High temperature annealing effect on structural and magnetic properties of Ti/Ni multilayers

High temperature annealing effect on structural and magnetic properties of Ti/Ni multilayer (ML) up to 600 °C have been studied and reported in this paper. Ti/Ni multilayer samples having constant layer thicknesses of 50 Å each are deposited on float glass and Si(1 1 1) substrates using electron-beam evaporation technique under ultra-high vacuum (UHV) conditions at room temperatures. The micro-structural parameters and their evolution with temperature for as-deposited as well as annealed multilayer samples up to 600 °C in a step of 100 °C for 1 h are determined by using X-ray diffraction (XRD) and grazing incidence X-ray reflectivity techniques. The X-ray diffraction pattern recorded at 300 °C annealed multilayer sample shows interesting structural transformation (from crystalline to amorphous) because of the solid-state reaction (SSR) and subsequent re-crystallization at higher temperatures of annealing, particularly at ≥400 °C due to the formation of TiNi₃ and Ti₂Ni alloy phases. Sample quality and surface morphology are examined by using atomic force microscopy (AFM) technique for both as-deposited as well as annealed multilayer samples. In addition to this, a temperature dependent dc resistivity measurement is also used to study the structural transformation and subsequent alloy phase formation due to annealing treatment. The corresponding magnetization behavior of multilayer samples after each stage of annealing has been investigated by using Magneto-Optical Kerr Effect (MOKE) technique and results are interpreted in terms of observed micro-structural changes.     

Hadroproduction experiments for precise neutrino beam calculations

The discovery of the neutrino oscillation pattern with solar and atmospheric neutrinos has stimulated systematic studies with long-baseline accelerator experiments. Precise neutrino beamline calculations have demonstrated the importance and paucity of existing hadroproduction data needed to shape the primary meson production in targets and tune available Monte Carlo codes for hadronic shower simulation. After a brief introduction to the physics of neutrino beams, available hadron production data will be reviewed with regards to their parametrization. Fast simulations based on such parameterizations and full Monte Carlo simulations of neutrino beamlines will then be illustrated. The prospective impact of new hadroproduction experiments, such as HARP at CERN and MIPP at Fermilab, will be shown together with some neutrino beamline simulations.     

Tests of quantum electrodynamics using ion traps

Experiments in ion traps on the g factors for the free and the bound electron in low-Z, hydrogen-like ions have provided the most accurate tests of quantum-electrodynamics calculations. Moreover they have been used to determine new and precise values for fundamental constants. Extensions to more stringent tests using ions of higher values of the nuclear charge Z are on the way. Also other QED tests such as Lamb shifts or hyperfine structures in H-like ions using traps will be feasible in the near future. The tests in bound systems, however, will be limited by nuclear structure effects which are difficult to calculate. Assuming the QED calculations as correct, the experimental results may be used to determine nuclear contributions and thus support nuclear models. Contribution presented at the TCP06, Vancouver Island, 2006.     

条件愈苦,意志愈坚 --记王淦昌早年的科研活动

文章介绍了中国物理学家王淦昌早期的科研工作，特别是在抗日战争时期的科研成绩．王淦昌早期的科研贡献并不是在先进的实验仪器上，在条件优裕的实验室内完成的，而是在实验设备缺乏，科学文献不足等极端困难的环境中完成的．从王淦昌身上，可以看到那个时代中国优秀科学家脚踏实地、执志若金的奋斗精神．     

Investigation of chemical decomposition of CCl4 on TiO2 near room temperature

Dissociative adsorption of CCl₄ on TiO₂ at 35 °C has been studied by Fourier-transform infrared spectroscopy, X-ray photoelectron spectroscopy, and electron spin resonance. CCl₄ decompose to form CO, CO₂, and CO₃ on the surface, at such a low temperature, in which CO₂ formation is not from CO oxidation on TiO₂, but CO₃ can be produced by CO and CO₂ adsorption. The Cl generated from CCl₄ decomposition is left on the surface and bonded to titanium ions. Mineralization of CCl₄ on TiO₂ involves the lattice oxygens. Thermodynamical driving force and possible reaction routes for CO and CO₂ formation in the CCl₄ decomposition on TiO₂ are discussed.     

