Eu- and Yb-induced reconstructions on a vicinal Si(1 0 0) surface

Early stages of rare-earth metal (Yb and Eu) growth on a vicinal, single-domain Si(1 0 0)2 × 1 surface have been studied in the coverage range of 0.1-0.3 monolayer (ML) by low energy electron diffraction, scanning tunneling microscopy, and synchrotron radiation photoemission spectroscopy. We show that Yb induces the 2 × 3 periodicity in the whole range of coverage studied. The 2 × 3 reconstruction coexists with the local 3 × 2/4 × 2 structure at about 0.2 ML of Yb. In contrast, Eu forms the 3 × 2 periodicity at 0.1-0.2 ML, whereas this structure is converted into the 2 × 3 phase at about 0.3 ML. The atomic arrangement and electronic properties of these reconstructions and the adsorbate-mediated modification of surface morphology are investigated.     

BEPCII直线加速器相控系统设计研究

为了补偿由于各种因素引起的微波相位漂移,BEPCII直线加速器需要建立微波相位反馈控制系统.能量最大法将用来确定每台功率源的最佳相位.沿直线加速器速调管长廊铺设相位稳定同轴线提供相位参考.现在已经完成了关键部件,如PAD单元、IfA 单元的开发.搭建了相控最小系统对系统进行了验证.     

温度对PSⅡCP4 7/D1/D2/Cytb559复合物荧光光谱特性的影响

采用激励光源为514.5 nm的分幅扫描单光子计数荧光光谱装置对经20℃、42℃和48℃不同温度处理后的反应中心复合物CP47/D₁/D₂/Cyt b559的荧光光谱特性进行了研究.经解析,获得不同温度处理后,CP47/D₁/D₂/Cyt b559复合物最大峰值未发生变化,均在682 nm,说明Chla670的能量都由Chla682接收,但损耗愈来愈小,在48℃时,损耗程度最小,而其荧光百分比未发生多大变化.振动副带～700 nm和～740 nm的中心波长都发生蓝移,在不同温度下分别为:20℃ 703 nm,749 nm;42℃ 697 nm,744 nm;48℃ 694 nm,740 nm.因此可以推测温度的升高,影响了CP47/D₁/D₂/Cyt b559色素蛋白的二级结构以及色素分子的空间位置,使最大峰值处的荧光强度逐渐降低,振动副带逐渐蓝移.42℃的温度已造成影响,48℃影响较大.     

用PM3量化参数预测多氯代二苯并呋喃的logKow

从现有的PCDFs分子的正辛醇 /水分配系数 (logKow)实验数据出发 ,建立定量结构 性质关系方程(QSPR) .采用G98W程序包中的PM3方法对 13 5个多氯代二苯并呋喃 (PCDFs)分子和二苯并呋喃进行了优化计算 ,作业命令为 #pPM3optfreqscf(conver =9) ,以计算所得的分子轨道能量、碳原子电荷作为PCDFs分子结构描述符 ,运用多元线性回归技术建立了PCDFs的logKow与分子结构描述符的四元方程 ,最优相关系数为 0 .95 0 7,标准偏差为 0 .173 7,经检验该模型的稳健性好 ,并对未有实验数据的 85个PCDFs的logKow进行预测     

成分和厚度的依赖

通过调整Mn的成分，系统地研究了Ni81Fe19/Ni100-xMnx双层膜的磁学性质，特别是交换偏置场(Hex)的变化.当Ni100-xMnx中Mn的原子百分比在534%到600%之间时，对于150nm的Ni81Fe19，得到了最大的交换偏置场175kA/m，同时由于Mn对Ni81Fe19层的扩散所造成的磁矩的降低小于20%；高角x射线衍射证明Ni100-xMnx的晶格常数随着Mn成分的改变而变化，Mn含量越多，其晶格常数越大；制备态Ni100-xMnx膜晶格常数与θ相NiMn膜晶格常数的接近程度与NiMn膜θ相形成的容易程度相对应.也研究了交换偏置场随着Ni１００-xMnx厚度的变化，第一次得到了当Ni100-xMnx中Mn的原子百分比为706%时，Ni81Fe19(150nm)/Ni100-xMnx(90nm)双层膜在经过240℃，5h退火后，可以有80kA/m的交换偏置场，此时铁磁层磁矩的大小几乎不变. 关键词： Ni81Fe19/Ni100-xMnx 交换偏置场     

