Slow crack growth in blends of HDPE and model copolymers

The resistance to slow crack growth (SCG) was measured in binary blends of high density polyethylene (HDPE) and 5–10% concentrations of model ethylene-butene random copolymers by measuring the time to failure (t_f) under a constant stress intensity. An increase of t_f with the addition of the copolymer if the copolymer could crystallize and the increase was greater the higher branch density. The copolymer with 117 branches/1000C could not crystallize and therefore its blend had a t_f that was less than that of the HDPE. The fracture energies of the blends as determined by their resistance to SCG were compared with the energy by rapid fracture, J_c, as previously measured by Rhee and Crist. It is concluded that SCG is more sensitive to variations in the microstructure than is rapid fracture and that the differences in SCG behavior can be qualitatively explained in terms of the differences in microstructure of the blends. ©1995 John Wiley & Sons, Inc.     

The stress driven instability in elastic crystals: Mathematical models and physical manifestations

Summary Equilibrium equations and stability conditions for the simple deformable elastic body are derived by means of considering a minimum of the static energy principle. The energy is supposed to be sum of the volume (elastic) and the surface terms. The ability to change relative positions of different material particles is taken into account, and appropriate natural definitions of the first and second variations of the energy are introduced and calculated explicitly. Considering the case of negligible magnitude of the surface tension, we establish that an equilibrium state of a nonhydrostatically stressed simple elastic body (of any physically reasonable elastic energy potential and of any symmetry) possessing any small smooth part of free surface is always unstable with respect to relative transfer of the material particles along the surface. Surface tension suppresses the mentioned instability with respect to sufficiently short disturbances of the boundary surface and thus can probably provide local smoothness of the equilibrium shape of the crystal. We derive explicit formulas for critical wavelength for the simplest models of the internal and surface energies and for the simplest equilibrium configurations. We also formulate the simplest problem of mathematical physics, revealing peculiarities and difficulties of the problem of equilibrium shape of elastic crystals, and discuss possible manifestations of the above-mentioned instability in the problems of crystal growth, materials science, fracture, physical chemistry, and low-temperature physics.     

对薄层柱壳爆炸膨胀断裂过程的研究

 本文提出了一个用于描述动态破坏发展过程的损伤度函数。从这个损伤度函数出发,把材料特征性方程取为强化粘塑性本构方程形式,导出了薄层柱壳爆炸膨胀运动在两种近似下（恒定膨胀速度近似合恒定应变速率近似）断裂判据的解析表达式。结果分析表明,在上述条件下,存在着一个动态断裂“塑性峰”,在这个峰值条件的应变率下,柱壳出现贯穿断裂时刻的应变最大。以软钢为算例,本断裂判据可以比较好地解释Иванов和陈大年等给出的实验结果。这时,动态断裂“塑性峰”对应的应变率为4×10⁴ s^-1,相应的应变约为60%~80%。     

聚丙烯/POE共混组成对材料断裂行为的影响

采用基本断裂功(EWF)方法对聚丙烯(PP)/聚烯烃弹性体(POE)共混物的注射双边缺口拉伸试样的断裂行为进行了研究,比较了不同POE含量对共混物各断裂参数的影响.结果表明,PP和用量为5phr POE的共混物都可完全满足EWF方法的要求,共混物的断裂韧性-比基本断裂功we,较PP有显著提高;POE用量为10phr以上的共混物则出现明显的成颈现象而限制了EWF方法的应用;PP和各种POE用量的共混物都得到了其屈服所需要的比基本断裂功we,y和比塑性功β′wp,y.     

老年髋部骨折患者血清中宏量及微量元素含量分析

为探讨微量元素与骨质疏松症及髋部骨折的关系,采用原子吸收分光光度计等方法分别测定了40例老年髋部骨折患者血清中微量元素铜(Cu)、锌(Zn)、硒(Se)、铁(Fe)、锰(Mn)及宏量元素钙(Ca)、磷(P)、镁(Mg)、钾(K)、钠(Na)的含量,并与30例青壮年髋部骨折患者对照。结果表明,老年髋部骨折患者血清中的Ca含量明显升高(P<0.01)、Cu、Mn有显著提高(P<0.05),其它元素有升高趋势,但无显著性差异,Zn的含量明显降低(P<0.01)。测定血清中宏量及微量元素含量可能对预测髋部骨折及骨质疏松症的疗效评价有一定临床价值。     

