Synthesis of novel soluble poly(imide-siloxane)s via hydrosilylation: Characterization and structure property behaviour

A series of novel poly(imide-siloxane)s (PIS) were synthesized by the grafting of amine terminated soluble imides to the siloxane backbone. The amine terminated imides were synthesized by choosing suitable anhydrides and amines to get the imides that are soluble in polar and non-polar solvents. The imides were grafted to the siloxane backbone by the epoxy group cleavage. All the polymers were obtained in quantitative yields with the inherent viscosities ranging from 0.22 to 1.2 dL g⁻¹. The polymers were characterized by FT-IR, ¹H and ¹³C NMR, and were examined for their thermal properties. The polymers were found to be stable up to a temperature 350 °C. The DSC results showed a single glass transition in the negative temperature, whereas the DTA revealed another glass transition in the positive end for some of the polymers showing phase separation. Polymer films were prepared employing the coupling reaction between PIS and the polydimethylsiloxane matrix by varying the amount of incorporation of PIS in the films. The polymer films had a tensile strength of 35-82 MPa with a percentage elongation of 86-271%. The contribution of polar and dispersion component towards the total surface energy was studied by the contact angle measurement and a reduction in surface tension of 14 mN m⁻¹ was achieved with the fluorine containing PIS membrane.     

Analysis of the effects of catalytic bleaching on cotton

Hydrogen peroxide can be catalyzed to bleach cotton fibers at temperatures as low as 30°C by incorporating dinuclear tri-μ-oxo bridged manganese(IV) complex of the ligand 1,4,7-trimethyl-1,4,7-triazacyclononane (MnTACN) as the catalyst in the bleaching solution. The catalytic system was found to be more selective under the conditions applied than the non-catalytic H₂O₂ system, showing better bleaching performance while causing slightly lower decrease in degree of polymerization (DP) of cellulose. In order to gain fundamental knowledge of the bleach effect on cotton fibers and cellulose as its main component, especially after catalytic bleaching, X-ray Photoelectron Spectroscopy (XPS) was used to study surface chemical effects. The Washburn method was applied to investigate wetting properties, and liquid porosity was used to obtain pore volume distribution (PVD) plots. Parallel analyzes performed on model cotton fabric, i.e. “clean” cotton fabric stained with morin - a pigment regularly found in native cotton fiber, helped to differentiate between pigment oxidation and other bleaching effects produced on the (regular) industrially scoured cotton fabric. Bleaching was not limited to the chemical action but also affected cotton fiber capillary parameters most likely due to the removal of non-cellulosic materials as well as chain-shortened cellulose.     

紫外光引发LDPE膜接枝含氟丙烯酸酯的研究

通过紫外光引发表面接枝聚合反应的方法 ,把含氟丙烯酸酯单体R 5 6 1 0引到LDPE薄膜上 .对经丁酮抽提后的接枝膜进行FTIR、ESCA、SEM和DSC等表征 ,证实含氟聚合物以化学键的方式接枝在LDPE基体膜上 .在一定范围内 ,增加紫外光强、引发剂和单体浓度以及反应温度等均有利于提高接枝率 .经计算R 5 6 1 0的紫外光引发接枝聚合反应总活化能为 5 4 2kJ mol.接枝膜的接触角随着接枝率的提高逐步增大 ,直至趋于恒定 .作者提出接枝膜存在一个在接触角测定时影响基体膜与探测水滴相互作用过程的边界层 .当接枝率较低、接枝层厚度小于边界层临界厚度时 ,基体LDPE影响接触角的大小 ,但随着接枝率提高 ,接枝层逐渐变厚 ,氟聚合物层对接触角的贡献逐渐占优势 ,导致接触角随之增大 .当接枝率超过一定值以后 ,接枝层厚度超过边界层临界厚度 ,接枝层对接枝膜的接触角起全部贡献 ,接触角测定值随之稳定     

Synthesis and Crystal Structure of 4-{[（1E）1- （2-Hydroxy-3-methoxyphenyl）methylidene]amino}- 1,5-dimethyl-2-phenyl-2,3-dihydro-1H-pyrazol-3-one

The title Schiff base compound,C19H19N3O3,a derivative of antipyrine,has been synthesized and characterized by elemental analysis,IR,and single-crystal X-ray diffraction.The crystal belongs to the monoclinic system,space group C2/c,with α = 27.935(5),b = 7.553(1),c =16.692(3) (A),β = 105.810(3)°,Z= 8,V= 3388.7(10) (A)3,Dc = 1.323 g/cm3,Mr = 337.37,λ(MoKα) =0.71073 (A),μ = 0.091 mm-1,F(000) = 1424,R = 0.0630 and wR = 0.1273.A total of 3513 unique reflections were collected,of which 2112 with I ＞ 2σ(I) were observed.The molecular structure adopts a trans configuration about the C=N double bond.The pyrazoline and C(1)～C(6) pheny1 ring are approximately coplanar (mean deviation from the combined plane is 0.069(3) (A)),with the dihedral angle of 9.7(2)°.The preliminary biological tests show that the compound has high antibacterial activities.     

