by a continuous-wave visible laser is observed experimentally. The transmitted beam patterns change with the increase of the laser irradiation time. In the initial phase, the patterns with concentric ring-shaped structure are formed. In the end, the patterns become speckle-shaped. The incubation time of the transmitted beam widening is inversely proportional to the laser power density and solution concentration. The pattern formation results from the optical-field-induced refractive index changes in the solutions, but the mechanism of optical-field-induced refractive index changes in the polymer solutions needs to be further studied.     

Investigation on improving characteristics of two-cell SBS system with CCl4/C2H5OH liquid mixture

In order to improve the performance of the two-cell stimulated Brillouin scattering （SBS） system, this paper proposes the methods of using mixtures, which require amplifier media to have small absorption rate, and generator media to have high optical breakdown threshold and Brillouin frequency shift equal to that of the amplification media. The characteristics of the two-cell SBS system are studied experimentally by using CCl4 as amplifier medium and CCl4, C2H5OH and CCl4/C2H5OH liquid mixture as generator medium pumped by Nd：YAG Q-switched laser. The obtained results show that liquid mixture in generator cell improves the power load ability, phase conjugation fidelity, energy reflectivity （ER） and ER stability.     

Controllable optical delay line using a Brillouin optical fiber ring laser

A controllable optical delay line using a Brillouin optical fiber ring laser is demonstrated and a large time delay is obtained by cascading two optical fiber segments. In experiment, a single-mode Brillouin optical fiber ring laser is used to provide Stokes wave as probe wave. We achieve a maximum tunable time delay of 61 ns using two cascading optical fiber segments, about 1.5 times of the input probe pulse width of 40 ns. In the meantime, a considerable pulse broadening is observed, which agrees well with the theoretical prediction based on linear theory.     

基于SBS光限幅和金属酞菁光限幅相结合的复合型光限幅器的研究

为了使受激布里渊散射(SBS)光限幅器的输出能量更"平",提出了一种基于SBS光限幅和金属酞菁光限幅相结合的复合型光限幅器的方案,即SBS光限幅后边放置金属酞菁光限幅,在两种光限幅器的共同限幅作用下,使复合型光限幅器的输出光能量更"平". 数值模拟了该复合型光限幅器的输出光能量随入射光强度的变化曲线,并在Countinuum's Nd: YAG种子注入式激光器中进行了实验验证. 理论和实验结果均表明,复合型光限幅器的输出光能量比单独SBS光限幅器更"平". 关键词： 复合型光限幅器 SBS光限幅 金属酞菁限幅     

KrF激光受激布里渊散射反射率稳定性的研究

实验研究发现抽运功率密度（或抽运能量）的波动引起的受激布里渊散射(SBS)反射率的不稳定程度受实验参数（抽运能量、介质气压和透镜焦距）的影响.当抽运能量、介质气压和透镜焦距这三个参数同时满足下列条件时可以获得稳定的输出：抽运能量超过5倍的SBS阈值，介质气压在16×105Pa和透镜焦距在15—50cm的范围内；同时还发现当改变实验参数时SBS反射率与稳定性的变化规律完全一致，反射率越高稳定性越好.通过理论分析得到 SBS反射率的相对稳定度实际上是受GIL因子的影响，理论计算与实验符合得很好. 关键词： KrF激光 受激布里渊散射 反射率 稳定度