用离子速度影象技术研究n-C4H9Br的光解

利用离子速度影象技术研究了正一溴丁烷(n-C4H9Br)在231~267 nm波段的光解,得出了如下结论:正一溴丁烷(n-C4H9Br)在231~267 nm波段的吸收源于基态到三个最低激发态的跃迁,这三个激发态标识为1A″、2A′和3A′;发生在这三个排斥态的势能面(PES)上的光解最终导致C4H9 Br(2P3/2)或C4H9 Br*(2P1/2)的产生;2A′和3A′态之间存在避免交叉(Avoided crossing)会影响最终的光解产物;从基态1A′到激发态1A″的跃迁矩垂直于对称面,也就垂直于C-Br键;从基态1A′到激发态3A′的跃迁矩平行于对称面,同时平行于C-Br键;从基态1A′到激发态2A′的跃迁矩在对称面内,且与C-Br键成53.1°夹角.我们也讨论了正一溴丁烷(n-C4H9Br)在234 nm和267 nm附近光解时的避免交叉几率(Avoided crossingprobability),以及它对单通道相对产额(Relative fraction of the individual pathways)的影响.     

40Ar+诱导无定形碳到金刚石纳米晶相变的研究

通过60 keV的⁴⁰Ar⁺辐照无定形碳靶合成了大量尺寸不同的金刚石纳米颗粒.高分辨透射电子显微镜配合能量色散X射线谱和电子衍射以及Raman谱分析的结果表明，这些嵌于具有扰动石墨结构薄膜中的纳米金刚石颗粒，其成核率很高(约为10¹³/cm²)，而且可以生长到较大的尺寸，有的甚至可以达到微米量级.对其相转变过程也进行了初步探讨. 关键词： 离子束 金刚石纳米晶 相变 透射电子显微镜     

低速高电荷态离子40Ar16+与云母表面作用中的电子发射研究

报道了由兰州ECR源提供的低速高电荷离子40Ar16 入射到云母表面产生的电子发射的实验测量结果.结果发现,电子发射产额Y与离子入射角ψ有近似1/tanψ的关系.基于经典过垒模型,我们对这一关系进行了理论分析.实验结果和理论结果相当符合,这就间接说明势能电子发射是低速高电荷态离子作用于表面发射电子的一个主要途径.     

Study of nitrogen ion implantation and diffusion phenomena on thin chromium layers followed by the atomic force microscopy and secondary ion mass spectroscopy techniques characterization

This research investigates the effect of ion implantation dosage level and further thermal treatment on the physical characteristics of chromium coatings on Si(1 1 1) substrates. Chromium films had been exposed to nitrogen ion fluencies of 1 × 10¹⁷, 3 × 10¹⁷, 6 × 10¹⁷ and 10 × 10¹⁷ N⁺ cm⁻² with a 15 keV energy level. Obtained samples had been heat treated at 450 °C at a pressure of 2 × 10⁻² Torr in an argon atmosphere for 30 h. Atomic force microscopy (AFM) images showed significant increase in surface roughness as a result of nitrogen ion fluence increase. Secondary ion mass spectroscopy (SIMS) studies revealed a clear increased accumulation of Cr₂N phase near the surface as a result of higher N⁺ fluence. XRD patterns showed preferred growth of [0 0 2] and [1 1 1] planes of Cr₂N phase as a result of higher ion implantation fluence. These results had been explained based on the nucleation-growth of Cr₂N phase and nitrogen atoms diffusion history during the thermal treatment process.     

