Phase Transitions,Thermal Desorption of Gases,and Electroconduction in BaCeO<Subscript>3</Subscript>, a Base for High-Temperature Protonic Conductors

Investigations of phase transitions in barium cerate are carried out by methods of dilatometry and differential scanning calorimetry. Thermal desorption of gases and temperature dependences of electroconduction in dry and humid air are studied. Barium cerate exhibits complex polymorphism, undergoing a number of structural conversions at 300– 1300 K. The peaks in the spectra of thermal desorption of CO₂ and H₂O correlate with variations in the crystal lattice. Structural changes in BaCeO₃ affect activation energies for the carrier transport and the shares of partial conductivities.__________Translated from Elektrokhimiya, Vol. 41, No. 5, 2005, pp. 620–626.Original Russian Text Copyright © 2005 by Kuz’min, Gorelov, Vaganov, Korzun, Kazantsev, Aksenova, Khromushin.     

钙钛矿型复合氧化物Ca_xSr_（1－x）TiO_3催化剂上的甲烷氧化偶联反应

在固定床反应器上，评价了不同温度下钙钛矿型复合氧化物ＳｒＴｉＯ３和ＣａＴｉＯ３的组成变化对甲烷氧化偶联反应的影响．同时，利用ＸＰＳ和ＣＯ２－ＴＰＤ对催化剂的结构及其氧物种的反应特性进行了表征．结果表明：ＳｒＴｉＯ３和少量Ｃａ掺杂的ＣａｘＳｒｌ－ｘＴｉＯ３有利于在较低温度（９２３Ｋ）下催化反应的活性和选择性，而ＣａＴｉＯ３体系则在高温（１０７３Ｋ）下表现出较好的活性和选择性．钙钛矿型复合氧化物ＳｒＴｉＯ３和ＣａＴｉＯ３组成变化对不同温度下反应活性的影响与ＣＯ２－ＴＰＤ的脱附谱图有很好的平行关系．     

甲烷在SrO-La2O3/CaO催化剂上的氧化偶联Ⅱ.反应动力学的研究

在２０％Ｌａ２Ｏ３／ＣａＯ（ＬＣ）催化剂中添加ＳｒＯ（添加ＳｒＯ的ＬＣ以ＳＬＣ表示）明显地提高了反应活性和Ｃ２选择性。反应动力学研究表明，ＬＣ和ＳＬＣ催化剂在甲烷氧化偶联反应中，在表观活化能和表观反应级数上存在很大的差异。ＬＣ催化剂在ＣＨ４转化以及Ｃ２和ＣＯｘ形成过程中，表观活化能大于ＳＬＣ催化剂，而ＳＬＣ催化剂的指前因子小于ＬＣ体系，两者存在着补偿形象。ＳＬＣ催化剂的反应速率常数比ｋｃ２／ｋＣＨ     

Sol-Gel Preparation and Photoelectrochemical Properties of Fe2TiO5 Thin Films

Polycrystalline Fe₂TiO₅ films were prepared on nesa silica glass substrates by the sol-gel method, and their photoanodic properties were measured in a three-electrode wet cell with an aqueous buffer solution of pH = 7. Gel films were crystallized into Fe₂TiO₅ when fired at 500°C. The photoanodic current significantly increased when the films were fired at 700°C, and then decreased with increasing firing temperature. Thicker films obtained by repeating the gel film deposition and firing showed smaller photocurrent, and the 50 nm thick film prepared via non-repetitive deposition exhibited the maximum photocurrent. Although the photoresponse was extended to wavelengths near 500 nm, the maximum quantum yield was as low as 0.12 at a wavelength of 340 nm.     

钡修饰Ir/SiO2催化剂对氨分解促进作用的研究

研究了浸渍法制备的Ba修饰S iO2担载型铱(Ir)基催化剂(Ba-Ir/S iO2)在氨催化分解模型反应的作用。结果表明Ba的添加显著提高了催化剂的活性和稳定性。采用H2-TPR和H2-TPD对Ba-Ir/SiO2进行分析和研究,结果显示助催化剂Ba和活性催化组分Ir之间发生了强相互作用。Ba-Ir/SiO2在氨催化分解模型反应中的主要活性物种是零价态的Ir。     

Synthesis and Structure of Mixed Ba12F19ClδBr5–δ Crystals

In the structure Ba₁₂F₁₉Cl₅ [hexagonal space group P6 2m] the two chlorides on the sites Cl(1) and Cl(2) can partially be replaced by bromide ions. Single crystals of the type Ba₁₂F₁₉Cl_δBr_5–δ with a chloride to bromide ratio up to 2 : 3 could be obtained by cooling a flux of 75 mol% BaF₂ and 25 mol% BaX₂ with X = Cl, Br. The crystal quality decreases with increasing bromide concentration. Structural parameters of five selected single crystals with different chloride/bromide ratio were studied by single crystal X-ray diffraction methods. The refined total Cl^?/Br^? population ratio in the crystals is close to the one of the flux. The lattice parameters and interatomic distances change in various ways, when the smaller chloride ion is replaced by the bigger bromide ion. The refinements show a statistical disorder on the halide sites with preferential bromide substitution on site Cl(1).     