Surface and bulk properties of severely fluorinated carbon fibres

The development of ultra-inert composites using fluorinated carbon fibres as the reinforcement requires fluorinated carbon fibres with a durable surface composition. Here we report the effect of direct fluorination using an F₂/N₂ mixture at 653 K on the surface and bulk properties of two types of high strength carbon fibres. These were treated up to a surface fluorine content of ∼64 at.% and a bulk fluorine content of ∼15 mass%. A colour change was observed after fluorination caused by the changes in the graphitic band structure of the carbon fibres by the introduction of carbon sp³ hybridisation. The tensile strength and Young's modulus decrease after fluorination by up to 33 and 22%, respectively. XRD shows marginal changes in the interlayer distance but the crystallite size increases. Changes in the electrical conductivity of the fluorinated carbon fibres indicate that the modification is confined to the near surface volume. Predominantly covalent C-F bonds are formed as shown by X-ray photoelectron spectroscopy (XPS) and measured zeta (ζ)-potentials. Hence the fluorinated fibres are hydrophobic and have low surface tensions. This and the large increase in fibre surface area, as determined by nitrogen adsorption, is expected to facilitate interfacial interaction between fluorinated carbon fibres and fluoropolymers.     

Combined IR and XPS analysis of the native (1 0 0) surface of single‐crystalline silicon after HFaq etching

A combined analysis, based on angle‐resolved X‐ray photoelectron spectroscopy and multiple‐internal‐reflection infrared spectroscopy, of the (1 0 0) silicon surface after etching in dilute aqueous solution of HF is presented. The analysis shows that the surface is mainly formed by a heterogeneous distribution of SiH, SiH₂ and SiH₃ terminations, but contains (in addition to sub‐stoichiometric oxidized silicon) a form of reduced silicon, not consistent with the currently accepted picture of the native HF_aq‐etched surface. Copyright © 2007 John Wiley & Sons, Ltd.     

New liquid‐crystal alignment agents based on fluorinated polyimides with trifluoromethyl‐substituted benzene or diphenylether in the side chain

Fluorinated copolyimides derived from 4,4′‐oxydiphthalic anhydride (ODPA) with 4,4′‐oxydianline (ODA) and trifluoromethyl‐containing aromatic diamines have been synthesized and characterized. The trifluoromethyl‐containing diamines include 2,4‐diamino‐3′‐trifluoromethylazobenzene, 2,4‐diamino‐1‐[(4′‐trifluoromethylphenoxy) phenyl] aniline, 3,5‐diamino‐1‐[(4′‐trifluoromethylphenoxy) phenyl] benzamide, 3,5‐diamino‐1‐[(3′‐trifluoromethyl) phenyl] benzamide, 1,4‐bis(4′‐aminophenoxy)‐2‐(3′‐trifluoromethylphenyl) benzene, 3,5‐diaminobenzenetrifluoride, 4,4′‐diamino‐4″‐(p‐trifluoromethyl phenoxy) triphenylamine, and 4‐[(4′‐trifluoromethylphenoxy) phenyl]‐2,6‐bis(4″‐aminophenyl)pyridine. Strong and flexible copolyimide films, produced by casting the polyamic acid solution followed by thermal imidization, exhibited great thermal stability and high mechanical properties. The polyimides had an ultraviolet–visible absorption cutoff at 330–340 nm and pretilt angles as high as 20° for nematic liquid crystals, making them great potential candidates for advanced liquid‐crystal display applications. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 1583–1593, 2002     

Characteristic lengths and the structure of salt free polyelectrolyte solutions. A small angle neutron scattering study

We have studied salt free semi dilute polyelectrolyte solutions by small angle neutron scattering. Specific labelling associated with an extrapolation method has allowed the separation of the form factor of a single polyelectrolyte chainS ₁(q) and the structure factorS ₂(q). Two lengths are deduced from these two factors: the persistence lengthb _t which characterizes the electrostatic interactions along the chain by a fitting ofS ₁(q) with calculation of the scattering function for a wormlike chain, and fromS ₂(q),q _m ^–1 which characterizes the interactions between chains. These two lengths vary in the same way with the concentration of polyions (b _t C _p ^–1/2 ,q _m ^–1 C _p ^–1/2 ) and a constant relation exists between them: only one length is then necessary to describe the structure of polyelectrolyte soltuion on this semidilute concentration range.Laboratoire Commun CEA-CNRS.