Fluid and diffusion limits for transient sojourn times of processor sharing queues with time varying rates

We provide an approximate analysis of the transient sojourn time for a processor sharing queue with time varying arrival and service rates, where the load can vary over time, including periods of overload. Using the same asymptotic technique as uniform acceleration as demonstrated in [12] and [13], we obtain fluid and diffusion limits for the sojourn time of the M_t/M_t/1 processor-sharing queue. Our analysis is enabled by the introduction of a “virtual customer” which differs from the notion of a “tagged customer” in that the former has no effect on the processing time of the other customers in the system. Our analysis generalizes to non-exponential service and interarrival times, when the fluid and diffusion limits for the queueing process are known.     

Assessing contaminated hydrogen peroxide for safe storage and transportation using the FTAI

Hydrogen peroxide is a very versatile oxidizing agent, and it is also environmentally compatible considering that the products of its exothermic decomposition are oxygen and water.When kept in a clean temperature-controlled environment, the self-reaction (decomposition) rate is extremely low. However, it is well known that even a small amount of contamination will dramatically increase the reaction rate. This paper describes the use of the fast thermal activity interpreter (FTAI) instrument to examine the chemical reactivity of commercially available 50% hydrogen peroxide at two different temperatures (30 and 40°C) both with and without contamination. The results show that at 30°C a small amount of rust (330 ppm) increases the reaction rate of 50% hydrogen peroxide by a factor of 50. When the temperature is increased to 40°C, the reaction rate is further increased by almost a factor of four. The implication for reactivity management is that at this contamination level most practical vessel sizes would require emergency venting capability. An evaluation was then performed to determine the emergency venting requirement for the safe transportation or storage of the contaminated hydrogen peroxide. It was determined that for quantities of the material less than 5 gallons, conventional breather vents would be sufficient to accommodate the gas evolved. However, for larger quantities, a safety relief device would be needed. For example, for a 400-gallon tote bin at 40°C the required minimum vent area is estimated to be 4.3 in², corresponding to a minimum vent diameter of 2.3 inches.     

Surface polarity of cellulose derivates observed by coumarin 151 and 153 as solvatochromic and fluorochromic probes

Solvent‐dependent ultraviolet–visible (UV–vis) absorption and Stokes shifts including strong hydrogen‐bond‐donating (HBD) solvents such as 2,2,2‐trifluoroethanol and 1,1,1,3,3,3‐hexafluoro‐2‐propanol of two coumarine dyes (Co 151 and Co 153) were analyzed with multiple‐square analyses of linear solvation energy relationships and the Kamlet–Taft solvent parameter set to α (HBD capacity), β (hydrogen‐bond‐accepting capacity), and π* (dipolarity/polarizability). The UV–vis absorption and emission spectra of Co 151 and Co 153 were measured when adsorbed on various polysaccharides such as different cellulose batches, carboxymethylcelluloses with different degrees of substitution, and chitine. As a result of this evaluation, Co 153 is recommended as an alternative UV–vis probe for evaluating the dipolarity/polarizability of cellulose and cellulose derivates. Multiple adsorption of Co 153 on Linters cellulose took place indicating a wide‐surface polarity distribution, which makes the determination of a rigid polarity parameter questionable. Thus, fluorescence measurements of adsorbed Co 153 are suitable to detect inhomogenities on a surface but not for the determination of empirical polarity parameters. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 1210–1218, 2003     

用反射法自动测量大尺寸样品的折射率分布

针对大尺寸样品的折射率分布测量,引入自动扫描装置和适时数据处理系统,研究出一种高灵敏度的智能化反射法折射率分布测量仪,可进行快速、自动、准确的折射率分布测量.经理论分析和实验研究提出了一套合理的实验数据处理方法.并具体介绍和详尽分析了实验装置,讨论了有关理论和实验误差,给出了消除各种误差的有效方法,最终得出较为理想的实验结果.     

Spectrophotometric Study of Luminol in Dimethyl Sulfoxide–Potassium Hydroxide

The spectrophotometric study of luminol (LH₂) in dimethyl sulfoxide (DMSO), DMSO-water solutions, and alkaline DMSO and DMSO-water solutions has been done, focusing on the effect of the KOH additon on LH₂ absorption and fluorescence properties. The absorption spectra indicate an acid-base equilibrium, and the luminol dianion (L^2–) formation at 3 × 10^–4 – 2.4 × 10^–3 M KOH. The decrease of the fluorescence intensity and the variation of the excitation spectra of LH₂-DMSO-KOH solutions with KOH concentration have been similarly explained. The acid-base process is reversible. The addition of HCl to the solution with 3.0 × 10^–3 M KOH leads to an increase of the fluorescence intensity to its highest value, observed in pure DMSO. The addition of HCl to the LH₂-DMSO solution leads to the decrease of the fluorescence intensity as a result of the LH⁺ ₃ cation formation. In LH₂-DMSO-water, the fluorescence band is shifted from 405 nm to 424 nm and increased in the intensity. In the presence of KOH (in LH₂-DMSO-water-KOH solution) a new band appears, with the maximum at 485 nm and the band at 405 nm decreased. The changes in fluorescence lifetimes also evidence the different chemical species formed.     

利用弧形光栅尺测量大型转轴扭矩的原理研究

利用弧形光栅尺的旋转微位移测量功能,组建一组测量体系,用于测量巨型转轴的扭矩。采用四组相同的弧形光栅尺同时测量两截面的相对转角,通过多点测量实现误差均化,得出了消除转轴直径对测量影响的公式,使仪器的环境适应能力得到了极大地提高。根据不同的工作情况,提出了相应的动态测量扭矩的计算方程。实现了大型机械设备主传动的动力监测,为设备自动化、智能化奠定了基础。     

F-H实验仪与光栅光谱仪连用观测253.7nm谱线

通过F-H实验仪和光栅光谱仪的连用，可实时观测汞原子从6s6s1So态激发到6s6sSP1态，退激时，辐射出能量为4．9eV的光量子，其波长为253．7nm．     

摄像型等厚干涉实验仪器的研究

介绍了“摄像型等厚干涉实验仪”的构造及等厚干涉实验新的测量方法。