连续碳纤维增强的聚芳醚酮在Ⅰ型循环载荷下的层间破坏

用双悬臂梁(DCB)试件研究了连续碳纤维增强的聚芳醚酮复合材料(CF/PEK-C),在Ⅰ型循环载荷作用下的层间裂纹扩展行为.循环载荷采用载荷控制模式,最小载荷与最大载荷之比为0.5.在疲劳试验中,仍然发现有“阻力曲线”现象存在.层间裂纹扩展速率用指数定律与相应的应变能释放速率联系起来,并对结果进行了讨论.     

ELECTRORHEOLOGICAL PROPERTIES OF POLYANILINE/PUMICE COMPOSITE SUSPENSIONS

Electrorheological （ER） properties of polyaniline （PAni）, pumice and polyaniline/pumice composites （PAPC） were investigated. Polyaniline and PAni/pumice composite were prepared by oxidative polymerization. PAni/pumice particlesbased ER suspensions were prepared in silicone oil （SO）, and their ER behavior was investigated as a function of shear rate, electric field strength, concentration and temperature. Sedimentation stabilities of suspensions were determined. It has been found that ER activity of all the suspensions increases with increasing electric field strength, concentration and decreasing shear rate. It has shown that the suspensions have a typical shear thinning non-Newtonian viscoelastic behavior. Yield stress of composite suspensions increased linearly with increasing applied electric field strength and with concentrations of the particles. The effect of high temperature on ER activity of purrfice/silicone oil systems was also investigated.     

TiO_2/PVDF复合中空纤维膜的制备和表征

采用相转化法制备了二氧化钛 (TiO2 ) 聚偏氟乙烯 (PVDF)复合中空纤维膜 .应用牛血清白蛋白截留实验、扫描电子显微镜、热重分析、X射线衍射分别对复合膜的分离性能、微观结构、热稳定性和晶相组成进行了分析 .结果表明复合膜的性能与纯PVDF膜的相比有显著的改善 ,其中对牛血清白蛋白的截留率从 3 2 7%提高到 86 6 7% ,单根纤维的断裂应力从 3 35MPa提高到 4 70MPa ,提高了 4 0 3% .氮气吸附实验测定的孔径分布进一步表明复合膜的孔径分布变窄 ,孔径变小 .     

Effects of EG and MoSi2 on thermal degradation of intumescent coating

An intumescent flame retardant coating was prepared with resin, solvent and flame retardant system composed of ammonium polyphosphate-APP, pentaerythritol-PER and melamine-MEL. The modifiers such as molybdenum disilicide (MoSi₂) and expandable graphite (EG) were used to improve the performances of the APP-PER-MEL coating. The effects of EG, MoSi₂ and MoSi₂/EG on the fireproofing time and char formation of the coating were investigated by using heat insulation test, thermogravimetric analysis (TGA), differential thermal analysis (DTA), X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS) and scanning electric microscope (SEM). The results showed that by adding modifiers, the fireproofing time was prolonged and char formation rate was evidently enhanced. The largest improvement was achieved with 9 wt.% MoSi₂/5 wt.% EG, XPS analysis indicated that the performance of anti-oxidation of the coating was improved by adding EG and MoSi₂, and SEM images showed that a good synergistic effect was obtained through a ceramic-like layer produced by MoSi₂ covered on the surface of “open-cellular” structural char.     

包覆重钙粉为填充剂的橡胶加工及性能

重钙粉作为填充剂被广泛应用于橡胶加工过程,但由于其表面具有极性,分散性较差,导致与橡胶材料界面结合较差,影响了橡胶产品的抗拉强度、断裂伸长率等力学性能。 本文采用沉淀法,在CaCl₂-H₂O-NH₃-CO₂体系中生成碳酸钙直接结晶于重钙粉颗粒表面,实现对重钙粉的表面包覆,将n(CaCl₂)：n(重钙粉)=1：100、5：100、10：100的包覆重钙粉填充到天然橡胶和再生胶中,橡胶的力学性能与填充未包覆重钙粉的橡胶相比有了一定的提升。 通过比较,在填充量较大(8.5%、15%)时,包覆重钙粉橡胶产品在硬度、定伸应力等力学性能上要好于轻钙粉橡胶产品;在填充量(5%、8.5%)时,包覆重钙粉橡胶产品的抗拉强度、断裂伸长率接近于白炭黑,硬度高于白炭黑橡胶产品。     

Hydrothermal Synthesis and Thermal Stability of Natural Mineral Lindgrenite

IntroductionSynthesis of natural minerals is helpful for tracingthe geological origin of mineral formation and forverifying the quality of minerals. The investigations onthe conditions for mineral formation, such as pressure,temperature, and starting mate…     

Electroanalytical sensors for nonconducting media based on electrodes supported on perfluorinated ion-exchange membranes

