贵金属掺杂锐钛矿TiO2光催化性能的第一性原理研究

本研究采用基于密度泛函理论的第一性原理方法,对纯锐钛矿TiO2及贵金属（Ru、Pd、Pt、Ag和Au）掺杂锐钛矿TiO2的晶格结构、能带结构、电子态密度及光学性质进行了计算。结果表明：贵金属掺杂后TiO2的晶格体积都出现了不同程度的增大;Pd和Pt掺杂后TiO2体系的禁带宽度减小,Ru、Ag和Au掺杂后体系表现出了一定的金属属性,五种贵金属掺杂TiO2后吸收光谱都有红移的趋势。掺杂形成能计算表明,除Ru金属外,富氧条件下掺杂更容易实现。     

Tb3+掺杂锂铝硅酸盐玻璃的光致发光和辐照致发光

采用熔融-淬冷法制备了Tb3+掺杂锂铝硅酸盐闪烁玻璃,用紫外激发光谱、发射光谱及荧光寿命表征了光致发光性能,用X射线和阴极射线激发测试了辐射致发光性能。研究结果表明：低Tb3+掺杂浓度时,随着其浓度增大,Tb3+间的交叉弛豫增加导致了5D₃→7F_j跃迁的能量逐渐向5D₄→7F_j迁移转变,5D₃激发态的荧光寿命和发射强度均明显下降,5D₄-7F_j发射强度逐渐增大。较高Tb3+浓度时,其浓度继续增加会提升非辐射比例,是荧光寿命降低和荧光猝灭的最主要原因。比较光致发光和辐照致发光性能,发现随着激发源的能量上升,会增加激发态5D₃能级向5D₄能级的能量转移,同时,由于玻璃的密度低会导致辐照致发光效率随激发源的能量上升而下降。     

S掺杂的还原态TiO2-x的制备及其可见光催化性能

作为一种稳定、价廉的光催化剂,TiO2被广泛应用于各种污染物的降解;但是,较大的宽禁带(~3.2 eV)和较低的电子迁移率不仅使TiO2很难吸收可见光,而且光生电子和空穴的复合几率高,从而导致TiO2的总体光电效率不高.因此,设计能够被可见光激发、并具有快速光生电子传输的TiO2一直是研究热点.研究表明,Ti3+自掺杂的TiO2(还原态TiO2-x)不仅能够被可见光激发,而且使TiO2具有良好的电子导电性,从而有利于提高TiO2的光电转换效率.另外,非金属元素的掺杂能够减小TiO2的禁带宽度,使TiO2能够响应可见光并具有良好的可见光催化性能,其中S元素的掺杂被广泛研究.目前,S掺杂纳米TiO2的制备通常采用TiS2,单质S,硫脲、二甲亚砜等为S源,但这类原料通常价格昂贵或者具有一定的毒性,因而实际应用受到限制.而制备Ti3+自掺杂TiO2的方法大都是基于"还原法",在真空或强还原性气氛如H2,CO中加热TiO2,或采用高能粒子(电子、氩离子)轰击.在实际应用中,这些方法存在步骤多、条件苛刻、反应时间长和设备昂贵等不足.而且,还原法反应通常发生在颗粒的表面,形成的Ti3+很容易被空气和水中的溶解O2氧化,降低材料的稳定性.虽然在温和的液相中还原Ti4+可用于制备Ti3+掺杂的TiO2,但是由于反应过程中有副产物生成,需要进行后续处理才能得到纯的Ti3+自掺杂TiO2.因此,设计一种简单的制备S掺杂还原态TiO2-x光催化剂仍具有十分重要的意义.前期我们采用H2O2氧化TiH2得到不同状态的前驱体凝胶,然后进行不同方式的后处理得到Ti3+自掺杂的纳米TiO2.本文以TiH2和H2O2反应得到的黄色前驱体凝胶为Ti源,以价格低廉、无毒、稳定的二氧化硫脲为S源和还原剂,采用不同的方法制备了S掺杂的还原态TiO2-x光催化剂.本文初步研究了在凝胶中加入二氧化硫脲后进行水热处理,以及将干燥的凝胶粉末与二氧化硫脲混合热处理对所得产物的影响.并与纯的TiO2、还原态TiO2-x和S掺杂TiO2的光吸收、电化学、光催化性能进行对比研究.采用X射线衍射、透射电子显微镜、高分辨透射电子显微镜、X-射线光电子能谱、紫外-可见漫反射光谱、比表面分析和电化学工作站等技术对产物的结构、形貌和光电性能进行了表征.以罗丹明B(RhB)溶液为模拟废水,考察样品的可见光催化性能.结果表明,不同的后续处理方式不仅影响S掺杂TiO2-x的结晶性和形貌,而且影响产物的光吸收性能和电子传输性能,从而使不同条件下所得产物的可见光催化性能不同.其中,采用热处理方式得到的S掺杂TiO2-x样品在可见光下降解RhB的速率分别是纯的TiO2,TiO2-x和S掺杂TiO2的31,2.5和3.6倍,而且样品具有良好的循环稳定性.     

