Vibrational partition functions for H2O derived from perturbation-theory energy levels

Purely vibrational energy levels and partition functions are calculated using three different potential energy surfaces for the H₂O molecule. Results obtained with perturbation-theory, independent-normal-mode (INM), and harmonic approximations are compared with accurate values. For the cases considered here, the expected improvement that perturbation theory provides over the corresponding harmonic treatment is found to be substantial, while the INM approximation leads to results which are worse than the corresponding harmonic ones. In fact, we show that reliable partition functions for these potential surfaces can be obtained when resonance contributions are removed from the perturbation-theory treatment, and we propose a theoretical criterion for deciding when a particular interaction should be treated as resonant.     

碘化钾-乙基紫-水体系固相浮选分离镉的研究

研究了碘化钾 乙基紫 水体系固相浮选分离镉的行为及与常见金属离子分离的最佳条件。试验表明,将碘化钾溶液、乙基紫溶液和盐酸溶液混合稀释,生成稳定的CdI2-4·(EV+)2三元缔合物可很快浮于水相,使Cd(Ⅱ)被定量浮选。控制适当条件,可实现Cd(Ⅱ)与常见金属离子Mn(Ⅱ)、Al(Ⅲ)、Ni(Ⅱ)、Zn(Ⅱ)之间的分离。对合成水样进行了浮选分离测定,结果满意。     

Multi-walled carbon nanotubes as a solid-phase extraction adsorbent for the determination of chlorophenols in environmental water samples

Multi-walled carbon nanotubes (MWCNs) are used as adsorbent for solid-phase extraction (SPE) of several chlorophenols (CPs). CPs were adsorbed on MWCNs cartridge, then desorbed with pH 10.0 methanol, finally determined by HPLC. Under the optimized conditions, detection limits of 0.08-0.8 ng mL(-1) were obtained. The method had been applied to analyze the five CPs in tap water and river water.     

Spatially resolved characterization of PEFCs using simultaneously neutron radiography and locally resolved impedance spectroscopy

A method for performing neutron radiography and locally resolved impedance spectroscopy simultaneously in situ in an operating polymer electrolyte fuel cell (PEFC) is presented. The new method provides concurrently spatially resolved information about the local cell performance, the locally limiting processes, and the liquid water distribution. Information about the impact of water on cell performance and limiting processes can be gained in situ on a local scale in an operating PEFC. The method was applied to a PEFC operated on pure H₂/O₂ in co-flow mode under low humidity operating conditions. The results show that in co-flow mode strong flooding and severe drying can occur at the very same time in different sections of a PEFC.     

Copper ring-disk microelectrodes: fabrication, characterization, and application as an amperometric detector for capillary columns

A novel approach to the fabrication of metal ring-disk (RD) microelectrodes is presented that employs flexible chemical vapor deposition (CVD) and electrode modification techniques. Specifically, the development of a copper ring-disk microelectrode is described utilizing a combination of CVD coating, electroetching, and electroplating. Initially, a 25 μm diameter tungsten wire is concentrically coated by CVD with an insulating layer of silica, a layer of tungsten metal, and finally, a second outer layer of silica. The copper surface was prepared by first creating micrometer cavities by electrochemical etching the tungsten in hydroxide solutions followed by electrodeposition of copper from aqueous solutions of Cu(II). Each step of the process was characterized by scanning electron microscopy, optical microscopy, and cyclic voltammetry, demonstrating the preparation of a viable metal-based dual ring-disk microelectrode system. For the purpose of demonstrating the concept of introducing specific selectivity into the device, amperometric detection of galactose in 0.1 M NaOH was performed at +0.60 V in bulk solution and after flow injection analysis in a capillary column.     

Determination of total phosphorus and nitrogen in turbid waters by oxidation with alkaline potassium peroxodisulfate and low pressure microwave digestion, autoclave heating or the use of closed vessels in a hot water bath: comparison with Kjeldahl digestion

The evaluation of the use of alkaline peroxodisulfate digestion with low pressure microwave, autoclave or hot water bath heating for the determination of total phosphorus and nitrogen in turbid lake and river waters is described. The efficiency of these digestion procedures were compared to a Kjeldahl digestion procedure with sulphuric acid-potassium sulfate and copper sulfate. The final solution before digestion was 0.045 M in potassium peroxodisulfate and 0.04 M in sodium hydroxide. Procedures were evaluated by the analysis of suspensions of two reference materials, National Institute of Environmental Science, Japan, no. 3 Chlorella and no. 2 pond sediment and natural turbid waters. Best recoveries of phosphorus and nitrogen by microwave heating were obtained when solutions were digested at 95 °C for 40 min. Quantitative recoveries of phosphorus from Chlorella suspensions up to 1000 mg/l were obtained by all three heating procedures, but incomplete recoveries of nitrogen occurred above 20 mg N/l in the digested sample. Good recoveries of phosphorus and nitrogen from suspended sediment suspensions were obtained only from solutions containing <150 mg/l of suspended sediments. Recoveries of phosphorus from phosphorus compounds containing COP and CP bonds added to distilled water were quantitative (94-113%) except for polyphosphates (microwave, 34±8; autoclave, 114±6; water bath, 96±4) and aluminium phosphate (8-23%). Recoveries of nitrogen compounds containing CN bonds added to distilled water were quantitative (94-96%). The analysis of a range of natural turbid water samples by alkaline peroxodisulfate and microwave, autoclave and water bath heating gave similar total phosphorus and nitrogen results. All procedures using alkaline peroxodisulfate underestimate phosphorus concentrations at high suspended sediment concentrations (>150 mg/l) and are only suitable for the analysis of very turbid samples when the turbidity is due to organic matter (algal cells, plant detritus). Underestimation of nitrogen occurs when samples contain more than 20 mg N/l.     

