New FIR laser lines and frequency measurements in CD3OD

Twenty-four new submillimeter laser lines in fully deuterated methyl alcohol (CD₃OD) in the wavelength range from 52 to 328 m have been obtained in a Fabry-Perot FIR resonator by optically pumping the methanol with a cw CO₂ laser. We have made accurate wavelength measurements and have determined the relative polarization of most of the known CD₃OD laser lines. The frequencies of 13 of the strongest lines were also measured.Contribution of the U.S. Government, not subject to copyright.     

Frequencies and wavelengths from a new, efficient FIR lasing gas: CD2F2

We report for the first time wavelength, relative polarization, and frequency measurements for 47 new cw FIR laser lines in the wavelength region from 120 to 1714 m, all obtained by optically pumping CD₂F₂ with a CO₂ laser. Relative output powers were also measured. For comparison, the 189.8 m line pumped by R_I(34) is nearly five times as efficient as the 118.8 m methyl alcohol line.Contribution of the U.S. Government, not subject to copyright.     

大口径光学元件波前调制PSD模拟分析

 使用PSD作为大口径光学元件表面加工质量的评价参数，针对不同的波前调制进行了初步的模拟计算，得到了不同调制频率和不同调制深度情况下的PSD曲线变化情况。当调制频率不同时，PSD曲线的突变部分会发生相应的频移，调制频率高则突变发生在空间频率较高的频段，同时PSD峰值不变。相对应调制深度不同时，PSD曲线的突变部份峰值发生变化，调制深度大则峰值大，与此同时峰值出现的位置不会发生变化。计算和分析结果表明PSD分析结果能够在频率域反应出元件表面受到的不同程度的调制信息。     

回旋速调管放大器输出腔的特性研究

 利用变截面波导的耦合模理论，根据输出腔中电场幅值分布函数所满足的微分方程组，编写了具有自动优化功能的计算程序，分析研究了不同渐变角度、考虑腔体损耗前后和输出腔与外电路失配时，谐振频率、腔体品质因数和高频场幅值沿轴分布的变化情况，为进一步研究高频场与电子注的互作用和输出腔奠定了基础。     

强流射频四极加速器输入耦合环的物理设计研究

 详细讨论了强流射频四极加速器高频输入耦合环的一些基本问题，完成了高频输入耦合环的初步物理设计. 利用二维程序Superfish 的一些结果，确定了耦合环的大小，计算了耦合环的功耗，并对构成耦合环导线的粗细进行了估算。该耦合环的物理设计可作为耦合环试验的基础，同时，也可作为三维程序HFSS 模拟计算的起点。     

Frequency and voltage-dependent electrical and dielectric properties of Al/Co-doped PVA/p-Si structures at room temperature

In order to investigate of cobalt-doped interracial polyvinyl alcohol （PVA） layer and interface trap （Dit） effects, A1/p- Si Schottky barrier diodes （SBDs） are fabricated, and their electrical and dielectric properties are investigated at room temperature. The forward and reverse admittance measurements are carded out in the frequency and voltage ranges of 30 kHz-300 kHz and -5 V-6 V, respectively. C-V or er-V plots exhibit two distinct peaks corresponding to inversion and accumulation regions. The first peak is attributed to the existence of Dit, the other to the series resistance （Rs）, and interfacial layer. Both the real and imaginary parts of dielectric constant （er and err） and electric modulus （Mr and Mrr）, loss tangent （tan~）, and AC electrical conductivity （aac） are investigated, each as a function of frequency and applied bias voltage. Each of the M~ versus V and Mrr versus V plots shows a peak and the magnitude of peak increases with the increasing of frequency. Especially due to the Dit and interfacial PVA layer, both capacitance （C） and conductance （G/w） values are strongly affected, which consequently contributes to deviation from both the electrical and dielectric properties of A1/Co-doped PVA/p-Si （MPS） type SBD. In addition, the voltage-dependent profile of Dit is obtained from the low-high frequency capacitance （CLF-CHF） method.     

Crack detection of a double-beam carrying a concentrated mass

This paper presents the influence of a concentrated mass location on the natural frequencies of a cracked double-beam. The double-beam consists of two different beams connected by an elastic medium. The concentrated mass is located on the main beam. The relationship between the natural frequency and the location of concentrated mass is established and called “Frequency–Mass Location” (FML). The numerical simulations show that when there is a crack, the frequency of the double-beam changes irregularly when the concentrated mass is attacked at the crack position. This irregular change can be amplified by the wavelet transform and this is useful for crack detection: the crack location can be detected by the location of peaks in the wavelet transform of the FML. Finite element model for the cracked double-beam carrying a concentrated mass is presented and numerical simulations are also provided.     

Signal modeling using the gradient search

This letter presents a new method for continuous signal modeling. Firstly, the continuous signal can be represented as a function of the trigonometric functional extension (Fourier series). Fourier series of the signal are parameterized by the fundamental frequency and unknown parameters. Then, the gradient-based iterative identification algorithm is derived, for estimating parameters of the signal model with known and unknown frequencies, separately. Finally, the simulation results indicate that the proposed algorithm is effective.     

Salt effect on molecular orientation at air/liquid methanol interface

The salt effects on molecular orientation at air/liquid methanol interface were investigated by the polarization-dependent sum frequency generation vibrational spectroscopy(SFG-VS). We clarified that the average tilting angle of the methyl group to be u = 308 58 at the air/pure methanol surface assuming a d-function orientational distribution. Upon the addition of 3 mol/L Na I, the methyl group tilts further away from the surface normal with a new u = 418 38. This orientational change does not explain the enhancement of the SFG-VS intensities when adding Na I, implying the number density of the methanol molecules with a net polar ordering in the surface region also changed with the Na I concentrations. These spectroscopic findings shed new light on the salt effects on the surfaces structures of the polar organic solutions. It was also shown that the accurate determination of the bulk refractive indices and Raman depolarization ratios for different salt concentrations is crucial to quantitatively interpret the SFG-VS data.