Photodegradation of Rhodamine B on Sulfur Doped ZnO/TiO2 Nanocomposite Photocatalyst under Visible-light Irradiation

Sulfur doped ZnO/TiO₂ nanocomposite photocatalysts were synthesized by a facile sol‐gel method. The structure and properties of catalysts were characterized by X‐ray diffraction (XRD), X‐ray photoelectron spectroscopy (XPS), UV‐vis diffusive reflectance spectroscopy (DRS) and N₂ desorption‐adsorption isotherm. The XRD study showed that TiO₂ was anatase phase and there was no obvious difference in crystal composition of various S‐ZnO/TiO₂. The XPS study showed that the Zn element exists as ZnO and S atoms form SO^2?₄. The prepared samples had mesoporosity revealed by N₂ desorption‐adsorption isotherm result. The degradation of Rhodamine B dye under visible light irradiation was chosen as probe reaction to evaluate the photocatalytic activity of the ZnO/TiO₂ nanocomposite. The commercial TiO₂ photocatalyst (Degussa P25) was taken as standard photocatalyst to contrast the prepared different photocatalyst in current work. The improvement of the photocatalytic activity of S‐ZnO/TiO₂ composite photocatalyst can be attributed to the suitable energetic positions between ZnO and TiO₂, the acidity site caused by sulfur doping and the enlargement of the specific area. S‐3.0ZnO/TiO₂ exhibited the highest photocatalytic activity under visible light irradiation after Zn amount was optimized, which was 2.6 times higher than P25.     

Co~(2+)掺杂的纳米TiO_2薄膜光催化特性及电化学阻抗谱研究

本文采用交流电沉积技术,在多孔氧化铝模板中合成出Co2+掺杂的纳米TiO2薄膜(Co2+/TiO2薄膜)。以次甲基蓝为降解物,研究了纳米Co2+/TiO2薄膜在可见光下的催化性能,考察了阳极偏压对光催化活性的影响。用电化学阻抗谱(EIS)研究了纳米Co2+/TiO2薄膜在次甲基蓝溶液中的电化学行为,给出了相应的等效电路和半导体能带结构参数-空间电荷层宽度。研究表明,适量Co2+掺杂可以提高TiO2薄膜的光催化活性。在Co2+/TiO2膜电极上施加一定阳极偏压,使空间电荷层宽度增加,因此能有效实现光生电子-空穴分离,进一步提高次甲基蓝的光催化降解效率。     

Sensitive Determination of the Diquat Herbicide in Fresh Food Samples on a Highly Boron‐Doped Diamond Electrode