Diagnosis of OH Radical by Optical Emission Spectroscopy in Atmospheric Pressure Unsaturated Humid Air Corona Discharge and its Implication to Desulphurization of Flue Gas

OH radical in the corona discharge with pipe–nozzle–plate electrode has been diagnosed by optical emission spectroscopy. Spatial variations of OH radical emission in discharge gap have been measured. Relative intensity of OH radical emission spectroscopy increases with increasing water vapor flux injected into the reactor or intensity of electric field supported. In positive pulsed corona discharge, relative intensity is higher than that in positive DC corona discharge and lower than that in negative DC corona discharge. Strongest intensity of OH radical spectrum appears within the range of 5 mm near the discharge nozzle- electrode. In addition, it is proved that the efficiency of desulphurization from flue gas by pulsed corona discharge plasma processes can be improved when OH radical is produced in the reactor.     

Fundamental studies on the intermediate layer of a bipolar membrane: Part III. Effect of starburst dendrimer PAMAM on water dissociation at the interface of a bipolar membrane

Starburst dendrimer polyamidoamine (PAMAM) with ellipsoidal or spheroidal shape is structure-regular and has much more amino groups than conventional polymers. This paper investigates the possibility of these amino groups on water dissociation in a bipolar membrane interface. To do this, a bipolar membrane is prepared by casting the solution of sulfonated poly(phenylene oxide) (SPPO) in dimethyl formamide (DMF) on a commercial anion exchange membrane that is immersed in PAMAM aqueous solution in advance. The existence of PAMAM adsorbed on the membrane is proved by X-ray photoelectron spectroscopy (XPS), and the adsorption amount is evaluated by weighting method. The junction thickness of the prepared bipolar membrane is determined by electrochemical impedance spectroscopy (EIS), and the performance is evaluated by current–voltage curves. The experiments show that both the generation and concentration of PAMAM would strongly affect the characteristics of the bipolar membranes. There exists a transitional concentration for various generations PAMAMs to catalyze effectively the water dissociation, and above or below the transitional concentration the performance of bipolar membranes is decreasing. The higher the generation, the lower the concentration. Moreover, at a fixed solution concentration, there is not the simple relation of monotone decreasing or increasing between the performance of bipolar membranes and the generations of PAMAMs. All these can be explained according to the characteristics of PAMAMs combined with available water dissociation theory.     

Solubilization and applications of single-walled carbon nanotubes into aqueous and organic media by the use of nanometer size-controlled fluoroalkyl end-capped oligomeric aggregates

We have studied on the solubilization of single-walled carbon nanotubes (SW-CNTs) into aqueous and organic media by the use of a variety of nanometer size-controlled fluorinated self-assemblies, which were formed by the aggregations of end-capped fluoroalkyl segments in fluoroalkyl end-capped acrylic acid oligomers [R_F-(ACA)_n-R_F], N,N-dimethylacrylamide oligomers [R_F-(DMAA)_n-R_F], acryloylmorpholine oligomers [R_F-(ACMO)_n-R_F], and N-(1,1-dimethyl-3-oxobutyl)acrylamide oligomers [R_F-(DOBAA)_n-R_F]. Fluorinated self assemblies formed in organic media (colorless solutions) could solubilize SW-CNTs into organic media to afford the transparent pale yellow solutions. The dynamic light scattering measurements showed that the size of fluorinated self-assemblies increased after the solubilization of SW-CNTs into organic media. It was suggested that the solubilization of SW-CNTs into organic media is due to the encapsulation of SW-CNTs into fluorinated assemblies. Fluorinated assemblies were also able to solubilize SW-CNTs into water to give the transparent gray solutions. Among a variety of fluorinated assemblies, fluorinated assemblies formed by R_F-(ACMO)_n-R_F [R_F = CF(CF₃)OC₆F₁₃] oligomer was more effective for the solubilization of SW-CNTs into both aqueous and organic media. Contact angle measurements of dodecane and the fluorescence spectra for poly(methyl methacrylate) cast film modified by fluorinated self-assemblies—SW-CNTs complexes showed that SW-CNTs are dispersed above the PMMA surface.     

Osmotic Coefficients of Aqueous Solutions of Some Poly(oxyethylene) Glycols at the Freezing Point of Solution

Summary. The freezing temperatures of dilute aqueous solutions of some poly(oxyethylene) glycols (PEG, HO–(CH₂CH₂O) _n –H, n varying from 4 to 117) were measured over a solute to solvent mass ratio from 0.0100 to 0.3900. The second and third osmotic virial coefficient (A ₂₂ and A ₂₂₂) of poly(oxyethylene) glycols in aqueous solution were determined. The molecular weight dependence of the second virial coefficient can be described by a simple relation A ₂₂=2×10^–5 M _n ^1.86, and the third virial coefficient is A ₂₂₂=0.038A ₂₂ ². The activity coefficients of the solute were calculated using the Gibbs-Duhem equation as applied by Bjerrum. From the osmotic and activity coefficients the excess Gibbs energies of solution, as well as the respective partial molar functions of solute and solvent and the virial pair interaction coefficients for the excess Gibbs energies were estimated. The second and the third osmotic virial coefficients are correlated with the Mc-Millan-Mayer virial coefficients.