Growth studies of m-GaN layers on LiAlO2 by MOCVD

This paper reports that the m-plane GaN layer is grown on （200）-plane LiAlO2 substrate by metal-organic chemical wpour deposition （MOCVD） method. Tetragonal-shaped crystallites appear at the smooth surface. Raman measurement illuminates the compressive stress in the layer which is released with increasing the layer＇s thickness. The high transmittance （80%）, sharp band edge and excitonic absorption peak show that the GaN layer has good optical quality. The donor acceptor pair emission peak located at -3.41 eV with full-width at half maximum of 120 meV and no yellow peaks in the photoluminescence spectra partially show that no Li incorporated into GaN layer from the LiAlO2 substrate.     

All-optical frequency multiplication/recovery based on a semiconductor optical amplifier ring cavity

A novel scheme for all-optical frequency multiplication/recovery based on a semiconductor optical amplifier ring cavity is proposed and investigated numerically. The results show, for a 2.5 GHz driving pulse train, it can be generated 5-25 GHz repetition rate pulse trains with low clock amplitude jitter, polarization independence and high peak power. Furthermore, the extraction of the clock signal from a pseudorandom bit sequence signal can be realized based on the proposed scheme.     

a-C:F薄膜的热稳定性与光学带隙的关联

以CF4和C6H6的混合气体作为气源,在微波电子回旋共振化学气相沉积(ECRCVD)装置中制备了氟化非晶碳薄膜(aC:F),并在N2气氛中作了退火处理以考察其热稳定性.通过傅里叶变换红外吸收谱和紫外可见光谱获得了薄膜中CC双键的相对含量和光学带隙,发现膜中CC键含量与光学带隙之间存在着密切的关联,在高微波功率下沉积的氟化非晶碳膜具有低的光学带隙和较好的热稳定性. 关键词： 氟化非晶碳膜 光学带隙 退火温度 热稳定性     

Fiber-optic reflex sensor for in-line production measurement

The paper describes experiments concerning distance measurement with fiber-optic sensor and improvement of the measurement principle. The sensor probe was well-designed with a small structure and multi-function. The novel optical fiber probe arrangement as well as the possibilities of use for complex measurement problems are explained using the measurement of an internal screw thread as an example. The experimental results show that the measurement uncertainty of the thread minor diameter can reach ±10 μm, and the stability of the measurement system is better than 0.07%.     

差分吸收光谱法测量大气污染的测量误差分析

差分吸收光谱技术被广泛地应用于测量大气中微量元素的浓度，尽管该技术利用最小二乘法来反演待测气体的浓度，能够得到很高的测量精度。但是，由于仪器本身的噪声以及测量波段其它气体的干扰等，使得仪器的测量有一定的误差，而且上述因素还决定着仪器的测量下限。对差分吸收光谱方法的测量误差以及引起误差的原因作了详细的分析。     

一维光学格子孤子的传输特性及控制研究

利用解析和数值方法研究了在具有横向折射率周期性调制的克尔型非线性介质中光学格子孤子的传输，得到了孤子参数的演化方程以及格子孤子的形成和稳定传输的条件.结果表明：当光束的入射角小于某临界角度时，光束可被类似波导形式的路径俘获而稳定传输，该临界角随折射率调制周期、调制深度的增加而增大，且光束越窄临界值越大.此外，线性空间啁啾虽然对光束传输的中心位置没有任何影响，但会导致光束发散从而破坏格子孤子的形成和稳定传输，对此提出了采用特定功率取值来补偿啁啾作用从而形成格子孤子的方案. 关键词： 光孤子 光学格子 光传输 矩方法     

烷氧基取代聚对苯乙炔三阶非线性光学性能

通过双醚化反应、氯甲基化反应以及在强碱性条件下进行的脱氯化氢反应制备聚（2-甲氧基-5-丁氧基）对苯乙炔（PMOBOPV）、聚（2-甲氧基-5-己氧基）对苯乙炔（PMOHOPV）、聚（2,5-二丁氧基）对苯乙炔（PDBOPV）和聚（2,5-二己氧基）对苯乙炔（PDHOPV）等四种可溶性聚对苯乙炔（PPV）衍生物，通过紫外-可见吸收光谱对产物分子结构进行表征.结果显示，PMOBOPV、PMOHOPV、PDBOPV和PDHOPV的共轭π电子发生π → π* 跃迁的吸收峰分别位于491 nm、495nm、504nm和510nm处，相应的光学禁带宽度分别为2.23eV、2.18eV、2.12eV和2.07eV.利用简并四波混频技术测量PPV衍生物的三阶非线性光学性能，探讨了分子结构对PPV衍生物三阶非线性极化率（χ(3)）的影响.研究发现，激发波长为532 nm时，PMOBOPV、PMOHOPV、PDBOPV和PDHOPV的共振χ(3)值分别为3.45×10－10、5.13×10－10、7.15×10－10和9.61×10－10 esu；激发波长为1064 nm时，它们的非共振χ(3)值分别为1.09×10－11、1.42×10－11、1.62×10－11和2.14×10－11 esu.     

Assisted Cloning and Orthogonal Complementing of an Arbitrary Unknown Two-Qubit Entangled State

Based on A.K. Pati‘s original idea [Phys. Rev. A 61 (2000) 022308] on single-qubit-state-assisted clone, very recently Zhan has proposed two assisted quantum cloning protocols of a special class of unknown two-qubit entangled states [Phys. Lett. A 336 (2005) 317]. In this paper we further generalize Zhan‘s protocols such that an arbitrary unknown two-qubit entangled state can be treated.     

Propagation of the Hermite–Gaussian beams through misaligned optical system with a circular aperture

By means of expanding a hard-edged aperture into a finite sum of complex Gaussian functions, the approximate analytical formula of one kind of higher-order Gaussian beams called the Hermite–Gaussian beams (HGBs) passing through circular apertured and misaligned optical system is obtained in this paper. The result provides more convenience for studying its propagation than the usual way by using diffraction integral directly. Some numerical simulations are also given for illustrating the propagation properties of the HGBs through the circular apertured optical systems.     

光纤的能量传输特性及应用

着重分析了影响光纤传输能量以及光纤传输中造成能量损耗的因素。这些因素主要包括光纤材料、构造、光纤的折射率分布、光纤的长度和芯径、光纤的数值孔径和热效应以及耦合等。同时 ,结合激光二极管点火的实例 ,分析探讨了其背景和应用价值。结论是 :为了尽可能减少能量损耗、提高光纤输出的激光功率和激光功率密度 ,应当选取合适的激光工作波长、较小的光纤长度、较小的芯径和较小的数值孔径 ,应采用渐变折射率分布光纤 ,应减少弯曲与耦合