The highly boron‐doped diamond electrode (HBDD) combined with square wave voltammetry (SWV) was used in the development of an analytical procedure for diquat determination in potato and sugar cane samples and lemon, orange, tangerine and pineapple juices. Preliminary experiments realised in a medium of 0.05 mol L^?1 Na₂B₄O₇ showed the presence of two voltammetric peaks around ?0.6 V and around ?1.0 V vs. Ag/AgCl/Cl^? 3.0 mol L^?1, where the first peak could be successfully used for analytical proposes due the facility in the electrode surface renovation. After the experimental and voltammetric optimisation, the calculated detection and quantification limits were 1.6×10^?10 mol L^?1 and 5.3×10^?10 mol L^?1 (0.057 µg L^?1 and 0.192 µg L^?1, respectively), which are lower than the maximum residue limit established for fresh food samples by the Brazilian Sanitary Vigilance Agency. The proposed methodology was used to determine diquat residues in potato and sugar cane samples and lemon, orange, tangerine and pineapple juices and the calculated recovery efficiencies indicated that the proposed procedure presents higher robustness, stability and sensitivity, good reproducibility, and is very adequate for diquat determination in complex samples.     

Simultaneous Differential Pulse Voltammetric Determination of Ascorbic Acid and Caffeine in Pharmaceutical Formulations Using a Boron‐Doped Diamond Electrode

A cathodically pretreated boron‐doped diamond electrode was used for the simultaneous anodic determination of ascorbic acid (AA) and caffeine (CAF) by differential pulse voltammetry. Linear calibration curves (r=0.999) were obtained from 1.9×10^?5 to 2.1×10^?4 mol L^?1 for AA and from 9.7×10^?6 to 1.1×10^?4 mol L^?1 for CAF, with detection limits of 19 μmol L^?1 and 7.0 μmol L^?1, respectively. This method was successfully applied for the determination of AA and CAF in pharmaceutical formulations, with results equal to those obtained using a HPLC reference method.     

Hydrothermal Synthesis and Characterization of Ce_(1-x)Mn_xO_(2-δ) Solid Solutions

Nanocrystals of Ce1-xMnxO2-δ(x=0.00,0.05,0.10,0.15,and 0.20) were synthesized by a hydrothermal reaction route.The solid solutions crystallized in a cubic fluorite structure with a particle size in the range of 11～15 nm.The incorporation of Mn ions in CeO2 resulted in a lattice volume reduction.Mn ions showed a mixed valence state of +2,+3 and +4 in CeO2 lattice.An obvious red-shift of the absorption threshold edge was observed from the UV-visible spectrum.Compared with the bulk CeO2,Ce1-xMnxO2-δ nanocrystals exhibited a lower releasing oxygen temperature as indicated by TPR technique.     

Full L-band coverage of multiwavelength erbium-doped fiber laser

We propose and experimentally demonstrate a dual-pass unbalanced in-line Sagnac interferometer as a novel comb filter for implements in erbium-doped fiber lasers to obtain wide wavebands of multiwavelength radiations with enhancements of signal-to-noise ratios (SNRs). The hybrid combinations of the comb filter with the two schemes of nonlinear polarization rotation and intensity dependent loss have successfully not only enlarged the lasing bandwidth up to 47 nm but also enhanced the SNR up to 40 dB. The simultaneous lasing-wavelengths of 117 channels are also obtained. The multiwavelength lasing spectra with free spectral range of 0.4 nm covering the full L-band are useful for the applications of DWDM and WDM-PON systems.     

All-optical method of developing a phase encoded latch by using EDFA

Optics has already proved its meaningful application in information processing and computation, where the parallelism of light is exploited to achieve the desired result. In this communication a novel concept of all-optical memory unit based on phase encoding process is proposed. The unit is simple in architecture comprising phase sifters, mirrors (M′) and two blocks of Erbium doped fiber amplifier. The optical feedback is supported by use of beam splitters and mirrors. It is independent of intensity and therefore requires a small switching power and can work at a bit rate far above 100 Gb/s.