Heterometallic lead-titanium oxyalkoxide precursors to lead titanate thin films

Two lead titanium oxyalkoxides with composition Pb₂Ti₄O₂(O₂CCH₃)₂(OC₂H₅)₁₄ and Pb₂Ti₂O₂(O₂CCH₃)₂(OCH(CH₃)₂)₈ have been isolated and characterised by elemental analysis, IR, ²⁰⁷Pb NMR and molecular weight measurements. X-ray structural analysis of the 1:2 complex confirmed the presence of two Pb₂Ti₂O units which are linked by a common Pb···Pb edge and are held together by alkoxide and acetate bridges. The acetate groups have migrated from the Pb to the Ti centres during the reaction. Hydrolysis of the 1:1 Pb/Ti complex produced clear gels providing the H₂O/complex ratio was less than 4. Heat treatment of the gel results in loss of residual organics below 400°C. The XRD pattern indicates the presence of the pyrochlore and perovskite phases after heating at 500°C but the sample is poorly crystalline. Complete conversion to the perovskite phase of lead titanate occurs on heating to 600°C for 1 hour. Thin films of lead titanate were deposited by dip-coating a solution of this complex in isopropanol. Analyses of the films, carried out using electron microprobe, Scanning Auger Spectroscopy and Rutherford Backscattering, indicated that they were of excellent quality, crystalline after heating at 600°C and with relatively sharp substrate-coating interface.     

Microstructure and electrical properties of BaTiO<Subscript>3</Subscript> and (Ba,Sr)TiO<Subscript>3</Subscript> ferroelectric thin films on nickel electrodes

Nickel thin films have been sputtered on standard Si/SiO₂ substrates with TiO₂ as an adhesive layer. The thermal stability of these substrates was analyzed. SEM images show an increase in grain size with annealing temperature. They were found to be stable till 800°C, beyond which the nickel layer disintegrated. These substrates were used for deposition of BaTiO₃ and (Ba,Sr)TiO₃ dielectric thin films under a reducing atmosphere. The dielectric thin films were processed with various pyrolysis and annealing temperatures in order to optimize the dielectric properties. Increased pyrolysis temperatures showed an increase in the grain size. Results on these nickelised substrates were finally compared with dielectric films deposited on platinized silicon substrates under identical conditions but crystallized in an oxygen atmosphere.     

Fabrication of lead titanate single crystalline nanowires by hydrothermal method and their characterization

Single crystalline nanowires of lead titanate (PbTiO₃) were fabricated by hydrothermal method at 200°C using lead acetate and n-tetrabutyl titanate as starting materials, where sodium hydroxide was served as a mineralizer. Crystalline phases, microstructure and optical properties of PbTiO₃ nanowires were investigated. The PbTiO₃ nanowires were uniform and continuous along the long axis, and were composed of single crystalline PbTiO₃ with a tetragonal perovskite structure. The diameter of a single nanowire was around 12 nm and the length reached up to 3 μm. The chemical composition of the samples and the valence states of elements were determined by X-ray photoelectron spectroscopy (XPS). The ultraviolet/visible absorption spectroscopic investigation suggested that the absorption edge of optical transition of the first excitonic state occurred at around 320 nm. A blue-green light emission peaking at about 471 nm (2.63 eV) is observed at room temperature, and the intensity of this emission increased with increasing excitation wavelength. Oxygen vacancies are responsible for the light emission of PbTiO₃ nanowires.     

氧化锶催化性质：Ⅱ.SrO,MgO上异丙醇的分解反应

ＳｒＯ，ＭｓＯ对异丙醇的分解反应有各自的作用形式，因而产物分布也有明显差别．ＭｇＯ上异丙醇分解，在较低温度时，主要产物为丙酮和丙烯；随温度升高，生成丙烯的量增加，而丙酮的量减少，直至消失，在ＳｒＯ上，异丙醇在较高温度时反应，产物几乎为丙酮，丙烯的生成量极少。认为：产物中丙烯来源于异丙醇在催化剂表面强酸中心上的脱水；丙酮在ＭｇＯ上来源于强碱中心和酸中心协同作用异丙醇的脱氢，而在ＳｒＯ上则是ＳｒＯ表面极强的碱中心作用异丙醇而脱氢制得。