植物油中脂肪酸不同定量方法的比较分析

比较峰面积归一化法与标准曲线法两种方法分析植物油中脂肪酸百分比含量的差异。利用气相色谱-质谱联用仪(GC-MS)检测10种市售食用植物油中的8种主要脂肪酸,峰面积归一化法和标准曲线法计算脂肪酸的百分比含量。结果表明,标准曲线法与峰面积归一化法相比,肉豆蔻酸、棕榈酸、十七烷酸、硬脂酸和棕榈油酸所占的百分比升高,而油酸、亚油酸和亚麻酸比例降低;饱和脂肪酸比例升高,不饱和脂肪酸百分比降低。利用峰面积归一化法计算植物油中脂肪酸百分比时,降低了饱和脂肪酸比例,升高了不饱和脂肪酸比例,可能对健康有潜在的不利影响。建议使用标准曲线法计算不同植物油中脂肪酸的百分比。     

基于NI-DAQ的高采样实时数据绘制方法与实现

飞行试验实时监控中,对高采样数据通常采用曲线绘制进行分析与故障判断,这对数据绘制的实时性、精确性以及曲线长度等都提出了较高的要求。本文对基于NI-DAQ的曲线绘制方法进行了研究和软件设计,实现了客户端的高采样数据实时绘制与打印输出。结果证明,采用该方法绘制的参数曲线可以满足实时监控要求。     

光生物节律因子计算模型的研究

通过实验测量额头温度拟合光生物节律因子-额温差曲线,对现有评价光生物效应作用大小的BioEq模型和CLA模型的计算结果进行分析比较.利用不同图片LCD屏幕的光谱计算节律因子,发现两种模型对于绿色波段的光抑制较强,而对红色波段的光则与实际不相符.通过对九种不同颜色的LED光源测试额头温度,比较模型计算结果与实际光生物效应的作用,发现光生物节律因子与生理体征变化线性递增,其中对BioEq模型的直线拟合相关度达到0.95.     

Sulfur removal from bauxite water slurry (BWS) electrolysis intensified by ultrasonic

Effects of ultrasonic on desulfurization ratio from bauxite water slurry (BWS) electrolysis in NaOH solution were examined under constant current. The results indicated that ultrasonic improved the desulfurization ratio at high temperatures because of the diffusion and transfer of oxygen gas in electrolyte. However, due to the increase in oxygen gas emission, ultrasonic could not improve the desulfurization ratio obviously at low temperatures. Additionally, the particle size of bauxite became fine in the presence of ultrasonic, indicating that the mass transfer of FeS₂ phase was improved. According to the polarization curves, the current density increased in the presence of ultrasonic, indicating that the mass transfer of liquid phase was improved. The apparent activation energy (AAE) of electrode reaction revealed that ultrasonic did not change the pathway of water electrolysis. However, ultrasonic changed the pathway of BWS electrolysis, converting indirect oxidation into direct oxidation. The AAE of BWS electrolysis in the presence of ultrasonic was higher than that in the absence of ultrasonic. And the low AAEs (less than 20 kJ/mol) clearly indicated the diffusion control during BWS electrolysis reaction.     

空间光调制器曲面拼接实现全息三维显示视角拓展

本文对多空间光调制器不同拼接方式拓展全息三维再现像视角的方法进行了分析,基于多片空间光调制器拼接拓展视角的思想,利用平面反射镜、分光镜和两片透射式空间光调制器设计了曲面拼接系统,进行了全息三维再现像的视角拓展实验研究。用该系统对四棱锥物体的层析菲涅尔衍射全息图进行再现,结果表明,总视角由基于单片空间光调制器的1.7°增大到3.2°,即拓展到约1.9倍,分光镜能够消除两片空间光调制器间的间隙,实现无缝拼接。该方法同样适用于更多空间光调制器的曲面拼接中,可以有效地拓展全息再现像的视场角大小。     

食盐与心血管结局

介绍了食盐与心血管结局关系的最新研究结果,食盐摄入量与心血管结局之间呈J形关系;低盐和高盐都增加心血管危险;不支持普遍减盐推荐。     

仪器分析教学中通过实例培养学生的创新能力——电位滴定终点确定的新方法

以电位滴定终点确定新方法探讨研究为例,从5个方面介绍将创新能力培养融入基础课教学的探索。通过该研究提高了学生基础课学习热情与学习质量。首先改进了二次差值微商终点计算方法,通过Excel 计算Δ2E/ΔV-V 二次差值微商法数据表中的最高点与最低点直线线性方程 y=ax+b,令 y=0, x=-b/a即为终点。另外,研究得到了模拟滴定曲线微分法确定电位滴定终点的新方法。用Excel 对滴定曲线进行三次方程模拟即:y=ax3+bx2+cx+d,二次微分后得到: d2y/dx2=6ax+2b, 当d2y/dx2=0,对应的x=-b/3a处即为滴定终点。2     

Multi-reference calculations of the photodissociation of HSCH3 molecule

This paper performs multi-reference second-order perturbation theory calculations on the ground state and a number of low-lying excited states of HSCH3 molecule, and calculates the vertical excitation energies and low-energy potential-energy curves, based on which the photodissociation channels of HSCH3 at 193,222,248 nm are clarified.     

Studies of synthesizing behaviors and superconductivity of sol-gel YBa2Cu3O7-x samples in flowing oxygen atmosphere

Systematic studies of synthesizing behaviors of sol-gel YBa₂Cu₃O_7−x samples in flowing oxygen atmosphere and their superconductivity have been performed. A set of high temperature ρ-T curves has been obtained for the whole synthesizing process. After four rounds of synthesizing, the resistivity of the sample was around ρ=1.00×10⁻³Ω · cm at room temperature. The ρ-T curve of the fourth round shows that the orthorhombic to tetragonal phase transformation of the sample occurs around 600 °C, which is lower than that of the YBa₂Cu₃O_7−x sample prepared by conventional solid-state reaction method. Other measurements, such as X-ray diffraction, SEM measurement and low temperature R-T and M-T measurement, were also performed. And the R-T and M-T measurement results suggest that during the synthesizing process, there exist some state at which the sample has better superconductivity than the other states. Moreover, we found screw dislocations presenting on the sample broken surface from the SEM images. This will change the concept that the screw dislocations can only grow on the surface of the YBCO thin films and single crystals.