关于半群局部化的一个注记

证明了对于任何的半群Ｓ和其任何的子半群Ｔ，Ｓ在Ｔ的局部化总是存在的。     

Concerning the multiplicators of Fourier series in the trigonometric system

In this paper we prove theorems on multiplicators of Fourier series inL _p, where the conditions depend on a parameterp. An example illustrating the importance of these conditions is constructed. Translated fromMatematicheskie Zametki, Vol. 63, No. 2, pp. 235–247, February, 1998.     

MO analysis of macroscopic supercurrent flow in MgB 2

We present results from an extended magneto-optical (MO) analysis of two samples cut from high-density pellets of MgB₂. The first sample was studied in order to show that no matter how large the sample is and despite the bulk granularity, the material enters into a critical state in a crystal-like fashion. The second sample was chosen for the quantitative analysis. A numerical approach based on an inverted 2D Biot-Savart model was used to calculate the current paths across the homogeneous polycrystalline bulk, as well as in the vicinity and across some morphological defects. Local current densities in the homogeneous part were estimated as a function of the applied magnetic field at different temperatures, in three regimes: below full penetration, at full penetration and above full penetration, respectively. A hypothesis of interpretation of the apparent absence of magnetic granularity inside the polycrystalline microstructure is presented. It is related to a critical state likely reached by a network of strongly coupled Josephson junctions. Received 31 May 2001 and Received in final form 5 December 2001     

射流式单重态氧发生器研究

单重态氧O2 (a1Δg)是迄今唯一能用纯化学反应高效产生的具有长寿命的亚稳激发态分子 .为了考察提出的用两个O2 (1Δ)能量汇集反应生成氧第二单重激发态O2 (b1Σ+ g)以实现近可见短波长化学激光方案的现实性 ,设计和实验了一个氯流量为 3～ 10mmol/s的射流式单重态氧发生器 (JSOG) .考察了三种具有不同孔径和孔数目的喷头、氯气流量和脱水冷阱温度等对JSOG出口的O2 (1Δ)浓度、O2 (1Δ)分压、氯利用率及水蒸气含量的影响 .发现用聚氯乙烯管作冷阱时 ,最佳冷阱介质温度为 - 140～ - 15 0℃ ,对此提出了O2 (1Δ)表面脱活与脱水互相竞争的解释 .在最佳条件下 ,可将O2 (1Δ)气中水分压降低至 4Pa ,这一结果是首次报导     

Classical solutions to a quadratically nonlinear gauge theory

We present some classical solutions to a gauge theory based on quadratically nonlinear Lie algebras without a central term. We observe that instanton-like and meron-like solutions force the internal fields to behave like solitons.     

On parabolic equations with a small parameter

A singularly perturbed parabolic equation with a nonlinear right-hand side of a special form is examined. A numerical analytical study of such equations is performed.     

Low-Temperature Magnetic Properties of Co Antidot Array

Cobalt antidot arrays with different thicknesses are fabricated by rf magnetron sputtering onto porous alumina substrates. Scanning electron microscopy and grazing incidence x-ray diffraction are employed to characterize the morphology and crystal structure of the antidot array, respectively. The temperature dependence of magnetic properties shows that in the temperature range 5K--300K, coercivity and squareness increase firstly, reach their maximum values, then decrease. The anomalous temperature dependences of coercivity and squareness are discussed by considering the pinning effect of the antidot and the magnetocrystalline anisotropy.     

L-S category of quaternionic Stiefel manifolds

By calculating certain generalized cohomology theory, lower bounds for the L-S category of quaternionic Stiefel manifolds are given.     

“Slow” active control of combustion instabilities by modification of liquid fuel spray properties

This paper describes an experimental investigation of the feasibility of using “slow” active control approaches, which “instantaneously” change liquid fuel spray properties, to suppress combustion instabilities. The objective of this control approach was to break up the feedback between the combustion process heat release and combustor pressure oscillations that drive the instability by changing the characteristics of the combustion process (e.g., the characteristic combustion time). To demonstrate the feasibility of such control, this study used a proprietary fuel injector (Nanomiser^TM), which can vary its fuel spray properties, to investigate the dependence of acoustics–combustion process coupling, i.e., the driving of combustion instabilities, upon the fuel spray properties. This study showed that by changing the spray characteristics it is possible to significantly damp combustion instabilities. Furthermore, using combustion zone chemiluminescence distributions, which were obtained by Abel’s deconvolution synchronized with measured acoustic data, it has been shown that the instabilities were mostly driven midway between the combustor centerline and wall, a short distance downstream from the flame holder, where the mean axial flow velocity is approximately zero in the vortex near the flame holder. The results of this study strongly suggest that a “slow” active control system that employs controllable fuel injectors could be effectively used to prevent the onset of detrimental combustion instabilities.