射频磁控溅射法制备薄膜电池电极的计算机模拟初步

计算机模拟仿真射频磁控溅射实验制备薄膜及离于电池电极,研究了在特定实验条件下薄膜的生长过程,并分析了影响薄膜生长的部分因素。     

Holographic interferometry as electrochemical emission spectroscopy of a carbon steel in 5–20 ppm TROS C-70 inhibited seawater

In the present investigation, holographic interferometry was utilized for the first time to determine the rate change of the number of the fringe evolutions during the corrosion test of a carbon steel in blank seawater and seawater with different concentrations of a corrosion inhibitor. In other words, the anodic dissolution behaviors (corrosion) of the carbon steel were determined simultaneously by holographic interferometry, as an electromagnetic method, and by the electrochemical impedance (EI) spectroscopy, as an electronic method. So, the abrupt rate change of the number of the fringe evolutions during corrosion tests, EI spectroscopy, of the carbon steel is called electrochemical emission spectroscopy. The corrosion process of the steel samples was carried out in blank seawater and seawater with different concentrations, 5–20 ppm, of TROS C-70 corrosion inhibitor using the EI spectroscopy method, at room temperature. The electrochemical-emission spectra of the carbon steel in different solutions represent a detailed picture of the rate change of the anodic dissolution of the steel throughout the corrosion processes. Furthermore, the optical interferometry data of the carbon steel were compared to the data, which was obtained from the EI. spectroscopy. Consequently, holographic interferometry is found very useful for monitoring the anodic dissolution behaviors of metals, in which the number of the fringe evolutions of the steel samples can be determined in situ.     

An improved injector bunching geometry for ATLAS

The bunching system of the ATLAS positive ion injector (PII) has been improved by relocating the harmonic buncher to a point significantly closer to the second stage sine-wave buncher and the injector LINAC. The longitudinal optics design has also been modified and now employs a virtual waist from the harmonic buncher feeding the second stage sine-wave buncher. This geometry improves the handling of space charge for high-current beams, significantly increases the capture fraction into the primary rf bucket and reduces the capture fraction of the unwanted parasitic rf bucket. Total capture and transport through the PII has been demonstrated as high as 80% of the injected dc beam while the population of the parasitic, unwanted rf bucket is typically less than 3% of the total transported beam. To remove this small residual parasitic component a new traveling-wave transmission-line chopper has been developed reducing both transverse and longitudinal emittance growth from the chopping process. This work was supported by the U.S. Department of Energy under contract W-31-109-ENG-38.     

Study of the spontaneous formation of organic layers on carbon and metal surfaces from diazonium salts

This study investigates the spontaneous grafting of different para-substituted phenyl groups on carbon and metallic surfaces from diazonium salts solutions. Glassy carbon, nickel, zinc and iron plates were allowed to react with an acetonitrile solution of aryldiazonium tetrafluoroborate salt by simple dipping. The surfaces were characterized before and after their immersion by XPS and AFM to evidence the formation of a coating on the different materials. The results are indicative of the presence of substituted phenyl groups on all the investigated surfaces. This study also aims at correlating grafting efficiency with metal reactivities and diazonium salt electronic properties by means of AFM and FT-IRRAS. For this purpose, zinc and nickel were chosen due to their opposite reducing properties and two diazonium salts were selected with electron-donor or -withdrawing para-substituents. The results tend to indicate that redox properties of both partners (diazonium + metal) are of prime importance for grafting to occur.     

HIRFL注入器PIG离子源的研制

本文介绍了兰州重离子加速器(HIRFL)的注入器(SFC)所用PIG离子源的研制和改进工作,使用新研制的PIG源,已在注人器SFC上获得了5μA的O_(16)~(5+)及10μA的C_(16)~(4+)的离子束。     

Laser vaporization: A versatile method for studying metal clusters

Vaporizing solid samples of metals and semiconductors with a YAG Laser is a method well suited for producing molecules and clusters of those materials. The clusters are examined by either laser-induced fluorescence (LIF) or mass spectroscopic methods. The technique is valuable for both gas phase and matrix studies. The method is described and some applications, studying either the structure of small metal molecules or their reactions, are reviewed, with emphasis on our recent results from the LIF studies of LiBe, Al₂ and the reaction of Al with oxygen, yielding A1₂O. For larger clusters, Ion Cyclotron Resonance is an extremely valuable method, as we demonstrate by its application to the reactions of small charged silicon clusters with strong oxidising agents.