钛硅分子筛挤条成型催化剂热稳定性能的研究

采用在空气中程序升温焙烧的方式考察了钛硅分子筛挤条成型催化剂的热稳定性能．对不同温度焙烧得到的样品进行了XRD、IR、UV Raman和SEM表征．结果表明，在高温焙烧时，由于载体结构的改变引起载体与分子筛之问相互作用发生变化，导致成型催化剂中分子筛骨架破坏．随着焙烧温度的提高，IR谱图中960cm^-1处代表钛进入骨架的特征峰的强度迅速减弱，当焙烧温度达到1000℃时，960cm-1处的骨架钛特征峰移至948cm^-1．在紫外拉曼谱图中，骨架位钛物种的特征拉曼谱峰-1125cm^-1谱峰在加入SiO2载体后，高温下峰强度明显降低，这说明载体的加入降低了钛硅分子筛挤条成型催化剂的热稳定性能．     

内含式化合物X@B12P12的结构与稳定性研究

采用B3LYP/6-31G*方法，对内含式化合物X@B₁₂P₁₂(X=Li^0/+、Na^0/+、K^0/+、Be^0/2+、Mg^0/2+、Ca^0/2+、H和He)的不同对称性构型进行了计算，讨论其最稳定构型的几何参数、布居分析、偶极矩、电离势、包含能、振动频率、能隙和自旋密度． 发现在X@B₁₂P₁₂化合物中，客体X=Li、Na^0/+、K^0/+、Mg^0/2+、Ca^0/2+和He处在偏离笼的中心0.006 nm的半径内． Be²⁺沿着C₃轴偏离中心点0.279 nm． 在Be@B₁₂P₁₂和H@B₁₂P₁₂的基态结构中，Be和H与笼上的B原子成键． 除Li@B₁₂P₁₂、 Be²⁺@B₁₂P₁₂和He@ B₁₂P₁₂外， 其余结构为C_s对称稳定构型．     

ANPZ的合成及ANPZ·DMSO(1:1)晶体结构

富氮杂环化合物被认为是理想的高威力含能材料,因为这些化合物大多具有高的分子密度、低易损性和正的生成焓[1].2,6-二氨基-3,5-二硝基吡嗪(ANPZ)是一种富氮杂环含能材料,也是合成新型高能钝感含能材料2,6-二氨基-3,5-二硝基吡嗪-1-氧化物(LLM-105)的前体.     

利用微生物直接生产羟基丁酸单体

利用重组大肠杆菌E.coli HB101来进行直接生产羟基丁酸(HB)手性单体,研究了含pUCAB质粒的重组体E.coli HB101在各种条件下生长及积累HB单体的情况,研究了HB单体的积累随pH值变化的规律。结果表明,pH=6.8时,48 h内细菌可生产0.5 g/L以上的HB单体。     

取代基对氮和氧自由基稳定性影响的理论研究

用MNDO方法，全构型优化，研究了15个氮自由基4-RC6H4NH，和15个氧自由基4-RC6H4O（R＝－H；－OCH3，－Cl，－F，－CN，－COCH3，－NO2，－CH3，－CF3，－SCH3，－C6H5，－Nh2，－BH2，－PH2，－SiH3）的稳定化能．结果表明：－NH2，－CH3，－OCH3，－F基团对自由基起稳定化作用，－CF3，－NO2；－CN，－COCH3，－BH2基团对自由基起去稳定化作用．苯基对氧自由基有较大的稳定化作用，而对氮自由基的稳定性影响较小．－SCH3，－PH2，－SiH3，－Cl基团表现弱的去稳定化作用．计算和实验结果基本相符．     

