In‐line monitoring of UV photopolymerization with a quartz crystal resonator

An in‐line monitoring device using a quartz crystal resonator for thin film polymerization was proposed, and its performance has been evaluated by implementing in the UV polymerization of 2‐hydroxyethyl methacrylate with a photoinitiator of 1‐chloroanthraquinone. Because the variation of resonant resistance of the resonator is proportional to the square root of viscosity change that is closely related to the polymerization degree, the resistance can be used as a measure of the polymerization degree. The resistance measurements were compared with the outcome of instrumental analyses of polymerization degree using an FTIR spectrometer and a gel permeation chromatograph. The experimental results showed that the resistance measurements were consistent with the experimental outcome of the instrumental analyses, and this indicates the effectiveness of the proposed device. Owing to the simplicity and availability of the resonator system, its wide utilization in the monitoring of a variety of film polymerization processes, including photoresistor application, is expected. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 2428–2439, 2006     

Monitoring the Hydrolysis of p—Nitrophenyl Acetate Catalyzed by Seryl—histidine with Electrospray Ionization Mass Spectrometry

ＩｎｔｒｏｄｕｃｔｉｏｎＩｎｔｈｅｐａｓｔｄｅｃａｄｅ ,ｉｔｗａｓｆｏｕｎｄｔｈａｔｔｗｏａｍｉｎｏａｃｉｄｒｅｓｉｄｕｅｓ ,ＳｅｒａｎｄＨｉｓ ,ｗｏｒｋａｓｔｈｅａｃｔｉｖｅｓｉｔｅｓｉｎｔｈｅｓｅｒ ｉｎｅｐｒｏｔｅａｓｅ .1 3 Ｉｎｏｕｒｐｒｅｖｉｏｕｓｗｏｒｋ ,ａｄｉｐｅｐｔｉｄｅｓｅｒｙｌ ｈｉｓｔｉｄｉｎｅ (Ｓｅｒ Ｈｉｓ)ｗａｓｆｏｕｎｄｔｏｈａｖｅｔｈｅｐｒｏｔｅｉｎａｎｄｎｕ ｃｌｅｏｓｉｄｅｓｃｌｅａｖａｇｅａｃｔｉｖｉｔｙ .4 7ｐ Ｎｉｔｒｏｐｈｅｎｙｌａｃｅｔａｔｅ (ｐ ＮＰＡ)ｗ…     

用碘酸钾滴定法标定二氧化硫标准溶液

用KIO3滴定法标定SO2标准溶液,RSD≈0.10%,标定结果与标准法结果无显著性差异,相对误差<±0.3%。     

Hydrogen Oxidation on a Platinum Microelectrode: Effect of Carbon Monoxide Impurities

The kinetics of the hydrogen oxidation and the CO adsorption on a Pt (ultra)microelectrode is studied in a 0.5 M H₂SO₄ solution saturated with a mixture of gaseous H₂ and CO at partial CO pressures p _CO = 10–500 ppm. The balance between rates of diffusion and adsorption of CO at different adsorption times is studied. Studied is the effect of CO impurities in H₂ on steady-state polarization curves for the hydrogen ionization and nonsteady-state curves of the oxidation current decay with time at 0.02–0.05 V. Conditions under which in a certain time interval and at a certain CO concentration the slope of an I vs. t curve is proportional to p _CO are determined. The obtained dependence may be used when designing a technique for monitoring CO impurities in technical hydrogen.     

Identification of a chemical indicator of the rupture of 1,4-β-glycosidic bonds of cellulose in an oil-impregnated insulating paper system

In this study, headspace gas chromatography/mass spectrometry has been used to assess the volatile by-products generated by the ageing of oil-impregnated paper insulation of power transformers. Sealed-glass ampoules were used to age under oxidative conditions 0.5-g specimens of insulating paper in 9 mL of inhibited mineral oil in a temperature range of 60–120 °C and moisture of 0.5, 1 and 2% (w/w). A linear relationship between one of the oil-soluble degradation by-products, i.e. methanol, and the number of ruptured 1,4-β-glycosidic bonds of cellulose, regardless of the type of paper (ordinary Kraft or thermally-upgraded (TU) Kraft paper), was established for the first time in this field. Ageing at 130 °C of model compounds of the Kraft paper constituents (α-cellulose, hemicellulose and lignin) and two cellulosic breakdown by-products (D-(+)-glucose and 1,6-anhydro-β-d-glucopyranose) confirmed that the α-cellulose degradation was mostly responsible for the presence of this molecule in the system. Furthermore, additional 130 °C-tests with six different papers and pressboard samples under a tight control of initial moisture indicated that at least one molecule of methanol is formed for each rupture of 1,4-β-glucosidic bond of the molecular chains. Stability tests showed that the ageing indicator is stable under the oxygen and temperature conditions of open-breathing transformers. The presence of methanol was detected in 94% of oil samples collected from over than 900 in-service pieces of equipment, confirming the potential for this application. Lastly, the tests have shown that oil-oxidation by-products and TU-nitrogenous agents modify the methanol partitioning coefficients in the paper/oil/air system, which makes their study essential over a range of field conditions encountered by power transformers. Results are presented and discussed in comparison with 2-furfuraldehyde, which is the current reference in the domain.     

