Laser spectroscopic investigation of a new precursor-type polyparaphenylenevinylene

Optical, structural and morphological properties of thin films of polyparaphenylenevinylene (PPV) formed by an alkyl sulfinyl precursor route have been studied. Thin films were fabricated on an optical glass and on quartz glass either by spin-coating of the precursor solution or by layer-by-layer deposition using Langmuir–Blodgett technique. PPV precursor films were also spin-coated on gold-coated glass in order to study thin-film optical parameters by surface plasmon spectroscopy. We have been successful in forming about 40 precursor mono layers on quartz glass by Langmuir–Blodgett technique using optimized surface pressure and dipping conditions. After thermal conversion of the precursor layers good quality fluorescent PPV films of yellow colour have been obtained. Optical characterization of the films was carried out by linear absorption and emission spectroscopy, ellipsometry, and surface plasmon spectroscopy. Structural and morphological studies on the thin films were carried out by using X-ray scattering and atomic force microscopy. Wave-guided travelling-wave laser action has been achieved in a PPV film on quartz glass. The sample was transversally pumped with picosecond laser pulses (wavelength 347.15 nm, duration 35 ps). Laser emission occurred at 550 nm for pump pulse energy densities above .     

Rugged distal tips for CO2 laser medicine

Low-loss and rugged distal tips for CO₂ laser have been proposed and fabricated based on a commercially available stainless steel (St) pipe. A method of smoothening the inner surface of the St pipe with a rough inner surface is put forward. Fabrication parameters, transmission properties, and mechanical strength of the cyclic olefin polymer-coated silver hollow St distal tip are experimentally discussed.     

高功率固体激光放大系统相位自校正方法研究

就光学元件间低频相位误差叠加提出用相关系数作为叠加相位结果的估计参量，并通过模拟计算和验证实验证明了相关系数能有效地对低频相位叠加结果进行比较估计，在此基础上就高功率固体激光放大系统中放大片的选取和安装提出了自校正方法并实现了自校正过程。     

激光水下扫描成像系统的图像修正机理

同步扫描系统可以克服后向散射，但同时也产生了两种非线性，一是扫描线速度的非线性，一是由于距离对光能衰减造成的非线性，两种非线性都需要修正，本文从原理上讨论水下激光成像时能量衰减的修正原理与修正方法，并给出仿真结果。     

中空光纤技术与应用特性

介绍一种采用环烯烃聚合物镀膜的中空光纤结构，阐述其传输特性，说明其使用特点，指出它在工业和医疗等领域中的应用前景。     

LD泵浦固体激光器基模振荡光的场分布噪音

通过调整泵浦光直径,使得LD端面泵浦固体激光器的振荡光工作于基模.在排除高阶横模的条件下,测量了由于热透镜的不稳定引起的光场场分布的噪音.实验发现,基模振荡光的高斯半径、光束指向角都在波动,而且光斑存在畸变波动.对一个未采取抑制措施的2W连续LD端面泵浦Nd:YAG固体激光器进行了测量.结果表明,在总功率不变的情况下,激光束峰值点附近的光强波动达到6.3%;激光的高斯半径波动达到5.8%;激光的指向角波动达到0.3mrad.     

利用相干渡越辐射测量电子束团长度的分析与计算

利用相干渡越辐射(CTR)测量短和超短电子束团长度是国际上束测领域新发展的频域测量技术.文中理论分析和数值计算了北京自由电子激光装置的皮秒级的射频电子束团序列产生的CTR,当辐射波长在长于束长(4ps)时,渡越辐射发生相干增强效应;与非相干渡越辐射相比,当λ≥2πσz时,增强的倍数约等于束团中粒子的数目(10⁸);CTR从亚毫米波到毫米波段呈宽带连续谱特性;渡越辐射能量主要集中在轴线附近,宏脉冲辐射能量高达几毫焦.设计采用偏振型束团长度测量系统,利用CTR自相关技术,实验测量该束团序列的纵向长度,并藉助傅里叶变换光谱法,推求束团电子分布.     

某些类氖离子和类镍离子等离子体状态对应关系的研究

利用一维拉格朗日流体动力学程序Med103详细研究了产生类镍Ag,Cd,In,Sn, Sb离子和类氖Fe,Co,Ni,Cu,Zn离子的等离子体状态.通过对电子温度、离子丰度、离子数密度等状态参量的分析比较，得到了这两类等离子体状态之间的对应关系.即类镍银的等离子体状态与类氖铁 的相近，类镍镉的与类氖钴的相近，依次类推.利用这一对应关系可以方便地由类氖机理x射线激光的等离子体状态来对相应元素的类镍x射线激光的等离子体状态进行判断. 关键词： 类氖 类镍 等离子体状态 x射线激光     

Changes in the Laser-Induced Fluorescence Spectrum of Myocardium Tissue with Decrease in Its Viability

We investigated the laser-induced fluorescence spectra (LIF) of porcine cardiac tissues with different degrees of viability. The data obtained are compared with the results of routine histological investigations and also with the experiments performed with the use of fluorescent probes. It has been found with a high degree of reliability that the loss of the viability of the myocardium tissue leads to the alteration of its LIF spectra. This can be used for low-invasive rapid control of transplant viability in the process of its preparation and during surgery.     

用数值方法分析微孔激光器出射光的近场特性

微孔激光器作为应用于近场光信息存储系统中的一种新型光源，它的出射光斑的近场特性对于近场光存储是十分重要的。针对纳米孔径运用角谱进行Fox-Li数值迭代，得到不同孔径微孔激光器的基模光强分布，然后运用二维非线性时域有限差分法分析微孔激光器出射端即微孔金属膜的近场光学性质，模拟计算了不同孔径和厚度的微孔金属膜的光强近场分布，从应用于近场光存储的角度，给出反映其近场光学特性的相关数据。发现由于TM模式下金属存在局域表面等离子增强效应，使得其出射强度比TE模式高一个数量级，从而更适于作为实际中近场光存储系统和原理试验的光学头。