Hydraulic conductivity of rock fractures

The flow of a single-phase fluid through a rough-walled rock fracture is discussed within the context of fluid mechanics. The derivation of the cubic law is given as the solution to the Navier-Stokes equations for flow between smooth, parallel plates - the only fracture geometry that is amenable to exact treatment. The various geometric and kinematic conditions that are necessary in order for the Navier-Stokes equations to be replaced by the more tractable lubrication or Hele-Shaw equations are studied and quantified. In general, this requires a sufficiently low flow rate, and some restrictions on the spatial rate of change of the aperture profile. Various analytical and numerical results are reviewed pertaining to the problem of relating the effective hydraulic aperture to the statistics of the aperture distribution. These studies all lead to the conclusion that the effective hydraulic aperture is less than the mean aperture, by a factor that depends on the ratio of the mean value of the aperture to its standard deviation. The tortuosity effect caused by regions where the rock walls are in contact with each other is studied using the Hele-Shaw equations, leading to a simple correction factor that depends on the area fraction occupied by the contact regions. Finally, the predicted hydraulic apertures are compared to measured values for eight data sets from the literature for which aperture and conductivity data were available on the same fracture. It is found that reasonably accurate predictions of hydraulic conductivity can be made based solely on the first two moments of the aperture distribution function, and the proportion of contact area.     

磁场对含稀土铝锂合金断裂特征的影响

以含铈铝锂合金为研究对象，研究了磁场对含稀土铝锂合金时效过程的影响，从断裂特征及微观组织两方面分析了磁场作用规律。实验结果表明：未加磁场时，合金的断裂特征以理断裂为主；扁平晶粒厚度不匀，在磁场作用下，此合金的断裂特征与微观组织发生明显改观，随磁感应强度增强，合金主断裂面上准解理断裂特征减弱，同时二次裂纹增多，分层比较升高；扁平晶粒厚度变薄，尺寸趋于均匀。用少体物理理论，探讨了磁场对含稀土合金原子扩散过程的影响，为进一步研究稀土元素在磁场中的行为及其局域效应提供了一定的实验依据。     

CePO_4/Ce-ZrO_2可加工陶瓷性能与断裂机制研究

以Ce ZrO2为基体,通过复合不同加入量的第二相CePO4颗粒,研究了陶瓷材料力学性能的变化,并借助加载能谱仪(EDS)的扫描电子显微镜(SEM)对材料弯曲断口及压痕裂纹扩展方式进行分析。当CePO4加入量为25%时,虽然材料力学性能有一定下降,但已经能用WC刀具进行加工。材料的弯曲断口显示,CePO4在两相体系中的断裂呈层片状形式;加入CePO4后,由于两相之间弱结合界面的存在,压痕裂纹扩展形式发生明显变化,由连续扩展机制过渡为不连续扩展。由这两种机制形成的材料断裂过程是阶段性的,在实际中可以用作材料最终破坏前的预报。     

原子吸收光谱法测定拉伸断口铬镍钼钛钢样品中主成分

研究了毫克级铬镍钼风样品中主成分镍的火焰原子吸收光谱法（FAAS法）和铬、钼、钒、钛、铝的塞曼恒温平台石墨炉原子吸收光谱法（ZSTPF－AAS法）。采用了微波溶样技术作为防污染样品预处理技术，采用石墨管硅涂层改进技术提高了仪器的测试精度。其中铬、镍、钼、钒、钛、铝的相对标准偏差分别为2.7%,0.97%,8.6%,7.3%,1.7%,7.3%。其加标回收率分别为96.5%,97%,96.7%,93%,98%,91%。通过分析，发现在较低温度下铬镍钼钛钢断面上有轻微的钼偏析现象，可能是拉伸断裂的主要化学影响因素。     

EPR study of free radicals in a main chain thermotropic polymer

Free radicals were generated in a rigid rod-like copolymer via mechanical route and by gamma radiation. The (EPR) method was used for studying free radicals formed at 123 K. The spectra of free radicals observed and the influence of molecular motions on the transport of radical centers in the fracture surface layer are discussed.