添加剂对PVDF相转化过程及膜孔结构的影响

研究了PVP、PEG及LiCl 3种成孔添加剂下PVDF DMAc H2 O 添加剂体系的成膜机理 .无论那种添加剂的铸膜液相转换成膜过程中都存在凝胶分相和液液分相两种相变方式 ,在 30～ 6 0℃时凝胶分相在较低的非溶剂浓度下先于液液分相发生 ,LiCl作为添加剂较PEG、PVP对铸膜液有较强的致凝胶作用 ,成膜过程中凝胶分相段时间依PVP、PEG、LiCl的顺序延长 ,导致液液分相初始分相点处聚合物浓度增大 ,阻止了大孔结构的充分发展 .制得的膜依PVP、PEG、LiCl的顺序有效孔隙率和通量降低 ,结晶度升高 .以LiCl为添加剂制得的膜几乎不改变PVDF膜的疏水性 ,而以PVP或PEG为添加剂的膜隔水压差降低约 2 0kPa .     

Direct separation of the enantiomers of cetirizine and related compounds by reversed-phase chiral HPLC

Summary Direct separations of the enantiomers of cetirizine and related compounds have been achieved by reversed-phase HPLC on the Chiralcel OD-R, a polysaccharide-derived chiral stationary phase; the mobile phase was usually perchlorate solution supplemented with acetonitrile. Resolution of the enantiomers of cetirizine and related compounds was good. The effect of the acetonitrile content of the mobile phase was investigated, and the effect of the structure of the chiral compounds on their behavior on the Chiralcel OD-R column is discussed.     

Enantiomeric separation of amphetamine,methamphetamine and ring substituted amphetamines by means of a β-cyclodextrin-chiral stationary phase

Summary The enantioseparation of amphetamine, methamphetamine and various ring-substituted amphetamines by use of a chiral stationary phase carrying immobilized native -cyclodextrin (-CyD) selectors is reported. The system is evaluated for resolving the specified compounds directly without any derivatization and after derivatization with phenyl isothiocyanate (PITC), naphthyl isothiocyanate (NITC) and 6-aminoquinolyl-N-hydroxysuccinimidyl carbamate (AQC). This direct enantioseparation is compared with the features of indirect separation of diasteromeric derivatives after reaction with the optically pure Marfey's reagent employing a simple non-chiral alkyl-silica (RP-8) column. A selection of those methods best suited for each single amphetamine is given.Seventeen different samples of amphetamine, confiscated by the Swedisch police, were analyzed with respect to their enantiomeric composition. Within this set of samples synthesized by the same method no significant deviation from a racemic ratio could be observed.     

5种生物胺的毛细管胶束电动色谱分离

在胶束电动色谱模式下考察了影响生物胺分离的几个因素(如缓冲溶液及SDS浓度、pH、表面活性剂、分离温度及外加电压等)并优化了分离条件,建立了一种简单快速的利用毛细管胶束电动色谱DAD检测器分离分析生物胺的新方法。当缓冲溶液为40mmol/L硼酸缓冲液(pH8.5)、68mmol/LSDS,分离电压为25kV、分离温度为25℃时,5种生物胺在7min内实现了令人满意的基线分离。在优化的条件下,对其线性范围、检出限和重现性进行了测定。结果表明,生物胺的迁移时间的重现性<0.8%,面积的重现性<4%。     

配体交换毛细管区带电泳拆分未衍生化氨基酸

以铜（Ⅱ）-L-谷氨酸络合物为手性分离选择剂，对苯丙氨酸、酪氨酸和色氨酸3种非衍生芳香族氨基酸的手性对映体拆分进行了研究，建立了一种快速、简便拆分未衍生化的氨基酸对映体的配体交换毛细管电泳方法。在使用10mmol／L NH4AC（pH5．0），5mmol／L CuSO4和10mmol／L L-谷氨酸的条件下，成功地拆分了苯丙氨酸、酪氨酸手性对映体；色氨酸手性对映体也得到部分分离；考察了电泳缓冲液组成、pH值等影响分离效果的因素。     

Resolution of lymphocyte subpopulations derived from rat spleen by polyamine-graft-PHEMA copolymer

The retention behavior of lymphocyte subpopulations, B cell, T cell and null cell, derived from rat spleen to polyamine-graft-poly(2-hydroxyethyl methacrylate) copolymer (HA) surface was investigated, focusing on the conformational transition of the polyamine side chain as well as the protonation of amino groups in the polyamine grafts. Furthermore, the availability of HA was discussed as a column adsorbent for separation of lymphocyte subpopulations derived from spleen. The conformational transition of polyamine grafts significantly influenced the mode of retention of lymphocyte subpopulations. When polyamine grafts existed in an aggregated conformation (protonatin degree α < 0.5), the retention of lymphocyte subpopulations was decreased in the order B cell> null cell> T cell. On the other hand, when polyamine existed in an extended conformation into the aqueous interior from the matrix interface (α > 0.5), T cell retention became greater than null cell retention, resulting in a decreased B cell> T cell> null cell order. These results indicate that the differential retention of spleen lymphocyte subpopulations is attributed to their differential responses to the change in matrix interface accompanied by the protonation of amino groups. Furthermore, spleen lymphocytes were compared with lymph node lymphocytes in terms of resolution efficacy by an HA copolymer column.     

