全光纤脉冲压缩器的理论及实验研究

对色散位移光纤＋普通单模光纤构成的全光纤脉冲压缩器进行了理论分析，分析了压 缩效果与光纤参数及输入脉冲参数的关系；对不同中心波长和脉宽的主动锁模光纤激光器的 输出脉冲进行了压缩实验，均得到了近变换限Sech的压缩脉冲，实验结果与理论分析一致. 关键词： 全光纤脉冲压缩器 压缩因子 基座能量 主动谐波锁模光纤 激光器     

Two-Frequency Brillouin Fiber Laser Based on Bragg Grating Fabry-Perot Cavity

A novel and simple two-frequency Brillouin fiber laser is presented. It is based on a fiber Fabry-Perot cavity with fiber Bragg gratings as reflectors. The model of stimulated Brillouin scattering in fiber grating-based Fabry-Perot resonator is investigated. The laser allows conversion efficiency of close to 100% and suppresses the higher-order Stokes waves. The theoretical prediction is presented and the experimental demonstration is realized.     

高能、超短脉冲、可调谐激光器用掺镱氟磷酸盐玻璃研究进展

Yb^3 与其它稀土离子相比有最简单的能级结构，这使它具有一些独特的性质，如避免激发态吸收，消除上转换和浓度猝灭等，因此它是高能输出激光器介质的理想掺杂离子。氟磷玻璃综合了氟化物玻璃和磷酸盐玻璃的优点，可降低磷酸盐的声子能量，改善其易吸湿性；提高氟化物玻璃的物理化学性能等，这使它成为稀土掺杂可调谐光纤激光器的很好的掺杂介质。众多研究表明，Yb^3 掺杂氟磷玻璃是一种很有前途的激光工作物质。本文总结了Yb^3 掺杂氟磷玻璃的特点，性质，结构及存在的问题。     

光纤传感振动检测系统及其实验研究

实际工程结构中的振动检测是十分重要的，也是十分复杂的，常用的结构振动检测传感器易受工程现场恶劣环境的影响．而光纤传感器具有小巧、抗电磁干扰、灵敏度高、适合长期监测等优点。本文建立了基于马赫—曾德(Mech-Zehnder)干涉原理的光纤传感振动检测系统．研制了运用先进的数字信号处理技术采集和处理数据的专用软件，并在典型结构件——钢制悬臂梁结构上进行了外加信号作用下的强迫振动检测和冲击载荷作用下的自由衰减振动检测，测量了该结构件的频率及振幅，其结果与同时进行的成熟的电测结果相近，说明光纤传感器用于结构件的振动测量是可靠的。本文为光纤传感器应用于实际工程的振动检测提供了新的技术装置，具有工程应用前景。     

Light Diffraction of Aligned Polymer Fibers Periodically Dispersed by Phase Separation of Liquid Crystal and Polymer

We have confirmed light diffraction of aligned polymer fibers obtained by a phase separation of an anisotropic-phase solution of liquid crystal and polymer. He—Ne laser light passing through the polymer fibers was scattered in the axis vertical to the fibers, and had two peaks of light intensity symmetrical to the center of the transmitting laser spot. The two peaks were found to be caused by light diffraction due to the periodic polymer-fiber dispersion because the peaks corresponded to values calculated by intervals between the fibers. The periodical fiber networks are considered to be formed by anisotropic spinodal decomposition. This effect can be used to measure the dispersion order of the polymer fibers. © 2004 The Optical Society of Japan     

Completely biodegradable composites of poly(propylene carbonate) and short,lignocellulose fiber Hildegardia populifolia

The composites of biodegradable poly(propylene carbonate) (PPC) reinforced with short Hildegardia populifolia natural fiber were prepared by melt mixing followed by compression molding. The mechanical properties, thermal properties, and morphologies of the composites were studied via static and dynamic mechanical measurements, thermogravimetric analysis, and scanning electron microscopy (SEM) techniques, respectively. Static tensile tests showed that the stiffness and tensile strength of the composites increased with an increasing fiber content. However, the elongation at break and the energy to break decreased dramatically with the addition of short fiber. The relationship between the experimental results and the compatibility or interaction between the PPC matrix and fiber was correlated. SEM observations indicated good interfacial contact between the short fiber and PPC matrix. Thermogravimetric analysis revealed that the introduction of short Hildegardia populifolia fiber led to a slightly improved thermooxidative stability of PPC. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 666–675, 2004     

光纤光栅选频掺Yb3+双包层光纤激光器

利用相位掩模法 ,在D形内包层掺Yb3 双包层光纤一端直接写制出Bragg光栅 ,用作双包层光纤激光器的输出腔镜 .试验得到了线宽为 0 196nm ,波长为 10 5 8 2nm ,最高输出功率为 5 70mW的稳定激光输出 ,解决了激光器中模式竞争造成的输出不稳定现象 .从速率方程出发 ,对激光器的输出功率与抽运功率、光栅反射率的关系以及最佳光纤长度进行了理论分析 ,结果与实验符合很好     

闪烁光纤在γ射线辐照下部分特性的蒙特卡罗模拟

 闪烁光纤在射线成像方面的应用越来越广泛。为了进一步了解闪烁光纤在射线辐照下的基本特性，基于蒙特卡罗方法，利用计算机模拟分析了γ射线在闪烁光纤中的好事例率与光纤长度及射线能量的关系，能量沉积效率与光纤长度及射线能量的关系。此项工作对于闪烁光纤阵列在射线成像，剂量场测量等方面的研究很有价值。     

用楔形柱面光纤微透镜耦合的1.3μm SOA组件

运用激光模式耦合理论分析了半导体光放大器(SOA)与单模通信光纤的连接损耗,并设计制作了楔形柱面光纤微透镜用来实现两者的模斑匹配,有效地降低了器件的光耦合损耗.本文介绍了楔形柱面光纤微透镜耦合的1.3 μm半导体光放大器(SOA)组件及其制作方法.该组件的最大增益不小于14 dB,其偏振灵敏度小于1 dB,增益波动不大于0.5 dB.     

两段级联掺铒光纤放大器的优化研究

基于Giles模型,研究了980 nm和1480 nm泵浦的两段级联掺铒光纤放大器(EDFA)的设计,得出了掺铒光纤(EDF)的最佳长度和光隔离器的最佳位置随泵浦功率和信号功率的变化关系.比较980 nm和1480 nm泵浦的两段级联EDFA,可以发现,前者的最佳EDF长度短,而光隔离器最佳位置距EDFA输入端远.