水热法制备高纯超细CeO2-ZrO2复合氧化物

Superfine composite powders of CeO₂-ZrO₂ (CZ) and CeO₂-ZrO₂-La₂O₃ (CZL) were prepared by hydrothermal method. The effects of pH、temperature and time for hydrothermal process on the performance of the resulting powders were studied. The optimized reaction parameters were on follows: the precursor′s pH≈9.0, hydrothermal temperature of 200 ℃ holding for 2 h. Thermal stable powders with average particle size smaller than 10 nm and specific surface area of 171 m²·g^-1 were obtained. A BET specific surface area was still at 44 m²·g^-1 after calcination at 1 000 ℃ for 6 hours.     

Dislocation Analysis for Large-sized Sapphire Single Crystal Grown by SAPMAC Method

In this paper,large-sized sapphire (230×210 mm,27.5 kg) was grown by SAPMAC method (sapphire growth technique with micro-pulling and shoulder-expanding at the cooled center). Dislocation peculiarity in large sapphire boule (0001) basal plane was investigated by chemical etching,scanning electron microscopy and X-ray topography method. The triangular dislocation etch pit measured is 7.6×101～8.0×102 cm-2,in which relative high-density dislocations were generated at both initial and final stages of crystal growth. The analysis of single-crystal X-ray topography shows that there are no apparent sub-grain boundaries; the dislocation lines are isolated and straight. Finally,the origins of low-density dislocation in sapphire crystal are discussed by numerical analysis method.     

An Absence of Non-specific Immune Response towards para-Sulphonato-calix[n]arenes

The effects of para-Sulphonato-calix[4]arene, para-Sulphonato-calix[6]arene and para-Sulphonato-calix[8]arene on the activation of NADPH oxidase in neutrophils has been studied. All three molecules do not induce NADPH oxidase activation, and hence do not stimulate neutrophils. Measurement of cell viability demonstrates that these three water-soluble calix[n]arene derivatives are not cytotoxic.     

矿区植物重金属元素测定的两种前处理方法比较

分别采用酸消解法和干灰化法处理16种矿区植物,并用原子吸收分光光度法测定其中的Mn、Cd、Cr和Zn的含量。结果表明:除Cd外,两种处理方法对Mn、Cr、Zn的测定结果有明显影响。测定植物组织Cd时,两种处理方法都可采用;测定Mn、Cr元素,采用酸消解法较为合适;测定Zn则宜采用干灰化法,并可适当延长木质部分(根、茎)的灰化时间。     

双波长K系数—标准加入吸光光度法同时测定锰和锌

研究应用双波长K系数—标准加入吸光光度法同时测定锰和锌二组分混合物.试验确定了锰和锌测定中K_(Mn)与K_(Zn)的回归方程.对合成试样、人发试样测定,结果满意.     

铜的催化褪色动力学-负吸光度法测定

以催化褪色动力学光度法测铜为例 ,对负吸光度法用于褪色法能提高准确度与灵敏度、扩展线性范围、减小共存离子干扰及操作简便规范等的原因进行了系统的研究 ;实例表明 ,间接摩尔吸光系数为1.71×107L·moL -1·cm -1,可测浓度范围为40～3600ng·L -1及相对标准偏差为0.8%(n=9) ,均明显优于用经典吸光度法测定 ,且催化温度降低 ,反应时间缩短并省去反应抑制剂 ,较原方法易于操作     

Analysis of thermal behaviour of high power semiconductor laser arrays by means of the finite element method (FEM)

New results of steady-state two-dimensional finite-element computations of temperature distributions of high power semiconductor laser arrays are presented. The influence of different thermal loads on the 2D temperature distribution in AlGaAs/GaAs gain-guided laser arrays is investigated. TheFEM model is tested by comparing it with analytical solutions. For numerical convenience, the latter is rewritten in a novel form, which is free of overflow problems. The maximum temperatures calculated by both methods agree within 1%. Several factors determining the thermal resistance of the device are quantitatively examined: the ratio of light emitting to non-emitting areas along the active zone, the amount of Joule losses, the current spreading, the solder thickness, and voids in the solder. This yields design rules for optimum thermal performance.     

Non-stoichiometry of YBa2Cu3O7-d Observed by Repeated Temperature Scanning

Repeated temperature scanning method was applied to observe non-stoichiometry of YBa₂Cu₃O₇-d, and interesting results were obtained. Two simultaneously occurring processes were separately observed in mass change; one is a fast process and the other is slow, so that their responses to the temperature change are quite different from each other. The fast process follows the cyclic temperature change, but the slow process is observed to be a gradual mass change. Kinetic behaviors of these two processes are also made clear by plotting the mass vs. the temperature. Furthermore, a hysteresis loop was observed in the plot of the mass vs. the temperature in a high temperature range presumably due to the third process, and it depends on the heating and cooling rates. This revised version was published online in July 2006 with corrections to the Cover Date.     

Dynamic headspace liquid-phase microextraction of alcohols

A method was developed using dynamic headspace liquid-phase microextraction and gas chromatography-mass spectrometry for extraction and determination of 9 alcohols from water samples. Four different solvents, hexyl acetate, n-octanol, o-xylene and n-decane were studied as extractants. The analytes were extracted using 0.8 microl of n-octanol from the headspace of a 2 ml sample solution. The effect of sampling volume, solvent volume, sample temperature, syringe plunger withdrawal rate and ionic strength of the solution on the extraction performance were studied. A semiautomated system including a variable speed stirring motor was used to ensure a uniform movement of syringe plunger through the barrel. The method provided a fairly good precision for all compounds (5.5-9.3%), except methanol (16.4%). Detection limits were found to be between 1 and 97 microg/l within an extraction time of approximately 9.5 min under GC-MS in full scan mode.     

选相原位法合成立方氮化硼的关键影响因素

利用选相原位法在水溶液中成功制备出了立方氮化硼晶体，对反应条件进行了优化。结果表明，利用选相原位法合成立方氮化硼的最佳实验条件是：反应压力为10.0 MPa，在氯离子加入下利用混合氮源进行反应。在该条件下得到了纯相的立方氮化硼晶体。