Electroanalytical sensors, suitable for the analysis and monitoring of electroactive analytes present in gaseous phase or low-conductive liquid media, and based on electrodes in close contact with perfluorinated ion-exchange polymers are reviewed. The basic operative mechanism of these sensors, in which ion-exchange polymers act as solid polymer electrolytes (SPE's), is thoroughly discussed, while stressing the fundamental reasons why their behavior differs from that of conventional membrane electrodes. The procedures for preparing composite working electrodes by coating one side of ion-exchange membranes with stable porous films of conductive materials are described, along with the most common strategies followed to assemble this type of sensors. Useful examples of measurements in electrolyte-free media of inorganic and organic electroactive species of interest mainly for environmental analysis are given. Future prospects for the development of these sensors are also discussed.     

Preparation and characterization of mono-valent ion selective polypyrrole composite ion-exchange membranes

Polypyrrole composite cation- and anion-exchange membranes (CEM and AEM), in which polypyrrole (PPY) coated on one surface of the membrane as a thin layer, were prepared by chemical polymerization of pyrrole in the presence of high oxidant concentration (Na₂S₂O₈). Existence of polypyrrole layer on the both types of ion-exchange membranes were confirmed by recording their coating density, SEM images and conductivity. These membranes were extensively characterized by recording their properties such as water uptake, ion-exchange capacity, contact angle, permselectivity and membrane conductivity as a function of polymerization time such as. It was observed that due to coating of PPY for 2 h, membrane permselectivity of CEM for NaCl (0.907) was reduced to 0.873, while it was increased from 0.747 to 0.889 in the case of AEM. Similar behaviors were also obtained for bi-valent electrolytes. Electrodialysis experiments were also conducted with polypyrrole composite ion-exchange membranes using mixed electrolytic systems. Relative dialytic rates for NaCl with respect to other bi-valent electrolyte were varied in between 5 and 8 (depending on bi-valent electrolyte), which suggested the feasible and efficient separation of mono-valent from bi-valent electrolyte. Slower electro-migration of bi-valent electrolyte (CaCl₂, MgCl₂ and CuCl₂) in comparison to NaCl was explained on the basis of synergetic effect of sieving of bulkier bi-valent cations by tight and rigid polypyrrole layer and the difference in electrostatic and hydrophobic–hydrophilic repulsion force between bi-valent cations and mono-valent cation. It was concluded that these composite membranes are suitable for the efficient separation of same type of charged ions by electro-driven separation techniques.     

Characterization of chromate conversion coating on AA7075‐T6 aluminum alloy

Chromate conversion coatings (CCCs) on AA7075‐T6 were characterized using scanning electron microscopy, focused ion beam sectioning and scanning transmission electron microscopy with nano‐electron dispersive spectroscopy line profiling. The thickness and composition of the CCC was different at different locations on the heterogeneous microstructure of AA7075‐T6. The coating formed on the matrix phase was much thicker than that formed on the coarse Al–Cu–Mg, Al–Fe–Cu and Mg–Si intermetallic particles. Nano‐electron dispersive spectroscopy line profiling indicated that the coating on the Al–Fe–Cu particles was similar to the CCC formed on the phase matrix, primarily a chromium oxide. However, the coatings on the Al–Cu–Mg and Mg–Si particles were mixed Al/Mg/Cr oxide and Mg oxide, respectively. The growth of CCC followed a linear‐logarithmic kinetic rate law. The observations of this study support the sol‐gel model of CCC formation. Copyright © 2004 John Wiley & Sons, Ltd.     

Solid phase immune reactions as monitored by sedimentation field-flow fractionation

Summary Sedimentation field-flow fractionation was shown to permit the precise evaluation of surface concentrations of human IgG, adsorbed to polystyrene latex spheres of different sizes. Unlike conventional techniques for measuring protein uptake by colloidal substrates, this method allowed a direct evaluation of mass adsorbed per unit area, without the need for potentially destructive labelling reactions. Thus, a four hour adsorption of IgG from a 3–10 fold excess of protein in solution yielded surface concentrations which were 1.4±0.1 mg/m² on a 272 nm latex and 1.9±0.1 mg/m² on a latex with a diameter of 142 nm. The lower value coincided with the estimated monolayer surface coverage. The IgG-PS 272 nm adsorption complex was shown to take up negligible amounts of HSA from a 10 mg/mL solution, while its specific uptake of a polyclonal rabbit anti-human IgG was 2.6 molecules per molecule of adsorbed antigen. The same ratio was found for the smaller particles. The surface concentration of adsorbed second antibody, often crucial in immunodiagnostic quantifications, was therefore found to be significantly enhanced by the increased substrate curvature presented by the smaller particles.Dedicated to Professor Leslie S. Ettre on the occasion of his 70th birthday.