Determination of carbonyl compounds in air by HPLC using on-line analyzed microcartridges,fluorescence and chemiluminescence detection

Summary Sensitive and selective detection of dansylhydrazones of atmospheric carbonyl compounds (aldehydes and ketones) can be achieved using high performance liquid chromatography (HPLC) with fluorescence or chemiluminescence detection. The carbonyl compounds are derivatized by drawing air through small glass cartridges packed with porous glass particles impregnated with dansylhydrazine. After sampling, the contents of the cartridges are analyzed on-line by using a small plug of water (200 L) to transfer and focus the hydrazone derivatives at the head of a HPLC column. Greatly increased sensitivity over traditional methods derives from 1) analysis of the entire contents of the sampling cartridge, and 2) detection by fluoresence or peroxyoxalate chemilum-inescence. Results are compared for photo-initiated and H₂O₂-initiated peroxyoxalate chemiluminescence. This novel and practical system enables the detection of sub-ppbv concentrations of formaldehyde, acetaldehyde, acetone and higher carbonyls in air using relatively short sampling times.     

Determination of estrogenic steroids in surface water and wastewater by liquid chromatography-electrospray tandem mass spectrometry

An analytical method is presented which permits trace level determination of 17alpha-ethynylestradiol (EE2), 17beta-estradiol (E2), and estrone (E1). Using this method, the estrogenic steroids were analyzed in drinking water, surface water, and wastewater (sewage influents and effluents) at concentrations down to 0.1 ng/L. Sample volumes between 100 and 500 mL are concentrated using automated solid-phase extraction. Analysis is performed by liquid chromatography with detection by tandem mass spectrometry. Applying simple clean-up procedures and internal standard calibration, recovery losses resulting from matrix-dependent ion suppression during electrospray ionization could be compensated for all of the investigated compounds. Recoveries around 100% were obtained for all analytes after correction using the internal standards. Limits of quantification (LOQ) were between 0.1 and 0.4 ng/L for purified sewage, surface, ground, and drinking water and between 1 and 2 ng/L in the case of raw sewage. Water treatment by wastewater treatment plants (WWTPs) or by a surface water treatment plant affected the removal of all estrogenic steroids. Thus, E1, E2, and EE2 were removed in the municipal WWTPs to the extent of 93%, 93%, and 80%, respectively. In the effluents of the WWTP in Ruhleben (Berlin, Germany), E1, E2, and EE2 were detected at the low ng/L level. E2 and EE2 were, however, not present in the Berlin surface water above the LOQ (0.2 ng/L). E1 was the only compound that could be detected in surface water samples. After additional surface water treatment it was still detectable but only at trace-level concentrations with a mean value of 0.16 ng/L.     

Forensic classification of ballpoint pen inks using high performance liquid chromatography and infrared spectroscopy with principal components analysis and linear discriminant analysis

Several varieties of blue ballpoint pen inks were analyzed by high performance liquid chromatography (HPLC) and infrared spectroscopy (IR). The chromatographic data extracted at four wavelengths (254, 279, 370 and 400 nm) was analyzed individually and at a combination of these wavelengths by the soft independent modeling of class analogies (SIMCA) technique using principal components analysis (PCA) to estimate the separation between the pen samples. Linear discriminant analysis (LDA) measured the probability with which an observation could be assigned to a pen class. The best resolution was obtained by HPLC using data from all four wavelengths together, differentiating 96.4% pen pairs successfully using PCA and 97.9% pen samples by LDA. PCA separated 60.7% of the pen pairs and LDA provided a correct classification of 62.5% of the pens analyzed by IR. The results of this study indicate that HPLC coupled with chemometrics provided a better discrimination of ballpoint pen inks compared to IR. The need to develop a suitable IR method for analysing blue ballpoint pen inks has been emphasized and it is hoped that the development of such a method would indeed provide a valuable tool for the non-destructive analysis of blue ballpoint pen ink samples for forensic purposes.     

Polyhydroxy pregnanes from Dregea volubilis

Three new polyhydroxy pregnanes named dregealol (1), volubilogenone (2) and volubilol (3) were isolated from the flowers of Dregea volubilis, and their structures elucidated from extensive 2D NMR analysis. The structure of volubilol (3) was confirmed by X-ray crystallographic studies. The known pregnane derivatives drevogenin D, iso-drevogenin P and 17α-marsdenin were also isolated.     