掺铥氟磷玻璃的结构、热学性质和光谱性质

制备了不同Al(PO3)3含量的掺铥系列氟磷玻璃,研究了其结构、热稳定性和光谱性质。随着Al(PO3)3含量的增加,该系列玻璃的密度降低,折射率增加,差热分析表明,转变温度、析晶起始温度、析晶峰温度和熔化温度增加。Al(PO3)3摩尔浓度在7%~9%时析晶稳定性最佳。采用归一化的拉曼光谱分析了材料的结构和声子状况,对于该系列氟磷玻璃,Al(PO3)3含量的增加不会影响声子能量,但使声子密度增大。测试了样品的吸收光谱,Tm3 的3H6→3F4在第三通信窗口的L波段有明显吸收。与在其它玻璃基质中相比,Tm3 的3F4能级对应能量偏高,3H4能级对应能量偏低,使得3H4→3F4跃迁波长较大,接近于增益迁移光纤放大器的放大波长。扎得奥菲而特(Judd-Ofelt)理论分析表明随着Al(PO3)3含量增加,离子强度参量Ω2增大,Ω6保持相对稳定,Tm3 的能级寿命降低。     

Surface morphologies of anthracene single crystals grown from vapor phase

The morphologies and lattice structures of anthracene single crystals grown from the vapor phase were investigated using optical microscopy, phase contrast microscopy, atomic force microscopy (AFM), and X-ray diffraction analysis. Common morphologies with hexagonal large planes were observed irrespective of crystal size. The observation of certain surface morphologies with a phase contrast microscopy revealed that the spiral steps originated from screw dislocations present on the (0 0 1) planes. Moreover, the center and edge of the (0 0 1) planes had large curvatures, similar to hills. Resultantly, quarter-monolayer (ML) steps were observed on the large and flat planes between both hills.     

Semiconvergence in distribution of random closed sets with application to random optimization problems

The paper considers upper semicontinuous behavior in distribution of sequences of random closed sets. Semiconvergence in distribution will be described via convergence in distribution of random variables with values in a suitable topological space. Convergence statements for suitable functions of random sets are proved and the results are employed to derive stability statements for random optimization problems where the objective function and the constraint set are approximated simultaneously. The author is grateful to two anonymous referees for helpful suggestions.     

Zero weights and non-zero slacks: Different solutions to the same problem

This paper re-assesses three independently developed approaches that are aimed at solving the problem of zero-weights or non-zero slacks in Data Envelopment Analysis (DEA). The methods are weights restricted, non-radial and extended facet DEA models. Weights restricted DEA models are dual to envelopment DEA models with restrictions on the dual variables (DEA weights) aimed at avoiding zero values for those weights; non-radial DEA models are envelopment models which avoid non-zero slacks in the input-output constraints. Finally, extended facet DEA models recognize that only projections on facets of full dimension correspond to well defined rates of substitution/transformation between all inputs/outputs which in turn correspond to non-zero weights in the multiplier version of the DEA model. We demonstrate how these methods are equivalent, not only in their aim but also in the solutions they yield. In addition, we show that the aforementioned methods modify the production frontier by extending existing facets or creating unobserved facets. Further we propose a new approach that uses weight restrictions to extend existing facets. This approach has some advantages in computational terms, because extended facet models normally make use of mixed integer programming models, which are computationally demanding.     

新型金属杂冠醚配合物18-MC-6[Mn6(4-Amashz)6(DMF)6]·12DMF的合成

合成了一种新型金属杂冠醚配合物[Mn6(4-amashz)6(DMF)6]·12DMF,并用X射线衍射法对其结构进行了表征.研究了该化合物修饰金电极催化氧还原的性质,结果表明,该化合物具有平面碟状结构,对在碱性溶液中的氧有显著的催化还原作用.