Stationary entanglement between macroscopic mechanical oscillators

We show that the optomechanical coupling between an optical cavity mode and two movable cavity mirrors is able to entangle two different macroscopic oscillation modes of the mirrors. This continuous variable entanglement is maintained by the light bouncing between the mirrors and is robust against thermal noise. In fact, it could be experimentally demonstrated using present technology. Received 2 September 2002 / Received in final form 10 October 2002 Published online 7 January 2003     

On a new calcium vanadate: synthesis, structure and Li insertion behavior

A synthetic form of the mineral hewettite was prepared via a new route in aqueous medium, starting either from the crystalline compound Li_1.1V₃O₈, or from its amorphous precursor. The anhydrous, crystalline derivative Ca_0.5V₃O₈ was obtained by heating the synthetic hewettite at 250°C under dynamic vacuum. The diffraction studies show that the 2D structure of Ca_0.5V₃O₈ involves the same V₃O₈ layers as in the hewettite or in Li_1+αV₃O₈. The stacking of the layers is similar to that in the metahewettite. A structural model is proposed, where the Ca²⁺ ions occupy octahedral sites in the interlayer space. The electrochemical behavior of Ca_0.5V₃O₈ vs. lithium insertion is presented. It is original and reveals particularly good performances in terms of stability during cycling at C/5 rate. The homologues obtained with Mg or Ba, instead of Ca, are briefly presented.     

Electrochemical reduction of monothiobenzils in the presence of aroyl chlorides. First synthesis of (Z)-α-benzoyloxy-β-benzoylthiostilbenes

The first method for the synthesis of the title compounds has been established involving a stereoselective electrochemical diacylation process. The cathodic reductions of monothiobenzils in an aprotic medium, under constant potential, in the presence of twofold molecular amounts of aroyl chlorides provide previously unknown (Z)-α-benzoyloxy-β-benzoythiostilbenes in high to quantitative yields.     

Synthesis and conformational investigation of tetrapeptide analogues of the fragment B23-B26 of insulin

Tetrapeptides containing one of a set of four different α,α-dialkyl glycines at the C-terminus were synthesized by conventional methods in solution and their conformational behavior investigated by ¹H NMR spectroscopy in connection with molecular mechanics calculations. The results were consistent with conformations stabilized by a γ-turn in the case of compounds with alkyl groups larger than methyl, while the corresponding Aib derivative did not exhibit intramolecular hydrogen bonding.     

Numerical simulations of a filament in a flowing soap film

Experiments concerning the properties of soap films have recently been carried out and these systems have been proposed as experimental versions of theoretical two‐dimensional liquids. A silk filament introduced into a flowing soap film, was seen to demonstrate various stable modes, and these were, namely, a mode in which the filament oscillates and one in which the filament is stationary and aligns with the flow of the liquid. The system could be forced from the oscillatory mode into the non‐ oscillatory mode by varying the length of the filament. In this article we use numerical and computational techniques in order to simulate the strongly coupled behaviour of the filament and the fluid. Preliminary results are presented for the specific case in which the filament is seen to oscillate continuously for the duration of our simulation. We also find that the filament oscillations are strongly suppressed when we reduce the effective length of the filament. We believe that these results are reminiscent of the different oscillatory and non‐oscillatory modes observed in experiment. The numerical solutions show that, in contrast to experiment, vortices are created at the leading edge of the filament and are preferentially grown in the curvature of the filament and are eventually released from the trailing edge of the filament. In a similar manner to oscillating hydrofoils, it seems that the oscillating filaments are in a minimal energy state, extracting sufficient energy from the fluid to oscillate. In comparing numerical and experimental results it is possible that the soap film does have an effect on the fluid flow especially in the boundary layer where surface tension forces are large. Copyright © 2004 John Wiley & Sons, Ltd.