Fine characterization of the ethylene and ethane sorption in poly(amide 12-block-tetramethylenoxide) copolymer/AgBF4 membranes

Ethylene/ethane sorption characteristics were determined for dry Pebax™ (poly(amide 12-block-tetramethylenoxide) copolymer)/AgBF₄ membranes by using an electronic microbalance. The membranes containing 0.7 and 22 wt.% AgBF₄ showed a dual-mode sorption isotherm. The ethane isotherms for all the membranes were of the Henry-type, which is the normal sorption for gases in rubbery polymers. The abnormal presence of Langmuir sorption sites only for ethylene in the rubbery copolymer, never reported sofar, is attributed to the silver-based specific complexation sites. The silver salt which dissolved in limited amounts in the rubbery copolymer had a much smaller Langmuir sorption capacity than the salt that crystallized in the copolymer. The sorption kinetics indicate that the crystallized salt did adsorb slowly ethylene according to a zeroth-order kinetics, but not ethane. The gas uptake kinetics resulting from a step of the pressure surrounding the copolymer exhibited one stage for ethane but two stages for ethylene. For the latter, there was first a fast Fickian sorption stage, then a drift of the zeroth-order sorption of ethylene on salt crystals, which contributes for a large part to the total uptake. The zeroth-order sorption suggests that the sorbed ethylene amount in the second-stage is independent of the crystal-surface coverage. The value of the Fickian diffusion coefficient calculated by fitting the kinetics with a solution of the second Fick’s law was 5 × 10⁻¹² m²/s for both ethylene (the first stage) and ethane, and is typical for small organic compounds in a rubbery material.     

Phase separation of poly(γ-benzyl L-glutamate) to liquid crystal and isotropic solution in various helicogenic solvents

Solvent effects on the phase separation of poly(-benzyl L-glutamate) to liquid crystal and isotropic solution have been observed in various helicogenic solvents. The temperature-composition phase diagrams have been determined for each solution. The critical concentrations, ₂ ^* , at which the phase separation occours have been compared in various solvents. In dimethylformamide in which the polymer is molecularly dispersed, the observed ₂ ^* value has agreed with that calculated by Flory's theory. In some solvents in which the polymer aggregates in a head-to-tail mode such as chloroform, the observed ₂ ^* values have been considerably small. It is assumed that the polymer aggregates behave as longer particles than the original particles. In dioxane in which the polymer aggregates highly both in a head-to-tail and a side-by-side modes, the ₂ ^* value has been a little larger than that in chloroform. In this case the relationship between the aggregation and the liquid crystal formation is so complicated that further investigation is necessary. In aromatic solvents such asm-cresol that dissolves the polymer almost molecularly, the ₂ ^* is smaller than that in dimethylformamide. Therefore, the intermolecular interactions between the phenyl groups in the side groups of the polymer and those in solvent molecules must be considered.The author is grateful to Mr. K. Sano and Mr. M. Watanabe for their observation of the liquid crystal formation.     

Chiral separation of 1,1'-bi-2-naphthol and its analogue on molecular imprinting monolithic columns by HPLC

Two molecular imprinting polymer (MIP) monolithic columns with (S)-(-)-1,1'-bi-2-naphthol and (R)-(+)-5,5',6,6',7,7',8,8'-octahydro-1,1'-bi-2-naphthol as the templating molecules, respectively, have been prepared by in situ polymerization using 4-vinylpyridine and ethylene dimethacrylate as functional monomer and cross-linker, respectively. The columns with good flow-through properties were obtained by changing the molar ratio of the functional monomer and the template molecule. The effects of mobile-phase composition on separation of enantiomers were systematically investigated. The results indicate that hydrophobic interaction in aqueous solution and hydrogen-bonding interaction in ACN between the enantiomers and polymers could play important roles in the retention and resolution. The effects of chromatographic conditions, such as flow rate, column temperature, sample loading, on the enantioseparation were also studied. Further, these two MIP columns show a cross-reactivity.     

Preparation and characterization of silica—polyimide composite membranes coated on porous tubes for CO2 separation

Silica-polyimide microcomposite membranes were prepared on γ-alumina-coated α-alumina support tubes, and their gas permeation properties were evaluated with He, N₂ and CO₂. Smoothing of the substrate surface and hybridization of silica and polyamic acid were both effective to form defect-free thin composite membranes. The CO₂ permeance of a membrane with a silica content of 68 wt% was one order of magnitude higher than that of a polyimide membrane having the same thickness. The permselectivity of CO₂ to N₂ was 30 at 30°C and 13 at 100°C. Contributions of the silica and polyimide phases to permeance of the composite membrane were analyzed with a two-phase permeation model. The effective thickness of the rate-controlling polyimide phase was less than one-tenth of the total thickness of the silica-polyimide membrane.