Anodic stripping voltammetry of sulphide at a nickel film: towards the development of a reagentless sensor

The determination of sulphide at an electrochemically generated nickel oxide layer at glassy carbon and screen-printed electrodes in acidic media has been examined and appraised. The NiO layer was found to produce a stripping-like signal to sulphide and gave a linear peak current response from 20 to 90 μM. The response was further enhanced by repetitive cycling allowing accumulation of nickel sulphide at the electrode surface such that lower micromolar levels of sulphide (i.e. 5 μM) can be determined. The response at the NiO layer to sulphide is shown to be reproducible over a period of 24 h, thereby offering the development of a disposable amperometric sensor for sulphide.     

Concentration profiles and breakthrough curves in non-linear chromatography

The treatment of the non-linear isotherm in chromatography by one of the authors [1] is extended to other cases of practical interest. The original paper dealt with the case of an initially thin zone resulting in a Poisson distribution the asymmetry of which is a function of the plate number and the non-linearity constant. The present work shows that the same relations apply to initially thick zones and to the cases of washing and deposition leading to simple relations for breakthrough curves. For significantly non-linear isotherms other quasi-Gaussian distributions can give a better fit.     

苯胺类化合物的电化学氧化及随后化学反应

利用循环伏安法研究了二取代对苯二胺(1),四取代对苯二胺(2)和二取代氨基酚(3)三类化合物以及它们的衍生物的电化学行为及其氧化产物的随后不可逆脱氨反应。 1类化合物在任何pH下的电化学氧化均为一步双电子转移反应,2类化合物为二步单电子转移反应;3类化合物在酸性和中性范围为一步双电子氧化在碱性溶液中为二步单电子转移反应。文中定量求算了不可逆随后化学反应的表观水解速率常数k_f,并进行了讨论。     

铬(Ⅵ)与谷胱甘肽作用及其中间态配合物形成的电化学表征

本文采用电化学方法，对谷胱甘肽(GSH)与重铬酸钾的相互作用及其中间态配合物的形成过程进行研究。结果表明：在pH=5.6的HAc-NaAc缓冲溶液中，GSH浓度为Cr(Ⅵ)浓度5倍以上时，Cr(Ⅵ)与GSH作用完全并形成一新的中间态配合物，该中间态配合物于+0.21 V和+0.36 V(vs SCE)处产生一对新的氧化还原峰，UV-Vis的吸收光谱进一步证明了中间态配合物的形成。该配合物不稳定，在一定时间内缓慢分解，其电化学与UV-Vis光谱动力学信息同步。进一步探讨了GSH与Cr(Ⅵ)作用的电极反应机理。当Zn(Ⅱ)存在于该体系时，Zn(Ⅱ)对中间态配合物的生成和分解过程起着双向催化作用。     

Variable Mott-Schottky plots acquisition by potentiodynamic electrochemical impedance spectroscopy

Potentiodynamic electrochemical impedance spectroscopy provides extraction of potential-dependent space charge layer capacitance from potentiodynamic impedance spectra of non-stationary semiconductor–electrolyte interface. The new technique has been applied for acquisition of Mott-Schottky plots of cathodically treated TiO₂ anodic films. Cathodic treatment in 1 M H₂SO₄ increases donor density and flat band potential of TiO₂. Freshly doped films show hysteresis in the space charge layer capacitance in cyclic potential scans. The subsequent cycling eliminates the hysteresis but preserves the greater part of the doping effect. Presented at the 4th Baltic Conference on Electrochemistry, Greifswald, 13–16 March 2005     

Microstructure and electrical properties of BaTiO<Subscript>3</Subscript> and (Ba,Sr)TiO<Subscript>3</Subscript> ferroelectric thin films on nickel electrodes

Nickel thin films have been sputtered on standard Si/SiO₂ substrates with TiO₂ as an adhesive layer. The thermal stability of these substrates was analyzed. SEM images show an increase in grain size with annealing temperature. They were found to be stable till 800°C, beyond which the nickel layer disintegrated. These substrates were used for deposition of BaTiO₃ and (Ba,Sr)TiO₃ dielectric thin films under a reducing atmosphere. The dielectric thin films were processed with various pyrolysis and annealing temperatures in order to optimize the dielectric properties. Increased pyrolysis temperatures showed an increase in the grain size. Results on these nickelised substrates were finally compared with dielectric films deposited on platinized silicon substrates under identical conditions but crystallized in an oxygen atmosphere.     

Applicability of the Levich Equation for a Two-Phase Solution in the Rotating Disk Electrode System

The mass-transter characteristics of a two-phase system formed by mixing a fixed quantity (20 v/v%) of organic solvent with an aqueous ferricyanide electrolyte solution in an RDE system were studied. The Levich eqution, I₁ = 0.62 nFAC_bD^2/3v^?1/6_ω^1/2, was found to be applicable to the two-phase system with only a minor modification in the angular velocity (ω) at Reynolds numbers between 3–5 × 10⁴. The experimental results indicate that the interfacial tension is the most important variable for the two-phase system. One group of organic solvents with smaller interfacial tension, such as benzene or toluene, needs a modification of the Levich equation by replacing the observed angular velocity (ω_o) with the true angular velocity (ω_t) which was observed to be 1.1 times the observed angular velocity. For the other group with larger interfacial tension, such as n-hexane or cyclohexane, there is no need to modify the observed angular velocity. In other words, the Levich equation may be expressed as I₁ = 0.65 nFAC_bD^2/3v^?1/6ω^1/2 for two-phase solution if the interfacial tension is smaller than 37.0 dyne/cm.     

Mass transport in gas channels of electrochemical cells with a solid-oxide electrolyte: Allowing for the electrode reaction rates in numerical calculations

The concentration fields, Nusselt number distributions along the electrode, and ratios of concentrations of electrochemically active components at the entrance into and exit out of an electrochemical cell are determined by numerical integration of the convective-diffusion equation for a broad range of rate constants of electrode reactions, Peclet numbers, and geometrical parameters of channels. Three regions of parameter values are revealed. At low reaction rates (K _l < 0.5), mass transfer is completely determined by electrode kinetics; at high rates (K _l > 20), it is completely determined by the diffusion in the gas phase; and in the intermediate region of values of K _l it is necessary to allow for both the diffusion processes and the electrode reactions.Translated from Elektrokhimiya, Vol. 41, No. 3, 2005, pp. 317–324.Original Russian Text Copyright © 2005 by Ezin, Somov.     

2,2''''-联吡啶和亚铁氰化钾对乙醛酸化学镀铜的影响

以乙醛酸作还原剂、Na2EDTA为络合剂、2,2'-联吡啶和亚铁氰化钾作为添加剂组成化学镀铜体系,研究了两种添加剂对化学镀铜速率、镀层表面形貌、组成和结构的影响.结果表明:添加适量的2,2'-联吡啶和亚铁氰化钾,不仅提高了镀液的稳定性,而且使沉积速率增加1倍.这两种添加剂的同时使用,使镀层颜色变亮,形貌发生变化.所得镀层是多晶铜,没有发现夹杂Cu20.     

Chemical Liquid Phase Deposition of Thin Aluminum Oxide Films

Introduction Inorganic oxide films have attracted a lot of interest in the last several decades. Among them, silicon dioxide films are widely used in modern microelectronics, optics and mechanics. This material has been grown by various methods including thermal oxidation, chemical vapor phase deposition, plasma-enhanced chemical vapor phase deposition, and so on.1,2 Recently, Nagayama et al.3 have reported that SiO2 thin films could be produced by a new chemical method of liquid phase depos…