关于合理确定集装箱码头装船顺序的算法

如何在给出箱区图和配载图的情况下,根据不同的装船方式,运用计算机程序确定合理的发箱和装箱顺序?本文主要依据实际数据,针对两种在码头实际装船作业中应用性较强的装船方式进行了研究,分别对其做了建立数学矩阵模型,制定合理算法,编写M ATLAB程序等工作,并论证了它们在实际操作中的可行性.本文的研究结果会在集装箱码头的实际装船作业中具有很强的应用性.     

电子束流品质对自由电子激光小信号增益影响的计算

对电子束有一定初始能量分散或角度分散时的自由电子激光小信号增益用较简便的方法进行了分析计算,并给出了一个渐近公式,结果与用计算机模拟解自由电子激光微分方程组得到的结果一致。     

一个线性约束优化问题的广义梯度投影法

本文对线性约束优化问题提出了一个新的广义梯度投影法，该算法采用了非精确线性搜索，并在每次迭代运算中结合了广义投影矩阵和变尺度方法的思想确定其搜索方向．在通常的假设条件下，证明了该算法的整体收敛性和超线性收敛速度．     

双面加热环形通道内干涸点的确定

根据环形管通道内流体流动和换热的特点,以Kirillov和Smogalev提出的干涸点理论模型假设为基础,从最基本的质量守恒方程出发,并引入临界液膜厚度等相应的辅助模型,得到了双面加热环形通道内流动沸腾干涸点的理论模型。同时针对间隙为1.0mm和1.5mm的环形窄缝进行了低压低质量流速工况下干涸点的实验研究。比较发现理论模型预测值与实验结果基本相符。说明本文提出的理论模型适用于低压低流量条件下的窄环形通道。实验同时发现:环状流临界热流密度在系统压力为2.2MPa达到最大值,临界含汽量随质量流速的增大呈缓慢下降趋势。     

Mathematical Modeling, Control, Computer Simulation and Laboratory Experiments of a Spatial Servopneumatic Parallel Robot

In this paper, the special construction of a parallel robot, called spatial servopneumatic multi-axis test facility, will be discussed. The investigations include the following aspects: (i) the laboratory set-up of the robot, (ii) various results obtained in laboratory experiments, taking into account quite different control algorithms and command-input signals, (iii) a comparison of the laboratory experiments with the computer simulations of Part I of this paper, and ({vi}) a quality check of the results compared with the cost of the different controller realizations. The results of both the computer simulations and the laboratory experiments show: (i) The dynamic behavior of the parallel structure can be tremendously improved by using sophisticated nonlinear control algorithms. (ii) This improvement has to be paid by a drastically increased amount of work for deriving the model equations and control algorithms, and by augmented hardware cost of the sensing elements and controller electronics. (iii) Carefully developed model equations and identified model parameters provide theoretical models of the complex parallel structure that are very close to reality. This enables the design engineer to systematically investigate constructive alternatives of the design parameters, sensor and actuator concepts, and control strategies of the MAP prior to their hardware realization.This work has been supported by the German Science Foundation (DFG) under Contract No. Ha 1666/6-3.     

凹整数规划的分枝定界解法

凹整数规划是一类重要的非线性整数规划问题，也是在经济和管理中有着广泛应用的最优化问题．本文主要研究用分枝定界方法求解凹整数规划问题，这一方法的基本思想是对目标函数进行线性下逼近，然后用乘子搜索法求解连续松弛问题．数值结果表明，用这种分枝定界方法求解凹整数规划是有效的．     

Designing an effective federal biomass program

This article addresses two questions: Has the effectiveness of the US governments federal research and development (R&;D) spending suffered from the post-1980 strategic change from freely shared and publicly owned to privately owned scientific advances? What criteria would a federal R&;D program use to design a strategy that most effectively enhances the well-being of farmers and rural communities? Several studies found that the pre-1980 US Department of Agriculture research strategy was very effective. No comparable studies have analyzed the comparative effectiveness of the post-1980 strategy of restricting access to the results of public research. Recent experience and several analytical studies suggest that to significantly enhance the health of rural economies from an expanded use of plant matter as an industrial material, federal policy should channel scientific and engineering research into small- and medium-sized production and processing technologies and should encourage farmer-owned, value-added enterprises.     

高等数学教学改革研究进展

通过分析国内外高等数学教学改革研究历史与现状,阐明21世纪高等数学课程地位、作用和价值,及与21世纪相适应的高等数学教学改革意义、方向与方法.并结合个人教学实践分析、总结了具有代表性的高等数学教学理念、教学内容与课程体系、实践教学、计算机技术应用等方面改革成果与经验.最后对高等数学教学改革的继续深入和目前存在问题提出一些观点.     

求线性规划初始可行基的新方法

本文提出一个求线性规划初始可行基的新算法，该算法不仅避免了人工变量，而且理论分析及初步的数值实验结果表明其效率更高。     

凸合成模糊对策的模糊稳定集

本建立了凸合成模糊对策的模型，并得到了凸合成模糊对策的模糊稳定集，可由子对策的模糊稳定集表达出来。从而解决了凸合成模糊对策的解的结构问题。