卡尔曼滤波紫外光度法同时测定饮料中苯甲酸及糖精的研究

在酸性条件下，用乙醚萃取、蒸干乙醚后，用ＮａＨＣＯ３溶解残渣，从复杂的样品中分离出苯甲酸和糖精，测定它们在２４５～２８１ｎｍ之间的紫外吸收，运用卡尔曼滤波算法计算两者的浓度，用新息序列监测干扰物质分离的程度。此法简化了许多分离手续，用于饮料分析，结果满意。     

Automated at-line solid-phase extraction-gas chromatographic analysis of micropollutants in water using the PrepStation

A fully automated at-line solid-phase extraction-gas chromatography procedure has been developed for the analysis of aqueous samples using the PrepStation. The sample extract is transferred from the sample preparation module to the gas chromatograph via an autosampler vial. With flame-ionization detection, limits of determination (S/N=10) of 0.05–0.13 μg/l were obtained for the analysis of HPLC-grade water when modifying the PrepStation by: (i) increasing the sample volume to 50 ml, (ii) increasing the injection volume up to 50 μl, and (iii) decreasing the desorption volume to 300 μl. The HP autosampler had to be modified to enable the automated “at-once” on-column injection of up to 50 μl of sample extract. The amount of packing material in the original cartridge had to be reduced to effect the decrease of the desorption volume. The total set-up did not require any further optimization after having set up the method once. The analytical characteristics of the organonitrogen and organophosphorus test analytes, i.e. recoveries (typically 75–105%), repeatability (2–8%) and linearity (0.09–3.0 μg/l) were satisfactory. The potential of the system was demonstrated by determining triazines and organophosphorus pesticides in river Rhine water at the 0.6 μg/l level using flame-ionization and mass-selective detection. No practical problems were observed during the analysis of more than 100 river water samples.     

Fluorinated nitroxides as ESR probes of solvation

Some newly synthesized fluorinated nitroxides, such as t-butyl perfluoroalkyl nitroxides Bu^tN(O) R_f (R_f=CF₃, 5; C₂F₅, 6; n-C₃F₇, 7) and s-butyl perfluoroacyl nitroxides Bu^sN(O) COR_f (R_f=CF₃, 9; n-C₃F₇, 10) have been employed as ESR probes of solvation in different common organic solvents. In aprotic solvents, the measured a_N values for each of the nitroxyl probes show a linear correlation with the cybotactic polar solvent parameters E_T (Dimroth) and Z (Kosowar), i.e. a_N=bE_T+c, and a_N=b′Z+c′. The physical significance for the slope (b or b′), the slope×E_T or slope×Z, the extrapolated intercept on a_N axis, c or c′, are linked, respectively, to the sensitivity of a specific nitroxide toward solvation, the magnitude of the overall solvation effect on the a_N value, and the intrinsic a_N value of each nitroxide in the ideal gaseous state. The intercept on the a_N axis may also serve as a new measure of electronegativity for perfluoroalkyl groups, CF₃, C₂F₅, n-C₃F₇, and perfluoroacyl groups, CF₃CO, n-C₃F₇CO. In protic solvents, i.e. alcohols and carboxylic acids, however, a_N values of all the probes, kept almost no change with the increase in E_T and Z. Furthermore, the plots of a_N versus non-cybotactic solvent constants, such as dipolar moment (μ) and dielectric constant (ε), all show random variations.     

New results on multi-dimensional linear discriminant analysis

Fisher linear discriminant analysis is a well-known technique for dimensionality reduction and classification. The method was first formulated in 1936 by Fisher. In this paper we concentrate on three different formulations of the multi-dimensional problem. We provide a mathematical explanation why two of the formulations are equivalent and prove that this equivalency can be extended to a broader class of objective functions. The second contribution is a rate of convergence of a fixed point method for solving the third model.     

An $L^{\infty}$ Second Order Cartesian Method for 3D Anisotropic Interface Problems

A second order accurate method in the infinity norm is proposed for general three dimensional anisotropic elliptic interface problems in which the solution and its derivatives, the coefficients, and source terms all can have finite jumps across one or several arbitrary smooth interfaces. The method is based on the 2D finite element-finite difference (FE-FD) method but with substantial differences in method derivation, implementation, and convergence analysis. One of challenges is to derive 3D interface relations since there is no invariance anymore under coordinate system transforms for the partial differential equations and the jump conditions. A finite element discretization whose coefficient matrix is a symmetric semi-positive definite is used away from the interface; and the maximum preserving finite difference discretization whose coefficient matrix part is an M-matrix is constructed at irregular elements where the interface cuts through. We aim to get a sharp interface method that can have second order accuracy in the point-wise norm. We show the convergence analysis by splitting errors into several parts. Nontrivial numerical examples are presented to confirm the convergence analysis.