Simultaneous isolation and determination of esculin and rutin in natural materials using SPE and HPLC

Summary Esculin (ESC) and rutin (RUT) have been simultaneously isolated from pharmaceutical natural materials by solid phase extraction (SPE). Determination of both substances was performed by reversed phase high performance liquid chromatography (RPHPLC) with UV detection. Optimization of the separation conditions showed that simultaneous isolation and determination of rutin and esculin from pharmaceutical material was possible. The recovery obtained was not lower than 95±2%.     

1-苯基-3-甲基-4-苯甲酰基-5-吡唑酮与甲基膦酸二(1-甲基庚基)酯对Pb(Ⅱ)、Cd(Ⅱ)和Cu(Ⅱ)的萃取机理研究

本文用两相滴定法研究了1-苯基-3-甲基-4-苯甲酰基-5-吡唑酮(PMBP,简写为HA)与甲基膦酸二(1-甲基庚基)脂(P_(350),简写为B)对Pb~(2+)、Cd_(2+)和Cu~(2+)离子在不同的有机溶剂中的萃取机理.(?)定了萃合物的组成分别为:MA_2(M=Pb~(2+)、Ca~(2+)、Cu~(2+));MA_2·HA(M=Cd~(2+));MA_2·B(M=Pb~(2+)、Cd~(2+))和MA_2·2B(M=Cd~(2+)),同时求得了相应的萃合常数β值.     

Gas-stirred solvent extraction with propylene carbonate for separation and direct polarographic determination of thallium (III)

Gas-stirred propylene carbonate (PC) extraction can be performed by bubbling nitrogen without loss of volume. This extraction technique has proved to be highly useful for the separation and subsequent direct polarographic estimation of Tl(III) in the recovered PC phase. Tl(III) can be determined by differential-pulse polarography over the concentration range of 0.4 10 g ml^–1 without any interferences due to most metal ions such as Pb(II), Bi(III), Cu(II), Sb(III) and As(III). This proposed technique would be possible to use as a simple extraction step prior to the final estimation by instrumental method of analysis such as atomic absorption spectrometry or spectrophtometry.     

Fiber-in-Tube Solid Phase Extraction (FIT-SPE) for Miniaturized Sample Preparation Process

A typical analytical separation procedure has several important steps: sample preparation, isolation, identification, quantitation, statistical evaluation and final decision. Each step is alwayscritical to obtain correct results to fulfill the analytical purpose. In these various steps sample     

Cyanex272-P507浸渍树脂协同萃取色层分离铥镱镥的研究

以Cyanex272-P507浸渍树脂采用萃取色层法对铥镱镥富集物进行了吸附和淋洗分离研究,考察了淋洗剂浓度、稀土负载量、淋洗液流速等因素对分离铥镱镥富集物的影响。结果表明,在充填的树脂粒度为0.3~0.6 mm的色层柱中,以0.2 ml.cm-2.min-1进料流速时能得到较大的吸附率;在稀土负载量为树脂重量的0.6%,淋洗液流速为1.0 ml.cm-2.min-1,温度为30℃,装柱树脂高度为400 mm(高径比为25∶1)的条件下,用1.0,1.5,2.0 mol.L-1盐酸梯度淋洗Tm,Yb,Lu,可实现铥镱镥富集物三者的完全分离。     

氟涂料中全氟辛酸(PFOA)及其盐类物质测定的气相色谱质谱法

全氟辛酸(perfluorooctanoic acid,PFOA)是一种强酸[1],分子式为C8HF15O2,是常用的氟表面活性剂,具有很强的疏水性和疏油性,广泛用于油库、机场、军事设施等场所的消防材料中,也是氟涂料、氟塑料和有机氟织物整理剂等的生产过程中不可缺少的原料。全氟辛酸具有中等毒性的肝致癌     

SDE-GC-ECD分析水体中有机氯农药

运用单滴溶剂萃取-气相色谱-微池电子捕获检测器(SDE—GC—μECD)联用技术对水体中有机氯农药进行了分析，优化了影响单滴溶剂萃取的多种因素。该方法除了对P，P′-DDD的线性范围在0．4～4ng／mL之间外，其余的七种目标物(α-666，β-666，γ-666，δ-666，P，P′-DDE，0，P′-DDT，P，P′-DDT)线性范围均在0．04～4．0ng／mL之间，相关系数为0．9976～0．9999，回收率范围为83．3％～96．1％，相对标准偏差为2．1％～7．8％。与传统的液液萃取相比，单滴溶剂萃取不仅准确度、精密度相当，而且还具有省时、省溶剂的优点。     

Concentration and clean-up of trace hydrocarbons from atmospheric particulate matter

Summary The aim of this work is to establish the best conditions for concentration and purification steps in the trace analysis of aliphatic and polycyclic aromatic hydrocarbons (PAH) from atmospheric particulate matter by gas chromatography-flame ionisation detection (GC-FID) and high performance liquid chromatography with ultraviolet and fluorescence detection (HPLC-UV-FL). The best results for the more volatile compound were obtained with a combination of rotary evaporation and a stream of nitrogen (near to 100% for aliphatic hydrocarbons and from 70 to 105% for PAH). Two types of solid phase extraction (SPE)cartridges (Supelclean ^tm LC-Silica SPE tubes and Sep-Pak^? Plus silica cartridges) and glass column were examined for the purification and fractionation step. Blank chromatograms of both types of cartridges analysed by GC-FID made this study difficult, because a PSS (programmed split-splitless) injector was employed thereby increasing the sensitivity. This problem was not observed in the HPLC-UV-FL blank chromatograms of these cartridges. Glass columns filled with silica and alumina were chosen because no interference was found in the GC-FID blank chromatograms and the best recoveries in the fractionation of both aliphatic hydrocarbons and PAH were achieved. This is especially important when aliphatic hydrocarbons concentrations are lower than 1 μg mL⁻¹. Finally, the selected conditions were applied to the analysis of hydrocarbons in real atmospheric particulate samples.     

The contribution of the pressure drop to analyte retention in coupled column supercritical fluid chromatography of lipids

Summary This paper reports the qualitative and quantitative effects of the column pressure drop on the retention of lipid components in a serially coupled capillary column SFC system. The contribution of the pressure drop consists of two components, the density effect and the flow effect. The magnitude of the flow effect,i. e. the change in retention which results from changes in the flow-rate when column pressures are changed, is determined by the difference in single column analyte k values. The effect will be positive compared with the uncorrected retention values when the column with largest k value is closest to the injector. With the columns in reversed order, the effect will be negative. The contribution from the density effect always resulted in larger coupled column k values and was in most instances of more significance than the flow effect component. Values calculated with and without pressure drop correction have been compared and it has been shown that for most of the eighteen model lipid compounds investigated, the deviations from the experimental retention factors were smaller when pressure drop corrections were made.