GC-MS法测定焦化厂气溶胶中多环芳烃

利用气相色谱-质谱(GC-MS),电子轰击离子化(EI)法测定焦化厂气溶胶中多环芳烃的含量。超声波抽提气溶胶样品,用GC-MS的选择离子监测(SIM)方式测定EPA提出的优先监测的16种多环芳烃的含量。该法的检出限为0.167pg·m~(-3),PAHs的回收率为85.1％～110.5％,相对标准偏差为4.62％～19.4％。应用该法测定气溶胶中PAHs获得满意的结果。     

Chemometric interpretation of pesticide occurence in soil samples from an intensive horticulture area in north Portugal

An extensive monitoring programme of pesticides was carried out in soil samples from an intensive horticulture area in north of Portugal, putting into practice the needs for increased control of soil quality as far as organic pollution is concerned. The area under investigation was additionally defined as vulnerable to nitrates due to local soil and aquifer characteristics, which might be extended to pesticides contamination. Five sampling sites were selected and soils analysed at three depths in eight sampling campaigns, for the period of 2 years. A stepwise multivariate statistical approach was selected to uncover most relevant patterns inside a complex environmental data matrix. Cluster analysis was applied both to group pesticides and samples, giving a primary and unsupervised overlook of privileged relationships. Clusters of persistent pesticides and selected herbicides were identified, whereas sample classes were also formed and disposed geographically. Thirty eight percent of analysed soils samples fell into one class characterized by low contamination (class 1 in cluster analysis), which is entirely representative of the sampling site no. 1. Afterwards, linear discriminant analysis was applied to identify those pesticides, which had a higher impact in the definition of classes. Finally, factor analysis using a five component model was implemented in order to bring to light the constitution and data variance explained by each of the five main principal components, as well as, their relation to pest management practices. A factor was identified (PC1 – 22% variance) composed of chlorinated pesticides, which was representative of one of the investigated sites indicating its high contamination status. Qualitative main findings and class average concentration values were obtained through this multivariate statistical approach.     

一种基于流动注射梯度技术识别异常峰及校正的方法

基于流动注射梯度信息提出了一种利用梯度比均值进行定量的校正方法。方法具有在线自动判别和修复异常峰并自行校正的功能，和通用的标准系列定量方法相比，两者测定精度相当。但本文提出的方法抗干扰能力明显优于后者，可适用于在线过程监测。     

SciFinder-guided rational design of fluorescent carbon dots for ratiometric monitoring intracellular pH fluctuations under heat shock

Intracellular pH plays a significant role in various biological processes, including cell proliferation, apoptosis, metabolism, enzyme activity and homeostasis. In this work, a novel design strategy for the preparation of pH responsive carbon dots (CDs-pH) for ratiometric intracellular imaging was reported. By using SciFinder database, fluorescent CDs-pH with the required pK_a value of 6.84 were rationally designed, which is vital important for precise sensing of intracellular pH. As a result, the synthesized CDs-pH demonstrated robust ability to test pH fluctuations within the physiological range of 5.4-7.4. The CDs-pH was further utilized for fluorescent ratiometric imaging of pH in living HeLa cells, effectively avoided the influence of autofluorescence from native cellular species. Moreover, real-time monitoring of intracellular pH fluctuation under heat shock was successfully realized. This SciFinder-guided design strategy is simple and flexible, which has a great potential to be used for the development of other types of CDs for various applications.     

环境水中化学需氧量的FI分光光度法自动在线检测

本文将流动注射分光光度法用于环境废水中化学需氧量（ＣＯＤ）的自动在线检测，方法线性范围在０－１００ｍｇ／Ｌ之间，相对标准偏差＜２％以葡萄糖和苯二甲酸氢钾混合液制备标准溶液，对标准参考水样ＣＯＤ含量（Ｃｒ值）的测定结果表明两者有良好的相关性（Ｒ＝０．９８８０）对环境水样中ＣＯＤ含量的动态变化连续１０ｈ模拟试验，自制的在线过滤装置稳定，未发生堵塞现象；该系统可以较好地跟踪水样中ＣＯＤ浓度的实际变化