温压炸药能量输出结构的初步研究

为了研究温压炸药后燃反应及其对空中爆炸冲击波的影响规律,采用实验和数值模拟相结合的方 法对温压炸药能量输出结构进行了初步研究。结果表明,距爆心较近时冲击波压力时程曲线上呈现两个峰 值,而在较远处则存在较宽的正压作用区,该炸药正压作用区冲量为相同质量TNT的约1.6~1.8倍。并根 据JWL-Miller模型参数得出后燃反应释放的能量占总能量的约1/3,以及非理想组分反应度随时间的变化 关系,在完全燃烧的理想情况下,后燃持续时间可达400ms。说明温压炸药中铝粉等高能添加剂的后燃反应 对增强冲击波效应和提高炸药做功能力有显著贡献。     

Performance Analysis and Four-Objective Optimization of an Irreversible Rectangular Cycle

Based on the established model of the irreversible rectangular cycle in the previous literature, in this paper, finite time thermodynamics theory is applied to analyze the performance characteristics of an irreversible rectangular cycle by firstly taking power density and effective power as the objective functions. Then, four performance indicators of the cycle, that is, the thermal efficiency, dimensionless power output, dimensionless effective power, and dimensionless power density, are optimized with the cycle expansion ratio as the optimization variable by applying the nondominated sorting genetic algorithm II (NSGA-II) and considering four-objective, three-objective, and two-objective optimization combinations. Finally, optimal results are selected through three decision-making methods. The results show that although the efficiency of the irreversible rectangular cycle under the maximum power density point is less than that at the maximum power output point, the cycle under the maximum power density point can acquire a smaller size parameter. The efficiency at the maximum effective power point is always larger than that at the maximum power output point. When multi-objective optimization is performed on dimensionless power output, dimensionless effective power, and dimensionless power density, the deviation index obtained from the technique for order preference by similarity to an ideal solution (TOPSIS) decision-making method is the smallest value, which means the result is the best.     

激光二极管端面抽运Tm,Ho:YLF激光器双稳特性研究

报道了波长为792 nm激光二极管端面抽运Tm,Ho:YLF连续激光器的双稳输出特性.激光晶体温度为283 K时,双稳区的宽度为100 mW,跃变点输出功率的跃变量为15 mW.实验上还研究了晶体温度对2 μm激光双稳特性的影响,当晶体温度从283 K升高到298 K时,双稳区的宽度由100 mW减小到60 mW,跃变点输出功率的跃变量由15 mW下降到6 mW.通过分析可知,Tm,Ho:YLF连续激光器的双稳输出是由能量转递上转换、激发态吸收以及激光下能级对2 μm输出激光再吸收共同作用的结果. 关键词： 端面抽运 Tm Ho:YLF晶体 连续输出 光学双稳     

双波长数据包并行缓存

以半导体光放大器为非线性元件的双环耦合全光缓存器(DLOB)为基础,实现了速率为2.5 Gb/s双波长数据的并行缓存.不同波长光信号合成后的功率随机波动,导致由半导体光放大器交叉相位调制产生的相位差随机波动.在考虑吸收损耗的情况下,对常用的半导体光放大器增益特性曲线进行了修正并与实测值拟合,得到了更为准确的增益特性曲线.在此基础上进行了理论分析,提出了通过调节控制光功率到最佳点以便减小相位差波动的方法.     

烟火泵浦钕玻璃激光器出光实验研究

 烟火泵浦是激光器小型化、便携化的一种解决方法。研制了一种用于钕玻璃激光器泵浦源的化学试剂,其主要成分为金属粉和碱金属含氧酸盐。设计了烟火泵浦钕玻璃激光器实验装置,激光器采用平-凹腔结构、紧包型侧面泵浦,输出镜反射率98％,钕玻璃棒尺寸f8 mm×100 mm。采用A,B两种配方的泵浦源进行出光实验,A配方得到了波长为1 053 nm能量为29 mJ的激光,B配方没有出光。分别计算了两种泵浦源的阈值辐射强度,并与测量得到的药剂辐射强度平均值比较。A配方所提供的辐射强度2.68×104 W·sr^-1,大于阈值2.37×104 W·sr^-1;B配方小于阈值,未能出光。这与实验结果吻合,证明烟火泵浦方法可行。     

S波段速调管双间隙输出腔的设计和实验研究

 介绍了S波段强流相对论速调管放大器(RKA)双间隙输出腔高频系统的设计,并利用3维粒子模拟程序模拟和优化了短脉冲强流相对论调制电子束经过双间隙输出腔后的微波提取。在束压640 kV、束流6 kA、基波调制深度80%的条件下,模拟得到功率为1.1 GW的微波,频率约为2.85 GHz,效率28%。在高频分析和粒子模拟的基础上进行了实验研究,实验中采用束压640 kV、束流6 kA的环行电子束,经过优化调节RKA参数,在中间腔后得到了约4.6 kA的基波调制电流,加上双间隙提取腔后从该RKA获得了频率为2.9 GHz、功率为1 GW、脉宽22 ns的输出微波,束波转换效率26%。     

600 kV波形可调快前沿脉冲源的研制

 介绍了一种波形可调的高电压快前沿脉冲源。该脉冲源由Marx发生器、脉冲成型组件、主开关、匹配负载、分流电阻、串联电感等部件构成。各部件自成一体,呈模块化分布。以Marx发生器作为初级储能,通过调节发生器输出端分流电阻、串联电感及脉冲成型组件等模块,可以输出包括双指数波和方波在内的5种脉冲波形。输出脉冲幅值在200~600 kV范围内可调,最小脉冲前沿可达2 ns。     

Nd:YVO4复合腔激光器双波长激光输出及腔内和频研究

 采用两个重叠的共线支腔构成的三镜复合腔,实现LD泵浦的Nd:YVO₄激光器的1 064 nm和1 342 nm双波长激光运转。根据双波长振荡阈值相等条件,数值计算了1 064 nm支腔和1 342 nm支腔的腔长、支腔的输出耦合镜透过率之间的关系。合理选择两个支腔的参数,当泵浦功率13 W时,获得1 064 nm激光功率1.59 W,1 342 nm激光功率1.17 W的双波长激光输出。在满足腔内1 064 nm 和1 342 nm双波长光子数密度相等的条件下,计算了腔内和频的复合腔Nd:YVO4激光器的腔参数。采用Ⅱ类临界相位匹配KTP晶体作为和频器件,当808 nm泵浦光功率为12 W时,获得340 mW的和频593 nm激光输出。     

High-power terahertz radiation from surface-emitted THz-wave parametric oscillator

We report a pulsed surface-emitted THz-wave parametric oscillator based on two MgO:LiNbO3 crystals pumped by a multi-longitudinal mode Q-switched Nd:YAG laser.Through varying the phase matching angle,the tunable THzwave output from 0.79 THz to 2.84 THz is realized.The maximum THz-wave output was 193.2 nJ/pulse at 1.84 THz as the pump power density was 212.5 MW/cm 2,corresponding to the energy conversion efficiency of 2.42×10-6 and the photon conversion efficiency of about 0.037%.When the pump power density changed from 123 MW/cm 2 to 148 MW/cm 2 and 164 MW/cm 2,the maximum output of the THz-wave moved to the high frequency band.We give a reasonable explanation for this phenomenon.