Morphological and chemical study of the initial growth of CdS thin films deposited using an ammonia-free chemical process

We study the initial growth stages of CdS thin films deposited by an ammonia-free chemical bath deposition process. This ammonia-free process is more environmentally benign because it reduces potential ammonia release to the environment due to its high volatility. Instead of ammonia, sodium citrate was used as the complexing agent. We used atomic force microscopy (AFM), Rutherford backscattering (RBS) and X-ray photoelectron spectroscopy (XPS) to investigate the morphological and chemical modifications at the substrate surface during the first initial stages of the CdS deposition process. Additionally, X-ray diffraction (XRD) and optical transmission spectroscopy measurements were carried out to compliment the study. XPS results show that the first nucleation centers are composed by Cd(OH)₂ which agglomerate in patterns of bands, as demonstrated by AFM results. It is also observed that the conversion to CdS (by anionic exchange) of the first nucleus begins before the substrate surface is completely covered by a homogenous film.     

助熔剂N_aCl－CdCl_2对CdS∶Cu，In结晶状态作用规律研究

发现在确定的热处理温度和时间下，随炉料中助熔剂ＮａＣｌ－ＣｄＣｌ２，总含量的增加，ＣｄＳ：Ｃｕ，Ｉｎ多晶的粒度分布变窄，数均粒径具有最大值，晶粒外型趋于规整且表面平滑．进而证明，多晶的结晶状态对其光电性能具有显著的影响．     

A column packing for isothermal gas chromatographic analysis of C1−C5 paraffins and monoolefins and dimethyl ether

Summary An analytical GC method was developed which uses a single packed column consisting of three packings in series prepared with the following liquid phases: dimethyl sulfolane, propylene carbonate, and silver nitrate. This system provides satisfactory resolution of mixtures of C₁–C₅ hydrocarbons and dimethyl ether obtained when converting methanol to gasoline. Due to the high capacity of the column it is possible to inject larger sample amounts permitting trace analysis.     

简便快速的硫化氢测定法

本文提出了有一种简易快速测定剂来测定水样中的硫化氢的方法。该法的检出限为０．１ｍｇ／Ｌ，对１．０１ｍｇ／Ｌ的Ｈ２Ｓ样品７次测定的相对标准偏差＜４．１％，１ｈ能测定１２个样品。用本测定了几种水样中的Ｈ２Ｓ含量，回收率为８４％－１０５％。应用它可上标准法的４ｈ左右缩短到５ｍｉｎ；使分析成本降低９／１０；不需配制一系列分析试剂和仪器，只需一支小型塑料管和几片药片，便于渔业水质和环境水质的野外现场监测。     

耐硫催化剂上合成混合醇的研究

通过改进制备方法和添加助剂，用浸渍－热分解法制得了具有高活性和高选择性的MoS2-K-C型耐硫低碳混合醇催化剂。在8.0-11.0MPa,290-340℃，6000-12000h^-1,H2 S 浓度为100ppm 左右的条件下，在直流反应器中对催化剂进行了性能测试，结果表明，醇得率为0.14-0.47gROH(gcat·h)^-1，选择性为89-98%。同时，考察了操作条件对催化剂性能的影响。1042h的试验，证明催化剂具有很好的稳定性。     

碱改性γ－Al_2O_3催化剂表面碱强度分布与COS水解活性的研究

用非水滴定法和Ｈａｍｍｅｔｔ系列指示剂测定了ＣＯＳ水解碱改性γ－Ａｌ_２Ｏ_３催化剂的表面碱强度分布．发现表面碱强度分布不均匀与表面能量分布不均匀相呼应．采用零点酸碱强度（Ｈ_（０，ｍａｘ））及碱中心区域分析法，Ｂｒｏｎｓｔｅｄ催化定律，进一步证实ＣＯＳ水解反应具有明显碱催化特征，较高活性催化剂的Ｈ_（０，ｍａｘ）一般为１０左右，对ＣＯＳ水解反应起主要作用的碱性中心的碱强度（Ｈ_０）为４．８≤Ｈ_０≤９．８．对碱金属氧化物改性后的γ－Ａｌ_２Ｏ_３催化剂，Ｂｒｏｎｓｔｅｄ规律在每个碱强度分区域内是适用的．     

Thermolysis of reactive oligo(p-phenylene sulfide) containing disulfide bond

Oligo(phenylene sulfide) (OPS) containing one disulfide bond at the end of the chain, which was obtained by the oxidative polymerization of diphenyl disulfide, had a relatively low Td_10%(temperature for 10% weight loss) of 412 °C because of degradation of the disulfide bond. But this thermal cleavage of the disulfide bond promoted the curing reaction through thiophenoxy radical formation. OPS was allowed to react with diiodobenzene at 220 °C. The thermal stability of OPS was improved through the consumption of the disulfide bond and the coupling of the chain.     

Mesoporous material as catalyst for the production of fine chemical: Synthesis of dimethyl phthalate assisted by hydrophobic nature MCM-41

Aluminum, iron and zinc containing MCM-41 molecular sieves were prepared by the hydrothermal method. The catalyst was characterized by the XRD, BET (surface area), FT–IR and ²⁹Si, ²⁷Al MAS–NMR techniques. The catalytic activity of these molecular sieves was tested with esterification reaction used with phthalic anhydride (PAH) and methanol (MeOH) in the autoclave at 135 °C, 150 °C and 175 °C. Conversion increases with an increase in temperature and mole ratio. The activity of these catalysts followed the order: Al-MCM-41 (112) > Fe-MCM-41 (115) > Al-MCM-41 (70) > Al-MCM-41 (52) > Fe-MCM-41 (61) > Al, Zn-MCM-41 (104) > Al-MCM-41 (30). The reaction yielded both monomethyl phthalate (MMP) and dimethyl phthalate (DMP). The nature of the catalyst sites has been proposed using with water as an impurity. The selectivity of the dimethyl phthalate increases with increase in temperature and mole ratio. The weight of the catalyst was optimized at 0.07 g. The hydrophilic and hydrophobic nature of the catalyst has been explained by the influence of water and the external surface acidity also facilitates the reaction and this has been confirmed by the supporting reaction.     

聚-4,7-二硫杂壬基倍半硅氧烷铑配合物的合成与催化硅氢化性能

本文叙述了一种新型有机硅聚合物负载配位催化剂——聚-4,7-二硫杂壬基倍半硅氧烷铑配合物的合成、结构及其对烯烃硅氢化反应的催化性能.标题配合物在用量为烯烃摩尔量的十万分之一时仍具有良好的催化活性,烯烃的转化数达到80,000.     

ZrO2对合成二甲醚双功能催化剂表面结构及催化性能的影响

采用共沉淀沉积法制备了Cu基双功能催化剂，并进行了合成气一步法制取二甲醚实验．XRD、XPS以及BET表征结果表明，催化剂中ZrO2以无定形状态存在，且随着其含量的增加，Zr^4 逐渐溶进CuO晶格，两者之间的电子交换使得Cu^2 在活化过程中很难被彻底还原为Cu^0，而是以Cu^0/Cu^ 的形式共存．活性评价结果表明，Cu^ 离子表现出优异的CO转化率和DME选择性．同时，ZrO2的存在能有效调节催化剂表面的Cu／Zn摩尔比以及促进Cu元素在表面的富集，从而改善催化剂性能．