1,2,4-三氮杂苯-(H2O)n复合物氢键相互作用的密度泛函理论研究

用密度泛函理论方法在B3LYP／6—31 G**水平上对1，2，4-三氮杂苯-(H2O)n(n=1，2，3)氢键复合物的基态进行了结构优化和能量计算，结果表明复合物之间存在较强的氢键作用，所有稳定复合物结构中形成一个N…H--O氢键并终止于弱O…H—C氢键的氢键水链的构型最稳定．同时，用含时密度泛函理论方法(TD—DPT)在TD—B3LYP／6—31 G**水平上计算了1,2，4-三氮杂苯单体及其氢键复合物的单重态第-1(n，π*)垂直激发能．     

含芯电子相关能修正的G2理论——G2(ful)

A general method in considering the core electronic correlation energies has been proposed and introduced into the standard Gaussian-2 (G2)[7] theory by small post-Hartree-Fock calculations. In this paper an additional MP2(FC)/6-31G(d) calculation over the G2 procedures is employed and examined in modification in modification to the flaw of Frozen-Core (FC) approximation of G2 vai eq.:
ΔE(full)= E[MP2(full)/6-31G(d)]-E[MP2(FC)/6-31G(d)]
where the MP2(full)/6-31G(d) energy has been obtained in the molecular geometry optimizations. This energy, ΔE(full), is directly added into the total G2 energy of a molecule in facilitating the effect of core electronic correlations for each molecule in chemical reactions. It has been shown that the over-all average absolute deviation for the 125 reaction energies of the G2 test set (test set 1) is slightly reduced from 5.09 to 5.01 kJ, mol(-1) while for the 55 D0 values, which have been used for the derivation of the A coefficient of the empirical High-Level...更多-Correction (HLC), it is also reduced from 4.99 [for both G2 and G2(COMPLETE)[8]]to 4.77 kJ• mol(-1). In addition, larger errors (greater than ±8.4 kJ•mol(-1) for the D0 energies are improved, especially for the largest error of the D0 of SO2 This error is reduced from 21.3 to 15.4 kJ. mol(-1), in which the experimental geometry would further reduce it by 7.1kJ.mol(-1)[8]. Another improvement is the absolute value of the A coefficient in HLC being reduced from 4.81 for G2 to 4.34 milli-hartrees which is believed to be useful in isolating the relationship between the HLC and the FC approximation. Modifications to the original G2 from this work is denoted as G2(fu 1) and thus the G2 (fu 1) total energy for a molecule is
E[G2(fu 1)]= E[G2]+Δ E(full)h
with a new ΔE[HLC] =-0.19α- 4.34nβ milli-hartree.     

用三乙胺盐酸盐对酚醛环氧树脂开环合成水溶性感光高分子的研究

用三乙胺盐酸盐与酚醛环氧树脂开环反应合成了一种水溶性聚合物，研究了相转移催化剂、反应时间、反应温度、开环顺序等条件对反应程度的影响。研究了开环反应中丙烯酸及三乙胺盐酸盐与酚醛环氧树脂的比例对产物的水溶性及感兴性能的影响。     

烷烃电离能和生成焓的相关性

根据化合物形成过程中价电子能量变化与生成焓之间的关系, 推导出烷烃的生成焓和电离能之间的关系. 以21个烷烃化合物为模型将实验测定的电离能与标准生成焓进行直接关联, 证实了模型方程的适用性, 所得回归方程的相关系数达到0.9999, 估算值与实验值之间的标准偏差仅为0.03 eV. 同时还利用实验测定的标准生成焓对一系列烷烃的电离能作了预测.     

Interlayer Energy Transfer from Naphthalene to Anthracene Chromophores Organized in Langmuir—Blodgett Films

Interlayer energy transfer between 2,3-naphthol-10-hexadecylaza-15-crown-5(NC16) and N-[1-(9-methoxyanthryl)] decylaza-15-crown-5(A10C) within multilayer Langmuir-Blodgett films has been studied by steady-state fluorescence spectra. The donor and acceptor could be separated precisely by inserting stearic acid (SA) spacers. The efficiency of the energy transfer increases with the decrease in the donor-acceptor distance by a quadratic manner, suggesting the donor excitations are delocalized in the layer.